Utilization of gamma ray irradiation at the WASTEF Facility

Sano, Naruto; Yamashita, Naoki; Watanabe, Masaya; Tsukada, Manabu*; Hoshino, Kazutoyo*; Hirai, Koki; Ikegami, Yuta*; Tashiro, Shinsuke; Yoshida, Ryoichiro; Hatakeyama, Yuichi; et al.

JAEA-Technology 2023-029, 36 Pages, 2024/03

JAEA-Technology-2023-029.pdf:2.47MB

At the Waste Safety Testing Facility (WASTEF), the gamma ray irradiation device "Gamma Cell 220" was relocated from the 4th research building of the Nuclear Science Research Institute in FY2019, and the use of gamma ray irradiation has begun. Initially, Fuel Cycle Safety Research Group, Fuel Cycle Safety Research Division, Nuclear Safety Research Center, Sector of Nuclear Safety Research and Emergency Preparedness, the owner of this device, conducted the tests as the main user, but since 2022, other users, including those outside the organization, have started using it. The gamma ray irradiation device "Gamma Cell 220" is manufactured by Nordion International Inc. in Canada. Since it was purchased in 1989, the built-in 60Co radiation source has been updated once, and safety research related to nuclear fuel cycles, etc. It is still used for this purpose to this day. This report summarizes the equipment overview of the gamma ray irradiation device "Gamma Cell 220", its permits and licenses at WASTEF, usage status, maintenance and inspection, and future prospects.

Document collection of the 39th Technical Special Committee on Fugen Decommissioning

Sato, Yuji; Miyamoto, Yuta; Awatani, Yuto; Yamamoto, Kosuke; Hatakeyama, Takumi

JAEA-Review 2023-002, 59 Pages, 2023/08

JAEA-Review-2023-002.pdf:8.75MB

"Fugen Decommissioning Engineering Center", in planning and carrying out our decommissioning technical development, organizes "Technical special committee on Fugen decommissioning" which consists of the members well-informed, aiming to make good use of Fugen as a place for technological development which is opened domestic and international, as the central place in research and development base of Fukui prefecture, and to utilize the outcome in our decommissioning to the technical development effectively. This report consists of presentation paper are "Achievements and Considerations for Sampling and Analysis of Reactor Core Components", "Treatment of liquid scintillator waste liquid" and "Results and issues of rationalization of decontamination related to the clearance and considerations related to surface contamination monitoring" which is presented in the 39th Technical Special Committee on Fugen Decommissioning.

Historical changes and Correspondence to Research and Test Reactors New Regulatory Standards for Monitoring Post in Oarai Research and Development Institute, JAEA

Hamaguchi, Takumi; Yamada, Junya; Komatsuzaki, Naoya*; Hatakeyama, Takumi; Seya, Natsumi; Muto, Yasunobu; Miyauchi, Hideaki; Hashimoto, Makoto

JAEA-Technology 2022-038, 65 Pages, 2023/03

JAEA-Technology-2022-038.pdf:4.3MB

New regulatory requirements were developed taking into account the lessons-learnt from the accident at Fukushima Daiichi Nuclear Power Station on March 2011. The new regulatory standards required that monitoring posts should be diversified in transmission systems and equipped with backup power supply equipment for design basis accidents. In this report, we look back on the history of monitoring posts in Oarai Research and Development Institute, explained the application for the permission of reactor installment license, application for approval of the design and construction method, pre-use operator's inspection and improvement design of monitoring posts. This report also includes about inspection based on act on special measures concerning nuclear emergency preparedness and the installation of KURAMA-II, which was carried out in conjunction with the improvement of monitoring post for new regulatory standards. As an appendix, application document for approval of the design and construction method are included.

Results of 1-MW operation in J-PARC 3 GeV rapid cycling synchrotron, 2

Yamamoto, Kazami; Yamamoto, Masanobu; Yamazaki, Yoshio; Nomura, Masahiro; Suganuma, Kazuaki; Fujirai, Kosuke; Kamiya, Junichiro; Nakanoya, Takamitsu; Hatakeyama, Shuichiro; Yoshimoto, Masahiro; et al.

Proceedings of 19th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.277 - 281, 2023/01

https://www.pasj.jp/web_publish/pasj2022/proceedings/PDF/TUP0/TUP004.pdf

The J-PARC 3GeV Rapid Cycling Synchrotron (RCS) is aiming to provide the proton beam of very high power for neutron experiments and the main ring synchrotron. We have continued the beam commissioning and the output power from RCS have been increasing. In recent years, we have been trying continuous supply of 1-MW high-intensity beam, which is the design value, to a neutron target. We tried to operate continuously for over 40 hours in June 2020. However, some trouble occurred and the operation was frequently suspended. In June 2021, we tried again 1-MW operation but it was suspended due to deterioration of the cooling water performance. Last summer shutdown period, we recovered performance of the cooling water system and retried in this June. In the final case, the outside temperature became extremely high. We could not keep 1-MW power, whereas 600 kW beam was delivered in stable.

