Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Kumada, Takayuki; Nakagawa, Hiroshi; Miura, Daisuke; Sekine, Yurina; Motokawa, Ryuhei; Hiroi, Kosuke; Inamura, Yasuhiro; Oku, Takayuki; Oishi, Kazuki*; Morikawa, Toshiaki*; et al.
Journal of Physical Chemistry Letters (Internet), 14(34), p.7638 - 7643, 2023/08
Times Cited Count:0 Percentile:0.01(Chemistry, Physical)The structure of nano-ice crystals in rapidly frozen glucose solution was elucidated by using spin-contrast-variation small-angle neutron scattering, which distinguishes the nano-ice crystal signal from the frozen amorphous solution signal by the polarization-dependent neutron scattering. The analysis revealed that the nano-ice crystals form a planar structure with a diameter exceeding tens of nanometers and a thickness of 1 nm, which is close to the critical nucleation size. This result suggests that the glucose molecules are preferentially bound to a specific face of nano-ice crystals, and then block the crystal growth perpendicular to that face.
Saito, Takumi*; Motokawa, Ryuhei; Okubo, Takahiro*; Miura, Daisuke*; Kumada, Takayuki
Environmental Science & Technology, 57(26), p.9802 - 9810, 2023/07
Times Cited Count:0 Percentile:0(Engineering, Environmental)Kumada, Takayuki; Miura, Daisuke*; Akutsu, Kazuhiro*; Oku, Takayuki; Torikai, Naoya*; Niizeki, Tomotake*
Hamon, 32(4), p.165 - 168, 2022/11
We demonstrated the advantage of spin-contrast-variation neutron reflectometry on the structure analysis of buried interface between resin and porous silica layers. The interface structure was not reproduced by the normal Gaussian model, but by the asymmetric interface model where crosslinked polymer chains neither permeate the pore nor follow the surface roughness of the silica layer.
Kumada, Takayuki; Miura, Daisuke*; Akutsu, Kazuhiro*; Oishi, Kazuki*; Morikawa, Toshiaki*; Kawamura, Yukihiko*; Suzuki, Junichi*; Oku, Takayuki; Torikai, Naoya*; Niizeki, Tomotake*
Journal of Applied Crystallography, 55(5), p.1147 - 1153, 2022/10
Times Cited Count:1 Percentile:27.54(Chemistry, Multidisciplinary)Spin-contrast-variation neutron reflectivity obtains multiple reflectivity curves from a single sample and a single beam source. We used the strong point of the technique to reveal that, although methylated-perhydropolysilazane-derived silica layer has a higher porosity near the interface with acrylic urethane resin, the resin did not permeate the pore network.
Miura, Daisuke*; Kumada, Takayuki; Sekine, Yurina; Oku, Takayuki; Takata, Shinichi; Hiroi, Kosuke; Iwata, Takahiro*
J-PARC 22-02; J-PARC MLF Annual Report 2021, p.6 - 7, 2022/03
We carried out spin contrast variation neutron powder diffractometry of glutamic acid crystal. The diffraction peak intensities varied as a function of proton polarization. We extracted the structure factor of hydrogen atoms from the variation of peak intensities.
Miura, Daisuke*; Kumada, Takayuki; Iwata, Takahiro*
Nihon Kessho Gakkai-Shi, 63(4), p.287 - 293, 2021/12
We have developed the spin-contrast-variation neutron powder diffractometry to observe hydrogen atoms in a crystalline sample by polarized neutron and polarized proton in the crystal. L-glutamic acid crystals were dispersed in a deuterated polystyrene matrix containing a polarizing agent. The intensities of the diffraction peaks of the sample changed according to the proton polarization. The spin-contrast-variation neutron powder diffractometry can extract diffraction from hydrogen atoms because of the variation of peak intensities as a function of the proton polarization. This technique is expected to enable analyses of the structures of hydrogen-containing materials that are difficult to determine with conventional powder diffractometry.
Miura, Daisuke*; Kumada, Takayuki; Sekine, Yurina; Motokawa, Ryuhei; Nakagawa, Hiroshi; Oba, Yojiro; Ohara, Takashi; Takata, Shinichi; Hiroi, Kosuke; Morikawa, Toshiaki*; et al.
