Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Ikeda, Yoshimasa*; Takamura, Masato*; Hakoyama, Tomoyuki*; Otake, Yoshie*; Kumagai, Masayoshi*; Suzuki, Hiroshi
Tetsu To Hagane, 104(3), p.138 - 144, 2018/03
Times Cited Count：4 Percentile：22.16(Metallurgy & Metallurgical Engineering)Neutron engineering diffraction is a powerful technique which provides the information of the micro structure of steels in bulk-average, while X-ray diffraction or Electron backscatter diffraction can provide information only from the surface layer. However, such measurement using neutron diffraction is typically performed in a large facility such as a reactor and a synchrotron, while a compact neutron source has never been used for this purpose. Authors have recently developed a neutron diffractometer installed in Riken Accelerator driven compact Neutron Source (RANS) and succeeded in the measurement of texture evolution of a steel sheet. In this study, we made an attempt to measure the volume fraction of retained austenite by RANS. Background noise was carefully eliminated in order to detect as many diffraction peaks as possible with low flux neutrons. The volume fraction was estimated by Rietveld analysis. The accuracy of the measurement result was discussed by comparing with those obtained by a large neutron facility (J-PARC TAKUMI). The volume fraction obtained by RANS with reasonable measurement time, i.e. 30 to 300 min, showed only 1 to 2 % discrepancies with those obtained in J-PARC. These comparisons suggest that neutron diffraction by RANS is capable of quantitative analysis of the volume fraction of crystal phases, showing the possibility of practical use of an in-house compact neutron source in the industry.
Ikeda, Yoshimasa*; Taketani, Atsushi*; Takamura, Masato*; Sunaga, Hideyuki*; Kumagai, Masayoshi*; Oba, Yojiro*; Otake, Yoshie*; Suzuki, Hiroshi
Nuclear Instruments and Methods in Physics Research A, 833, p.61 - 67, 2016/10
Times Cited Count：38 Percentile：96.51(Instruments & Instrumentation)A compact accelerator-based neutron source has been lately discussed on engineering applications such as transmission imaging and small angle scattering as well as reflectometry. However, nobody considers using it for neutron diffraction experiment because of its low neutron flux. In this study, therefore, the neutron diffraction experiments are carried out using Riken Accelerator-driven Compact Neutron Source (RANS), to clarify the capability of the compact neutron source for neutron engineering diffraction. The diffraction pattern from a ferritic steel was successfully measured by suitable arrangement of the optical system to reduce the background noise, and it was confirmed that the recognizable diffraction pattern can be measured by the large sampling volume with 10 mm in cubic for an acceptable measurement time, i.e. 10 minutes. The minimum resolution of the 110 reflection for RANS is approximately 2.5 % at 8 
s of the proton pulse width, which is insufficient to perform the strain measurement by neutron diffraction. The moderation time width at the wavelength corresponding to the 110 reflection is estimated to be approximately 30 s, which is the most dominant factor to determine the resolution. Therefore, refinements of the moderator system to decrease the moderation time are important to improve the resolution of the diffraction experiment using the compact neutron source. In contrast, the texture evolution due to plastic deformation was successfully observed by measuring a change in the diffraction peak intensity by RANS. Furthermore, the volume fraction of the austenite phase was also successfully evaluated by fitting the diffraction pattern using a Rietveld code. Consequently, RANS was proved to be capable for neutron engineering diffraction aiming for the easy access measurement of the texture and the amount of retained austenite.
