Modeling the extraction of bound rubber from silica-filled styrene-butadiene rubber with toluene

Tamura, Yukiko*; Arakawa, Masato*; Takenaka, Mikihito*; Nakanishi, Yohei*; Fujinami, So*; Shibata, Motoki*; Yamamoto, Katsuhiro*; Miyata, Noboru*; Yamada, Masako*; Seto, Hideki*; et al.

Polymer, 333, p.128662_1 - 128662_8, 2025/08

https://doi.org/10.1016/j.polymer.2025.128662

Adsorption isotherm and kinetics of diffusion of water accumulated between polypropylene thin film and Si substrate; Neutron reflectivity investigation

Miyazaki, Tsukasa*; Miyata, Noboru*; Arima-Osonoi, Hiroshi*; Shimokita, Keisuke*; Yamamoto, Katsuhiro*; Takenaka, Mikihito*; Nakanishi, Yohei*; Shibata, Motoki*; Aoki, Hiroyuki; Yamada, Norifumi*; et al.

Colloids and Surfaces A; Physicochemical and Engineering Aspects, 701, p.134928_1 - 134928_8, 2024/11

https://doi.org/10.1016/j.colsurfa.2024.134928

Introduction to dismantling and decommissioning chemistry

Sato, Nobuaki*; Kameo, Yutaka; Sato, Soichi; Kumagai, Yuta; Sato, Tomonori; Yamamoto, Masahiro*; Watanabe, Yutaka*; Nagai, Takayuki; Niibori, Yuichi*; Watanabe, Masayuki; et al.

Introduction to Dismantling and Decommissioning Chemistry, 251 Pages, 2024/09

This book focuses on the dismantling and decommissioning of nuclear facilities and reactors that have suffered severe accidents. In Part 1, we introduce basic aspects ranging from fuel chemistry, analytical chemistry, radiation chemistry, corrosion, and decontamination chemistry to waste treatment and disposal. Then, Part 2 covers the chemistry involved in the decommissioning of various nuclear facilities, and discusses what chemical approaches are necessary and possible for the decommissioning of TEPCO's Fukushima Daiichi Nuclear Power Plants, how decommissioning should be carried out, and what kind of research and development and also human resource development are required for this.

Stability enhancement by hydrophobic anchoring and a cross-linked structure of a phospholipid copolymer film for medical devices

Uchida, Kazuto*; Masuda, Tsukuru*; Hara, Shintaro*; Matsuo, Yoichi*; Liu, Y.*; Aoki, Hiroyuki; Asano, Yoshihiko*; Miyata, Kazuki*; Fukuma, Takeshi*; Ono, Toshiya*; et al.

ACS Applied Materials & Interfaces, 16(30), p.39104 - 39116, 2024/07

https://doi.org/10.1021/acsami.4c07752

A Focusing supermirror for time-of-flight grazing-incidence small-angle neutron scattering measurement

Yamazaki, Dai; Maruyama, Ryuji; Aoki, Hiroyuki; Hanashima, Takayasu*; Akutsu-Suyama, Kazuhiro*; Miyata, Noboru*; Soyama, Kazuhiko

Quantum Beam Science (Internet), 9(2), p.20_1 - 20_12, 2024/06

https://doi.org/10.3390/qubs9020020

Properties of duplex stainless steels

Aoki, So; Sakai, Junichi*

Zairyo To Kankyo, 73(3), p.49 - 56, 2024/03

https://doi.org/10.3323/jcorr.73.49

This paper briefly reviews the history of the development of duplex stainless steels and summarises the grades that are currently standardised in JIS and used industrially. The chemical composition, phase equilibrium and phase transformation of duplex stainless steels are described, showing the basic data. The physical and mechanical properties of the duplex stainless steels are touched upon, and in particular the resistance to uniform corrosion and localised corrosion such as pitting corrosion, crevice corrosion and stress corrosion cracking are outlined, citing previously published data. Finally, the main environments in which duplex stainless steels are used and the results of their use are mentioned.

Transient analyses of hydraulic head in the fault slip experiments in fracture zones of Shionohira and Kuruma Faults

Wakahama, Hiroshi*; Nojo, Haruka*; Aoki, Kazuhiro; Imai, Hirotaro; Guglielmi, Y.*; Cook, P.*; Soom, F.*