Journal of Applied Crystallography, 54(2), p.454 - 460, 2021/04
Times Cited Count:1 Percentile:17.08(Chemistry, Multidisciplinary)We developed a spin-contrast-variation neutron powder diffractometry technique that extracts the structure factor of hydrogen atoms, namely, the contribution of hydrogen atoms to a crystal structure factor. Crystals of L-glutamic acid were dispersed in a dpolystyrene matrix containing 4-methacryloyloxy-2,2,6,6,-tetramethyl-1-piperidinyloxy (TEMPO methacrylate) to polarize their proton spins dynamically. The intensities of the diffraction peaks of the sample changed according to the proton polarization, and the structure factor of the hydrogen atoms was extracted from the proton-polarization dependent intensities. This technique is expected to enable analyses of the structures of hydrogen-containing materials that are difficult to determine with conventional powder diffractometry.
Kumada, Takayuki; Akutsu, Kazuhiro*; Oishi, Kazuki*; Morikawa, Toshiaki*; Kawamura, Yukihiko*; Sahara, Masae*; Suzuki, Junichi*; Miura, Daisuke*; Torikai, Naoya*
J-PARC 20-02; J-PARC MLF Annual Report 2019, p.38 - 40, 2021/00
Kumada, Takayuki; Miura, Daisuke*; Akutsu, Kazuhiro*; Suzuki, Junichi*; Torikai, Naoya*
Hamon, 30(4), p.207 - 211, 2020/11
We developed a technique of spin-contrast-variation neutron reflectivity (SCV-NR) for structural analyses of multilayer films. The SCV-NR curves of the polystyrene monolayer film were precisely reproduced using a common set of structural parameters and neutron scattering length density at each proton polarization. This result ensures that SCV-NR curves are not deformed by inhomogeneous PH due to the spin-diffusion mechanism. The number of structural parameters of the lamellar microphase-separated poly(styrene-block-isoprene) thin film is too large to determine with a single unpolarized reflectivity curve only. However, these parameters converged through the global analysis of the SCV-NR curves. In this manner, SCV-NR determines the structure of multilayer films while excluding the incorrect structural model that accidentally accounts for a single unpolarized reflectivity curve only.
Ishizawa, Akihiro*; Idomura, Yasuhiro; Imadera, Kenji*; Kasuya, Naohiro*; Kanno, Ryutaro*; Satake, Shinsuke*; Tatsuno, Tomoya*; Nakata, Motoki*; Nunami, Masanori*; Maeyama, Shinya*; et al.
Purazuma, Kaku Yugo Gakkai-Shi, 92(3), p.157 - 210, 2016/03
The high-performance computer system Helios which is located at The Computational Simulation Centre (CSC) in The International Fusion Energy Research Centre (IFERC) started its operation in January 2012 under the Broader Approach (BA) agreement between Japan and the EU. The Helios system has been used for magnetised fusion related simulation studies in the EU and Japan and has kept high average usage rate. As a result, the Helios system has contributed to many research products in a wide range of research areas from core plasma physics to reactor material and reactor engineering. This project review gives a short catalogue of domestic simulation research projects. First, we outline the IFERC-CSC project. After that, shown are objectives of the research projects, numerical schemes used in simulation codes, obtained results and necessary computations in future.
Nago, Makito*; Hagihara, Takeshi*; Minamide, Masashi*; Motoshima, Takayuki*; Jin, Kazumi; Kudo, Hajime; Sugita, Yutaka; Miura, Yoichi*
Dai-49-Kai Zenkoku Kensetsugyo Rodo Saigai Boshi Taikai Kenkyu Rombunshu (CD-ROM), p.77 - 80, 2012/10
This paper presents measures against gas emission during deep shaft excavation in the Horonobe Underground Research Laboratory Project (Horonobe URL Project). The gas control measures taken in the Horonobe URL Project include the following: (1) determination of the amount of methane contained in surrounding strata and groundwater, and gas concentration based on preliminary investigations, (2) determination of the specifications of fans, dust collectors, and ducts through ventilation network analysis (simulation), (3) reduction of methane gas emission through the use of waterproofing grout, (4) prohibition on the use of internal-combustion engine and the adoption of explosion-proof equipment, (5) development of methane gas control system, and (6) monitoring of methane gas emission. (3) to (6) described above are performed daily in the safety management activities and described in detail in this paper. The ventilation and eastern access shafts have currently reached a depth of 290 m and 250 m, respectively. The emission of methane gas has been observed to rise 0.3 % to 1.3 % in the fault zone, and it is controlled appropriately according to the gas control measures described above. As the measure to reduce the methane gas concentration, monitoring is confirmed to be effective.
