Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Yamamoto, Masahiko; Nishida, Naoki; Kobayashi, Daisuke; Nemoto, Ryo*; Hayashi, Hiroyuki*; Kitao, Takahiko; Kuno, Takehiko
JAEA-Technology 2023-004, 30 Pages, 2023/06
JAEA-Technology-2023-004.pdf:1.94MB
Glove-box gloves, that are used for handling nuclear fuel materials at the Tokai Reprocessing Plant (TRP) of the Japan Atomic Energy Agency, have an expiration date by internal rules. All gloves are replaced at a maximum of every 4-year. However, degrees of glove deterioration varies depending on its usage environment such as frequency, chemicals, and radiation dose. Therefore, physical properties such as tensile strength, elongation, hardness of gloves are measured and technical evaluation method for the glove life-time is established. It was found that gloves without any defects in its appearance have enough physical properties and satisfies the acceptance criteria values of new gloves. Thus, it was considered that the expired gloves could be used for total of 8-year, by adding 4-year of new glove life-time. In addition, the results of extrapolation by plotting the glove's physical properties versus the used years showed that the physical properties at 8-year is on the safer side than the reported physical properties of broken glove. Also, the data are not significantly different from the physical properties of the long-term storage glove (8 and 23 years). Based on these results, life-time of gloves at TRP is set to be 8-year. The frequency of glove inspections are not changed, and if any defects is found, the glove is promptly replaced. Thus, the risk related to glove usage is not increased. The cost of purchasing gloves, labor for glove replacement, and the amount of generated waste can be reduced by approximately 40%, respectively, resulting in more efficient and rationalized glove management.
Kobayashi, Daisuke; Yamamoto, Masahiko; Nishida, Naoki; Miyoshi, Ryuta; Nemoto, Ryo*; Hayashi, Hiroyuki*; Kato, Keisuke; Nishino, Saki; Kuno, Takehiko; Kitao, Takahiko; et al.
Nihon Hozen Gakkai Dai-18-Kai Gakujutsu Koenkai Yoshishu, p.237 - 240, 2022/07
All gloves attached to glove-box in Tokai Reprocessing Plant have a fixed expiration date and have to be replaced every 4-year. However, degrees of glove deterioration are different depending on its usage environment (frequency, chemicals, radiation, etc.), because of rubber products. Therefore, physical properties such as tensile strength, elongation, hardness of gloves are measured, and the life-time of gloves are estimated. As a result, gloves without any defects in its appearance have enough physical property for acceptance criteria of new glove. The extrapolated physical property of glove is sufficiently larger than the reported values of damaged glove. No deterioration in physical properties of gloves, that are periodically replaced without any defects in its appearance, is observed and the usable life-time of the glove is estimated to be 8 years.
Sekine, Megumi; Matsuki, Takuya; Suzuki, Satoshi*; Tsutagi, Koichi; Nishida, Naoki; Kitao, Takahiko; Tomikawa, Hirofumi; Nakamura, Hironobu; LaFleur, A.*; Browne, M.*
JAEA-Technology 2019-023, 160 Pages, 2020/03
JAEA-Technology-2019-023.pdf:9.43MB
The International Atomic Energy Agency (IAEA) has proposed in its Research and Development plan (STR-385), the development of technology to enable real-time flow measurement of nuclear material as a part of an advanced approach to effective and efficient safeguards for reprocessing facilities. To address this, Japan Atomic Energy Agency (JAEA) has been tackling development of a new detector to enable monitoring of Pu in solutions with numerous FPs as a joint research program with U.S. DOE to cover whole reprocessing process. In this study, High Active Liquid Waste (HALW) Storage Facility in Tokai Reprocessing Plant was used as the test field. At first, the design information of HALW storage tank and radiation (type and intensity) were investigated to develop a Monte Carlo N-Particle Transport Code (MCNP) model. And then, dose rate distribution outside/ inside of the concrete cell where the HALW tank is located was measured to design new detectors and check MCNP model applicability. Using the newly designed detectors, gamma rays and neutron were continuously measured at the outside/ inside of the concrete cell to assess the radiation characteristics and to optimize detector position. Finally, the applicability for Pu monitoring technology was evaluated based on the simulation results and gamma-ray/neutron measurement results. We have found that there is possibility to monitor the change of Pu amount in solution by combination both of gamma-ray and neutron measurement. The results of this study suggested the applicability and capability of the Pu motoring to enhance safeguards for entire reprocessing facility which handles Pu with FP as a feasibility study. This is final report of this project.
Kubo, Junichi*; Rahman, N.*; Takahashi, Nobuaki; Kawai, Takahiko*; Matsuba, Go*; Nishida, Koji*; Kanaya, Toshiji*; Yamamoto, Masahide*
Journal of Applied Polymer Science, 112(3), p.1647 - 1652, 2009/05
Times Cited Count：25 Percentile：62.54(Polymer Science)Aiming at improvement of mechanical and dielectric properties of poly(vinyl alcohol) (PVA) we prepared composites of PVA and magnesium nitrate. It was found that the composites were very soft and rubber-like, and the glass transition temperature decreased with increasing the salt concentration. Wide-angle X-ray diffraction and small-angle X-ray scattering revealed that the crystallites of PVA were destroyed by the additive and it was a cause of the softening.
Nishida, Takahiko; Izui, Kazuhiko
JAERI-M 6867, 15 Pages, 1977/01
no abstracts in English
Matsuki, Takuya; Nishida, Naoki; Horigome, Kazushi; Sekine, Megumi; Kitao, Takahiko; Nakamura, Hironobu
no journal, ,
To inquest the measurement point of the detector which can conduct the Pu monitoring in the high active liquid waste at Tokai reprocessing plant, we have made the simulation model which can calculate the radiation distribution in the cell storing HALW. Comparing the dose rate distribution between calculation result and actual measurement result, we evaluated the validity of the current simulation model.
