Benchmark analyses of criticality calculation on SCALE 6.2.3 code system

Okamoto, Naritoshi; Komeno, Akira; Seya, Atsumasa; Inaba, Hideki*; Terakado, Shinichi*; Higuchi, Masashi*

JAEA-Data/Code 2025-022, 497 Pages, 2026/03

JAEA-Data-Code-2025-022.pdf:18.06MB

The Plutonium Fuel Third Development Laboratory of the Nuclear Fuel Cycle Engineering Laboratories has applied for a change of use permit (hereinafter referred to as "license") for plutonium fuel facilities. For the criticality safety design of gloveboxes and equipment/instruments handling mixed oxide (MOX), various criticality calculation codes are used. The most recent employs the 3D Monte Carlo calculation code KENO-V.a embedded in the SCALE 4.4 code system, along with the 27-group ENDF/B-IV neutron cross-section library. SCALE 4.4 was released by the Oak Ridge National Laboratory (ORNL) in the US in 1998, and has now been in use for 27 years. ORNL has continuously improved its functionality, with SCALE 6.3.2 released in 2024. When designing and constructing new MOX fuel facilities, it is desirable to obtain a license using criticality calculation codes based on the latest knowledge. However, it is necessary to verify that these codes have sufficient reliability. Therefore, in 2018, benchmark calculations were performed using the 252-group ENDF/B-VII.1 neutron cross-section library (v7-252n) for two versions of the criticality calculation sequences KENO-V.a and KENO-VI from SCALE 6.2.3, based on past criticality experimental setups. The estimated critical-limiting multiplication factor was calculated. The results indicate that these codes can be used with sufficient confidence for criticality safety design of MOX fuel facilities.

Identified charged hadron production in collisions at = 200 and 62.4 GeV

Adare, A.*; Afanasiev, S.*; Aidala, C.*; Ajitanand, N. N.*; Akiba, Yasuyuki*; Al-Bataineh, H.*; Alexander, J.*; Aoki, Kazuya*; Aphecetche, L.*; Armendariz, R.*; et al.

Physical Review C, 83(6), p.064903_1 - 064903_29, 2011/06

https://doi.org/10.1103/PhysRevC.83.064903

Transverse momentum distributions and yields for , and in collisions at = 200 and 62.4 GeV at midrapidity are measured by the PHENIX experiment at the RHIC. We present the inverse slope parameter, mean transverse momentum, and yield per unit rapidity at each energy, and compare them to other measurements at different collisions. We also present the scaling properties such as and scaling and discuss the mechanism of the particle production in collisions. The measured spectra are compared to next-to-leading order perturbative QCD calculations.

Measurement of neutral mesons in + collisions at = 200 GeV and scaling properties of hadron production

Adare, A.*; Afanasiev, S.*; Aidala, C.*; Ajitanand, N. N.*; Akiba, Y.*; Al-Bataineh, H.*; Alexander, J.*; Aoki, K.*; Aphecetche, L.*; Armendariz, R.*; et al.

Physical Review D, 83(5), p.052004_1 - 052004_26, 2011/03

https://doi.org/10.1103/PhysRevD.83.052004

The PHENIX experiment at RHIC has measured the invariant differential cross section for production of , , and mesons in collisions at = 200 GeV. The spectral shapes of all hadron transverse momentum distributions are well described by a Tsallis distribution functional form with only two parameters, and , determining the high and characterizing the low regions for the spectra, respectively. The integrated invariant cross sections calculated from the fitted distributions are found to be consistent with existing measurements and with statistical model predictions.