Imaizumi, Tomomi; Miyauchi, Masaru; Ito, Masayasu; Watahiki, Shunsuke; Nagata, Hiroshi; Hanakawa, Hiroki; Naka, Michihiro; Kawamata, Kazuo; Yamaura, Takayuki; Ide, Hiroshi; et al.
JAEA-Technology 2011-031, 123 Pages, 2012/01
The number of research reactors in the world is decreasing because of their aging. However, the planning to introduce the nuclear power plants is increasing in Asian countries. In these Asian countries, the key issue is the human resource development for operation and management of nuclear power plants after constructed them, and also the necessity of research reactor, which is used for lifetime extension of LWRs, progress of the science and technology, expansion of industry use, human resources training and so on, is increasing. From above backgrounds, the Neutron Irradiation and Testing Reactor Center began to discuss basic concept of a multipurpose low-power research reactor for education and training, etc. This design study is expected to contribute not only to design tool improvement and human resources development in the Neutron Irradiation and Testing Reactor Center but also to maintain and upgrade the technology on research reactors in nuclear power-related companies. This report treats the activities of the working group from July 2010 to June 2011 on the multipurpose low-power research reactor in the Neutron Irradiation and Testing Reactor Center and nuclear power-related companies.
Shibano, Junichi*; Kiriyama, Koji; Kajiwara, Kentaro*; Shobu, Takahisa; Suzuki, Kenji*; Arai, Takayuki*; Miura, Setsuo*; Kobayashi, Michiaki*
Zairyo, 58(7), p.596 - 602, 2009/07
Miura, Takayuki*; Kuwano, Hisashi*; Kikuchi, Kenji
Tetsu To Hagane, 87(2), p.31 - 36, 2001/02
no abstracts in English
; *; Kikuchi, Kenji; ; Miura, Takayuki*
Proc. of 4th Int. Conf. on Recrystallization and Related Phenomena (REX'99), p.283 - 288, 1999/00
no abstracts in English
*; *; *; *; *; *; *; Oikawa, Toshihiro; *; *; et al.
Fusion Energy 1996, p.885 - 890, 1997/05
no abstracts in English
Kiriyama, Koji; Shibano, Junichi*; Kajiwara, Kentaro*; Shobu, Takahisa; Suzuki, Kenji*; Kaneko, Hiroshi; Nishimura, Suguru*; Arai, Takayuki*; Miura, Setsuo*; Kobayashi, Michiaki*
no journal, ,
Residual stress measurement is important to understand Stress Corrosion Cracking process. In this study, measurements of imaging and inner stress mapping around a crack-tip in steel material (alpha-Fe) have performed at beam-line BL14B1 and BL28B2 at SPring-8. The results showed that artificial cracking in the sample was clearly measured by imaging and that stress maps quite correspond to the result of imaging. Therefore, these methods are very effective tool for measurement of inner state of steel material.
Kiriyama, Koji; Shibano, Junichi*; Kajiwara, Kentaro*; Shobu, Takahisa; Suzuki, Kenji*; Arai, Takayuki*; Miura, Setsuo*; Kobayashi, Michiaki*
no journal, ,
Residual stress measurement and fractographycal study of cracks are important to understand SCC (Stress Corrosion Cracking) process. In this study, CT (Computerized Tomography) imaging of steel material (alpha-Fe) have performed at BL28B2 at SPring-8. The result showed that artificial crack in the sample was clearly measured by CT, and CT are very effective tool to measure an inner state of steel material.
Shibano, Junichi*; Kajiwara, Kentaro*; Kiriyama, Koji; Shobu, Takahisa; Suzuki, Kenji*; Arai, Takayuki*; Miura, Setsuo*; Kobayashi, Michiaki*
no journal, ,
Shibano, Junichi*; Kiriyama, Koji; Kajiwara, Kentaro*; Shobu, Takahisa; Suzuki, Kenji*; Arai, Takayuki*; Miura, Setsuo*; Kobayashi, Michiaki*
no journal, ,
no abstracts in English