Current status of the next generation fast reactor core & fuel design and related R&Ds in Japan

Maeda, Seiichiro; Oki, Shigeo; Otsuka, Satoshi; Morimoto, Kyoichi; Ozawa, Takayuki; Kamide, Hideki

Proceedings of International Conference on Fast Reactors and Related Fuel Cycles; Next Generation Nuclear Systems for Sustainable Development (FR-17) (USB Flash Drive), 10 Pages, 2017/06

The next generation fast reactor is being investigated in Japan, aiming at several targets such as "safety", "reduction of environmental burden" and "economic competitiveness". As for the safety aspect, FAIDUS concept is adopted to avoid re-criticality in core destructive accidents. The uranium-plutonium mixed oxide fuel, in which minor actinide elements are included, will be applied to reduce the amount and potential radio-toxicity of radioactive wastes. The high burn-up fuel is pursued to reduce fuel cycle cost. The candidate concept of the core and fuel design, which could satisfy various design criteria by design devisals, has been established. In addition, JAEA is investigating material properties and irradiation behavior of MA-MOX fuel. JAEA is developing the fuel design code especially for the fuel pin with annular pellets of MA-bearing MOX. Furthermore, JAEA is developing oxide dispersion strengthened (ODS) ferritic steel cladding for the high burnup fuel.

Tunnel support design for anisotropic stress state and comparison between in-situ convergence results and calculated results

Motoshima, Takayuki*; Yabuki, Yoshio*; Minamide, Masashi*; Nago, Makito*; Aoyagi, Kazuhei

Tonneru Kogaku Hokokushu (CD-ROM), 24, p.I_10_1 - I_10_5, 2014/12

http://ci.nii.ac.jp/naid/40020361441

Economic tunnel support design for Horonobe underground research laboratory was obtained according to the relationship in the direction of the initial stress and the direction of excavation. The authors compared between the in situ convergence results and calculated results in order to investigate the validity of initial stress measurements. As a result, a positive correlation was observed between the in situ convergence results and calculated results, and the difference between the two was able to be explained by the difference between the assumed deformation coefficient and the measured coefficient. From these results, the measurement results of the initial stress performed in the surface based investigation has been confirmed almost reasonable.

Conceptual design of multipurpose compact research reactor; Annual report FY2011

Watahiki, Shunsuke; Hanakawa, Hiroki; Imaizumi, Tomomi; Nagata, Hiroshi; Ide, Hiroshi; Komukai, Bunsaku; Kimura, Nobuaki; Miyauchi, Masaru; Ito, Masayasu; Nishikata, Kaori; et al.

JAEA-Technology 2013-021, 43 Pages, 2013/07

JAEA-Technology-2013-021.pdf:5.12MB

The number of research reactors in the world is decreasing because of their aging. On the other hand, the necessity of research reactor, which is used for human resources development, progress of the science and technology, industrial use and safety research is increasing for the countries which are planning to introduce the nuclear power plants. From above background, the Neutron Irradiation and Testing Reactor Center began to discuss a basic concept of Multipurpose Compact Research Reactor (MCRR) for education and training, etc., on 2010 to 2012. This activity is also expected to contribute to design tool improvement and human resource development in the center. In 2011, design study of reactor core, irradiation facilities with high versatility and practicality, and hot laboratory equipment for the production of Mo-99 was carried out. As the result of design study of reactor core, subcriticality and operation time of the reactor in consideration of an irradiation capsule, and about the transient response of the reactor to the reactivity disturbance during automatic control operation, it was possible to do automatic operation of MCRR, was confirmed. As the result of design study of irradiation facilities, it was confirmed that the implementation of an efficient mass production radioisotope Mo-99 can be expected. As the result of design study with hot laboratory facilities, Mo-99 production, RI export devised considered cell and facilities for exporting the specimens quickly was designed.

Gas control measures taken during deep shaft excavation

Nago, Makito*; Hagihara, Takeshi*; Minamide, Masashi*; Motoshima, Takayuki*; Jin, Kazumi; Kudo, Hajime; Sugita, Yutaka; Miura, Yoichi*

Dai-49-Kai Zenkoku Kensetsugyo Rodo Saigai Boshi Taikai Kenkyu Rombunshu (CD-ROM), p.77 - 80, 2012/10

This paper presents measures against gas emission during deep shaft excavation in the Horonobe Underground Research Laboratory Project (Horonobe URL Project). The gas control measures taken in the Horonobe URL Project include the following: (1) determination of the amount of methane contained in surrounding strata and groundwater, and gas concentration based on preliminary investigations, (2) determination of the specifications of fans, dust collectors, and ducts through ventilation network analysis (simulation), (3) reduction of methane gas emission through the use of waterproofing grout, (4) prohibition on the use of internal-combustion engine and the adoption of explosion-proof equipment, (5) development of methane gas control system, and (6) monitoring of methane gas emission. (3) to (6) described above are performed daily in the safety management activities and described in detail in this paper. The ventilation and eastern access shafts have currently reached a depth of 290 m and 250 m, respectively. The emission of methane gas has been observed to rise 0.3 % to 1.3 % in the fault zone, and it is controlled appropriately according to the gas control measures described above. As the measure to reduce the methane gas concentration, monitoring is confirmed to be effective.