Annual report on experimental operations and maintenances of mock-up model test facility with a full-scale reaction tube for HTTR hydrogen production system in 2004 fiscal year (Contract research)

Hayashi, Koji; Ohashi, Hirofumi; Morisaki, Norihiro; Kato, Michio; Aita, Hideki; Takeda, Tetsuaki; Nishihara, Tetsuo; Inaba, Yoshitomo; Takada, Shoji; Inagaki, Yoshiyuki

JAEA-Technology 2006-013, 73 Pages, 2006/03

JAEA-Technology-2006-013.pdf:6.27MB

This is annual report on the experimental test operations and maintenances of the mock-up test facility with a full-scale reaction tube for the HTTR hydrogen production system in 2004 fiscal year. The improvement work of catalyst dust filter in combustion system was performed in May 2004, and the performance was confirmed. The sixth experimental test operation was performed from June to July 2004. Periodic inspections on boiler equipment and high-pressure gas production facilities were performed from end of July to September 2004. The seventh experimental test operation was performed from October to December 2004 for chemical reaction shutdown test. From the results, a behavior of the helium-gas cooling system, consists of steam generator and radiator, during chemical reaction shutdown was confirmed. This report is summarized with the outline and the results of the test, maintenance works and inspections, and operation records in mentioned above.

Annual report on experimental operations and maintenances of mock-up model test facility with a full-scale reaction tube for HTTR hydrogen production system in 2002 fiscal year (Contract research)

Hayashi, Koji; Ohashi, Hirofumi; Inaba, Yoshitomo; Kato, Michio; Aita, Hideki; Morisaki, Norihiro; Takeda, Tetsuaki; Nishihara, Tetsuo; Takada, Shoji; Inagaki, Yoshiyuki

JAEA-Technology 2006-011, 132 Pages, 2006/03

JAEA-Technology-2006-011.pdf:9.47MB

This report describes 2002 fiscal-year experimental test operations of the mock-up test facility with a full-scale reaction tube for the HTTR hydrogen production system. The improvement works were performed in May 2002. The second experimental test operation was performed from June 2002 and the performances of the improved parts were confirmed. Periodic inspections on boiler equipment and high-pressure gas production facilities were performed from end of July 2002. The third experimental test operation was performed, from October 2002, for (a)start-up and shutdown test, (b)process change test, (c)chemical reaction shutdown test and (d)characteristics test on steam reformer. It was confirmed that the changes of helium gas temperature, caused at steam reformer, could be mitigated into the target range by the steam generator. Maintenance works of high-pressure gas production facilities were also performed in February 2003. This report is summarized with the outline and the results of the test, maintenance works and inspections, and operation records in mentioned above.

Heat transfer characteristics evaluation of heat exchangers of mock-up test facility with full-scale reaction tube for HTTR hydrogen production system (Contract research)

Shimizu, Akira; Ohashi, Hirofumi; Kato, Michio; Hayashi, Koji; Aita, Hideki; Nishihara, Tetsuo; Inaba, Yoshitomo; Takada, Shoji; Morisaki, Norihiro; Sakaki, Akihiro*; et al.

JAERI-Tech 2005-031, 174 Pages, 2005/06

JAERI-Tech-2005-031.pdf:20.71MB

Connection of hydrogen production system by steam reforming of methane to the High Temperature Engineering Test Reactor (HTTR) of the Japan Atomic Energy Research Institute (JAERI) has been surveyed until now. Mock-up test facility of this steam reforming system with full-scale reaction tube was constructed in FY 2001, and a lot of operational test data on heat exchanges were obtained in these tests.In this report specifications, structures and heat transfer formulae of steam reformer, steam superheater, steam generator, condenser, helium gas cooler, feed gas heater and feed gas superheater were described. Evaluation codes were newly made to evaluate heat transfer characteristics from measured test data. Overall heat-transfer coefficient obtained from the experimental data were compared and evaluated with the prospective value calculated with heat transfer formulae. As a result, heat transfer performance and thermal efficiency of these heat exchangers were confirmed to be appropriate.

Performance test results of helium gas circulator of mock-up test facility with full-scale reaction tube for HTTR hydrogen production system (Contract research)

Shimizu, Akira; Kato, Michio; Hayashi, Koji; Fujisaki, Katsuo; Aita, Hideki; Takeda, Tetsuaki; Nishihara, Tetsuo; Katanishi, Shoji; Takada, Shoji; Inaba, Yoshitomo; et al.

JAERI-Tech 2003-033, 105 Pages, 2003/03

JAERI-Tech-2003-033.pdf:8.35MB

no abstracts in English