Oyo Chishitsu, 64(5), p.236 - 254, 2023/12

https://doi.org/10.5110/jjseg.64.236

Upon the Hamadori earthquake (Mw 6.7) of 11 April 2011, coseismic surface deformation of 14 km running NNW to SSE in southeast Fukushima Prefecture occurred and was newly named the Shionohira Fault. However, no surface deformation was observed along the Kuruma Fault which is a southern extension of the Shionohira Fault. Fault injection tests using SIMFIP method at the Shionohira site on the former active segment and the Minakamikita site on the latter inactive segment were conducted to evaluate the activity of the two faults. Based on hydraulic responses to water injection into the fault rupture zone in the monitoring boreholes at the two sites, hydraulic properties of the area across the fault zone were estimated using the GRF model (Barker, 1988). The results obtained on hydraulic conductivity, specific storage and flow dimension were consistent with those in the domestic and international literature. The hydraulic conductivity and specific storage were larger in Shionohira than in Minakamikita. The flow dimension of Shionohira was three-dimensional, while that of Minakamikita was found to be a two-dimensional fractional flow. In addition, it is understood that the volumetric expansion occurs in the former site in the triaxial direction and the latter in the uniaxial with the comparison between the uniaxial expansion coefficient calculated from the results of SIMFIP displacement measurements and the specific storage in the hydraulic analysis. The difference in the hydraulic parameters between the two sites corresponded to the difference in the spatial development of fractures considered to be the "water passway," indicating the possibility of a correlation between the parameters and the different possible causes for fault activity at the two sites.

Translational study for stereotactic body radiotherapy against non-small cell lung cancer, including oligometastases, considering cancer stem-like cells enable predicting clinical outcome from data

Saga, Ryo*; Matsuya, Yusuke; Sato, Hikari*; Hasegawa, Kazuki*; Obara, Hideki*; Komai, Fumio*; Yoshino, Hironori*; Aoki, Masahiko*; Hosokawa, Yoichiro*

Radiotherapy and Oncology, p.109444_1 - 109444_9, 2023/00

https://doi.org/10.1016/j.radonc.2022.109444

When treating non-small cell lung cancer (NSCLC), stereotactic body radiotherapy (SBRT) with high-dose irradiation is often utilized. The fractionation schemes and curative effects can be evaluated by mathematical models for predicting cell survival curve. Such model parameters can be determined from in vitro experiment, but they are empirically determined based on experiences in clinics. As such, there is a large gap between in vitro and clinical study. As such background, translational study between in vitro cell survival and clinical curative effects is necessary. In this study, explicitly considering existence of cancer stem-like cells (CSCs), we developed an all-in-one model for predicting both in vitro cell survival and clinical curative effects (integrated microdosimetric-kinetic (IMK) model) and performed retrospective evaluation of clinical outcomes following SBRT for NSCLC in Hirosaki University Hospital. As a result, the IMK model successfully reproduced both in vitro cell survival and the tumor control probability with various fractionation schemes (i.e., 6-10 Gy per fraction). The developed model would contribute on precisely understanding the impact of CSCs on curative effects after SBRT for NSCLC with high precision.

Fuel Unloading Operations -2019- in the decommissioning of prototype fast breeder reactor "Monju"

Yabe, Takanori; Murakami, Makio; Shiota, Yuki; Isobe, Yuta; Shiohama, Yasutaka; Hamano, Tomoharu; Takagi, Tsuyohiko; Nagaoki, Yoshihiro

JAEA-Technology 2022-002, 66 Pages, 2022/07

JAEA-Technology-2022-002.pdf:10.45MB

In the first stage of "Monju" decommissioning project, "Fuel Unloading Operations" have been carrying out. The operations consists of two processes. The first process is "Fuel Treatment and Storage" is that the fuel assemblies unloaded from the Ex-Vessel fuel Storage Tank are canned after sodium cleaning, and then transferred to the storage pool. The second process is "Fuel Unloading" that the fuel assemblies in the reactor core are replaced with dummy fuel assemblies and stored in the Ex-Vessel fuel Storage Tank. "Fuel Treatment and Storage" and "Fuel Unloading" are performed alternately until 370 fuel assemblies in the core and 160 fuel assemblies in the Ex-Vessel fuel Storage Tank are all transferred to the storage pool. In fiscal 2018, as "Fuel Treatment and Storage", 86 fuel assemblies were transferred to the storage pool. As "Fuel Unloading", 76 dummy fuel assemblies were stored in the Ex-Vessel fuel Storage Tank. In fiscal 2019, as "Fuel Unloading", 60 fuel assemblies and 40 blanket fuel assemblies were unloaded from the core. These assemblies were stored in the Ex-Vessel fuel Storage Tank, and dummy fuel assemblies were loaded into the core instead. During these operations, a total of 38 cases of alarming or equipment malfunctions classified into 24 types occurred. However, no significant events that menaces to safety have occurred. The operations were continued safely by removing the direct factors for the malfunctions in the equipment operation and performance.

Unconventional superconductivity in UTe

Aoki, Dai*; Brison, J.-P.*; Flouquet, J.*; Ishida, Kenji*; Knebel, G.*; Tokunaga, Yo; Yanase, Yoichi*

Journal of Physics; Condensed Matter, 34(24), p.243002_1 - 243002_41, 2022/06

https://doi.org/10.1088/1361-648X/ac5863