Conceptual design of multipurpose compact research reactor; Annual report FY2010 (Joint research)

Imaizumi, Tomomi; Miyauchi, Masaru; Ito, Masayasu; Watahiki, Shunsuke; Nagata, Hiroshi; Hanakawa, Hiroki; Naka, Michihiro; Kawamata, Kazuo; Yamaura, Takayuki; Ide, Hiroshi; et al.

JAEA-Technology 2011-031, 123 Pages, 2012/01

JAEA-Technology-2011-031.pdf:16.08MB

The number of research reactors in the world is decreasing because of their aging. However, the planning to introduce the nuclear power plants is increasing in Asian countries. In these Asian countries, the key issue is the human resource development for operation and management of nuclear power plants after constructed them, and also the necessity of research reactor, which is used for lifetime extension of LWRs, progress of the science and technology, expansion of industry use, human resources training and so on, is increasing. From above backgrounds, the Neutron Irradiation and Testing Reactor Center began to discuss basic concept of a multipurpose low-power research reactor for education and training, etc. This design study is expected to contribute not only to design tool improvement and human resources development in the Neutron Irradiation and Testing Reactor Center but also to maintain and upgrade the technology on research reactors in nuclear power-related companies. This report treats the activities of the working group from July 2010 to June 2011 on the multipurpose low-power research reactor in the Neutron Irradiation and Testing Reactor Center and nuclear power-related companies.

The H-Invitational Database (H-InvDB); A Comprehensive annotation resource for human genes and transcripts

Yamasaki, Chisato*; Murakami, Katsuhiko*; Fujii, Yasuyuki*; Sato, Yoshiharu*; Harada, Erimi*; Takeda, Junichi*; Taniya, Takayuki*; Sakate, Ryuichi*; Kikugawa, Shingo*; Shimada, Makoto*; et al.

Nucleic Acids Research, 36(Database), p.D793 - D799, 2008/01

https://doi.org/10.1093/nar/gkm999

Here we report the new features and improvements in our latest release of the H-Invitational Database, a comprehensive annotation resource for human genes and transcripts. H-InvDB, originally developed as an integrated database of the human transcriptome based on extensive annotation of large sets of fulllength cDNA (FLcDNA) clones, now provides annotation for 120 558 human mRNAs extracted from the International Nucleotide Sequence Databases (INSD), in addition to 54 978 human FLcDNAs, in the latest release H-InvDB. We mapped those human transcripts onto the human genome sequences (NCBI build 36.1) and determined 34 699 human gene clusters, which could define 34 057 protein-coding and 642 non-protein-coding loci; 858 transcribed loci overlapped with predicted pseudogenes.

High-resolution resonance photoemission study of Ce (=Pt, Pd; =P, As, Sb)

Iwasaki, T.*; Sekiyama, Akira*; Yamasaki, Atsushi*; Okazaki, Makoto*; Kadono, Koji*; Utsunomiya, Hiroshi*; Imada, Shin*; Saito, Yuji; Muro, Takayuki*; Matsushita, Tomohiro*; et al.

Physical Review B, 65(19), p.195109_1 - 195109_9, 2002/05

https://doi.org/10.1103/PhysRevB.65.195109

no abstracts in English

Development and implementation of remote experimental system in JT-60U

Ozeki, Takahisa; Suzuki, Yoshio; Totsuka, Toshiyuki; Iba, Katsuyuki*; Nakajima, Kohei; Sakata, Shinya; Isayama, Akihiko; Ide, Shunsuke; Takenaga, Hidenobu; Oshima, Takayuki; et al.

no journal, , 

no abstracts in English

Responses of electron and ion channels to electron cyclotron heating in JT-60U H-mode and ITB plasmas

Yoshida, Maiko; Ide, Shunsuke; Takenaga, Hidenobu; Honda, Mitsuru; Urano, Hajime; Kobayashi, Takayuki; Nakata, Motoki; Miyato, Naoaki; Kamada, Yutaka

no journal, , 

Temporal and spatial responses of electron channels (the electron density, ne and the electron temperature) and ion channels (the ion temperature, Ti and the toroidal rotation velocity) to central electron cyclotron heating (ECH) have been investigated in positive shear H-mode plasmas with relatively peaked Ti profile and internal transport barrier (ITB) plasmas on JT-60U.

Conformity assessment of JMTR facilities for the new regulation

Watahiki, Shunsuke; Ide, Hiroshi; Hanakawa, Hiroki; Yamaura, Takayuki; Kaminaga, Masanori

no journal, , 

no abstracts in English