Reducing the effect of noise generated from stepper motor for H0 collimator in J-PARC RCS

Fujiyama, Hiroki*; Takahashi, Hiroki; Okabe, Kota; Ito, Yuichi*; Hatakeyama, Shuichiro; Suzuki, Takahiro*; Otsu, Satoru*; Yamakawa, Ryuto*

Proceedings of 19th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.529 - 531, 2023/01

http://www.pasj.jp/web_publish/pasj2022/proceedings/PDF/WEP0/WEP010.pdf

Stepper motors are used for mechanical drive in collimators and wire scanner monitors of J-PARC accelerators. Many of these drive unit hardware have been used since the beginning of J-PARC construction, and it is necessary to take measures against aging deterioration. Therefore, we started updating the motor and control system from around 2017. However, when the stepper motor was updated to the current product in the RCS H0 collimator, a malfunction occurred. This is because the drive unit control system cannot correctly recognize the state of the LS (limit switch) due to the noise generated by the motor driver, which hinders the operation. When the noise generated from the old and new stepper motors was measured in a simple test environment for confirmation, it was found that the current product was clearly larger. As a countermeasure, when the wiring of the stepper motor, which was bundled in a single multi-core cable, was separated into separate cables for the power system and LS signal system, the noise level was reduced to about 1/10 and normal operation was restored. I was able to. In this case, we report on noise countermeasures for the RCS H0 collimator drive unit.

Structural investigation of borosilicate glasses by using XAFS measurement in soft X-ray region, 2 (Joint research)

Nagai, Takayuki; Okamoto, Yoshihiro; Yamagishi, Hirona*; Kojima, Kazuo*; Inose, Takehiko*; Sato, Seiichi*; Hatakeyama, Kiyoshi*

JAEA-Research 2022-008, 37 Pages, 2022/10

JAEA-Research-2022-008.pdf:5.27MB

The local structure of glass-forming elements and waste elements in borosilicate glasses varies with its chemical composition. In this study, borosilicate glass frit and simulated waste glass samples were prepared and the chemical state regarding boron (B), silicon (Si) and waste elements of iron (Fe), cesium (Cs) were estimated by using XAFS measurement in soft X-ray region. Following results were obtained by XAFS measurements of simulated waste glass surfaces after immersion test to investigate the long chemical stability. (1) As the leaching time of glass samples in immersion test passed, the Cs M, M-edge XANES spectra disappeared and the Fe L, L-edge spectra changed. (2) A new compound was formed on the sample surface after the immersion test, and these changes in the surface state were confirmed by Raman spectroscopy. However, it became difficult to obtain a clear B K-edge XANES spectrum by forming a compound on glass surfaces. The Si K-edge XANES spectra of borosilicate glass frits with different NaO content were measured, and following was confirmed. (1) As the NaO concentration increases in borosilicate glass frit, the K-edge peak of Si shifts to the low energy side. (2) The intensity of the Si K-edge peak is maximum when the NaO content in glass frits was about 7wt%.

Magnetism of AlFeGeO with andalusite structure

Kakimoto, Kazuo*; Takada, Saki*; Ota, Hiroto*; Hayaguchi, Yuya*; Hagihara, Masato; Torii, Shuki*; Kamiyama, Takashi*; Mitamura, Hiroyuki*; Tokunaga, Masashi*; Hatakeyama, Atsushi*; et al.

Journal of the Physical Society of Japan, 91(5), p.054704_1 - 054704_7, 2022/05

https://doi.org/10.7566/JPSJ.91.054704

Behavior estimation focusing on the existing form of hydrogen in sodium in sodium-cooled fast reactors

Hatakeyama, Nozomi*; Miura, Ryuji*; Miyamoto, Naoto*; Miyamoto, Akira*; Ara, Kuniaki; Shimoyama, Kazuhito; Kato, Atsushi; Yamamoto, Tomohiko

Journal of Computer Chemistry, Japan, 21(2), p.61 - 62, 2022/00

https://doi.org/10.2477/jccj.2022-0026

no abstracts in English

XAFS analysis of ruthenium in simulated iron phosphate radioactive waste glass

Okamoto, Yoshihiro; Kobayashi, Hidekazu; Shiwaku, Hideaki; Sasage, Kenichi; Hatakeyama, Kiyoshi*; Nagai, Takayuki

Journal of Non-Crystalline Solids, 551, p.120393_1 - 120393_8, 2021/01

https://doi.org/10.1016/j.jnoncrysol.2020.120393

The chemical state of ruthenium in simulated iron phosphate radioactive waste glass was investigated by conventional X-ray absorption fine structure (XAFS) and imaging XAFS analyses. The EXAFS analysis suggested that ruthenium was contained as glass phase when content of the waste components was less than 10wt.% in 30 mol%FeO-PO base glass. In other samples, crystalline RuO was predominant. According to the imaging XAFS analysis, RuO particles in all samples had length smaller than 50m. Aggregations of RuO, which are found in nuclear waste borosilicate glass, were not seen in any of the iron phosphate glass samples.

Results of 1-MW operation in J-PARC 3 GeV rapid cycling synchrotron

Yamamoto, Kazami; Yamamoto, Masanobu; Yamazaki, Yoshio; Nomura, Masahiro; Suganuma, Kazuaki; Fujirai, Kosuke; Kamiya, Junichiro; Hatakeyama, Shuichiro; Hotchi, Hideaki; Yoshimoto, Masahiro; et al.

Proceedings of 17th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.209 - 213, 2020/09

https://www.pasj.jp/web_publish/pasj2020/proceedings/PDF/WEPP/WEPP03.pdf

The J-PARC 3GeV Rapid Cycling Synchrotron (RCS) is aiming to provide the proton beam of very high power for neutron experiments and the main ring synchrotron. We have continued the beam commissioning and the output power from RCS have been increasing. In recent years, just before the summer shutdown period, we have been trying continuous supply of 1-MW high-intensity beam, which is the design value, to a neutron target. First trial was 1-hour continuous operation in July 2018, and second trial was 10-hours continuous in July 2019. In both cases, we achieved almost stable operation. Furthermore, in June 2020, we tried to operate continuously for over 40 hours. But in this case, some trouble occurred and the operation was frequently suspended. Through these continuous operation trials, we have identified issues for stable operation of 1 MW. In this presentation, we will report the results of 1-MW continuous operation and issues obtained from these results.