検索対象:     
報告書番号:
※ 半角英数字
 年 ~ 
 年
検索結果: 5 件中 1件目~5件目を表示
  • 1

発表形式

Initialising ...

選択項目を絞り込む

掲載資料名

Initialising ...

発表会議名

Initialising ...

筆頭著者名

Initialising ...

キーワード

Initialising ...

使用言語

Initialising ...

発行年

Initialising ...

開催年

Initialising ...

選択した検索結果をダウンロード

論文

Evaluation of $$gamma$$-ray and neutron energy for area monitoring system in the IFMIF/EVEDA accelerator building

高橋 博樹; 前原 直; 榊 泰直; 平林 慶一*; 日高 浩介*; 執行 信寛*; 渡辺 幸信*; 相良 建至*

Fusion Engineering and Design, 87(7-8), p.1235 - 1238, 2012/08

 被引用回数:0 パーセンタイル:0.01(Nuclear Science & Technology)

IFMIF/EVEDA加速器は9MeV, 125mAのD$$^{+}$$ビームの加速器であり、六ヶ所サイトに計画されている。加速器系設備では、中性子及び$$gamma$$線モニターと連携したエリアモニターを構築する計画している。採用予定の中性子及び$$gamma$$線の検出レベルは、1.5eV$$sim$$15MeV領域レベルであり、現在の遮蔽設計において、これらの検出レベル以下となるような遮蔽であるかどうか検証することが安全審査のために必要不可欠である。このためにD$$^{+}$$重陽子イオンビーム入射による銅からの中性子角度分布のエネルギー依存性を九州大学との共同研究で取得し、この核データを用いてビームダンプから発生する$$gamma$$線及び中性子のエネルギー減衰についてPHITSコードを用いて解析した。本報告では、ビームダンプの構造、加速器室を現設計に近いジオメトリとして評価を行う。

論文

Design of $$gamma$$-ray and neutron area monitoring system for the IFMIF/EVEDA accelerator building

高橋 博樹; 前原 直; 小島 敏行; 久保 隆司; 榊 泰直; 竹内 浩; 設楽 弘之; 平林 慶一*; 日高 浩介*; 執行 信寛*; et al.

Fusion Engineering and Design, 86(9-11), p.2795 - 2798, 2011/10

 被引用回数:2 パーセンタイル:18.29(Nuclear Science & Technology)

IFMIF/EVEDAの加速器実験では、ビームダンプのターゲット材として銅を採用した設計が進められており、最大9MeVの重陽子ビームが入射される計画である。このため大量の中性子が発生するとともに、ビームダンプの熱負荷除去ための水やコンクリート遮蔽材による$$gamma$$線生成が予想できる。加速器系設備では、中性子及び$$gamma$$線モニターと連携したPPSを構築する計画している。採用予定の中性子及び$$gamma$$線の検出レベルは、それぞれ0.025eV$$sim$$15MeV, 80keV$$sim$$1.5MeV領域レベルであり、現在の遮蔽設計において、これらの検出レベル以下となるような遮蔽であるかどうか検証することが安全審査のために必要不可欠である。このために9MeV重陽子イオンビーム入射による銅からの中性子角度分布のエネルギー依存性を九州大学との共同研究で取得し、この核データを用いて水及びコンクリートにおける$$gamma$$線及び中性子のエネルギー減衰についてPHITSコードを用いて解析した。

論文

Activation analyses by the beam losses in the IFMIF/EVEDA accelerator

前原 直; 高橋 博樹; 榊 泰直; 平林 慶一*; 日高 浩介*; 執行 信寛*; 渡辺 幸信*; 相良 建至*

JAEA-Conf 2011-002, p.199 - 204, 2011/09

In the IFMIF/EVEDA project, the engineering validation through accelerator prototype for deuteron CW beam acceleration up to 9 MeV with output current of 125 mA is planning at the BA site in Rokkasho, Aomori, Japan. The activation due to beam loss or stopping of deuterons is critical to achieve successful beam operation, analyses of source terms of radiation and activities in the accelerator structural materials, Cu, SUS316, Fe, etc., are indispensable for safety assessment to obtain permission of operation. Since there was no experimental data for Cu(d,nx) reaction in the range of 5-9 MeV, deuteron induced thick target neutron yield at 5 MeV and 9 MeV were measured in collaboration with Kyushu University. In this article, the experimental data at 9 MeV is used as a source term in neutron transportation, and isotope productions in the materials; Copper, iron and stainless steel, are evaluated by PHITS code.

論文

Measurement of deuteron induced thick target neutron yields at 9 MeV

執行 信寛*; 日高 浩介*; 平林 慶一*; 中村 泰博*; 森口 大輔*; 隈部 正洋*; 平野 秀峻*; 平山 嵩祐*; 内藤 有紀*; 本岡 親英*; et al.

Journal of the Korean Physical Society, 59(2), p.1725 - 1728, 2011/08

The double differential thick target neutron yields from 9 MeV deuteron incidences were measured at the Kyushu University Tandem Accelerator Laboratory. A copper and a titanium foils which are thick enough for a deuteron to stop in the foils were placed at the center of a vacuum chamber. An NE213 liquid organic scintillator was employed to detect neutrons emitted from targets and placed at 9 directions from 0$$^{circ}$$ to 140$$^{circ}$$. To consider the contribution of scattered neutrons from the floor, we also measured neutron yields with an iron shadow bar located in front of the scintillator. Because incident deuteron beam was not pulsed and the Time-of-Flight method was not applied, the energy spectrum was derived from unfolding the light output spectrum using the FORIST code. The detection efficiency was calculated with the SCINFUL-QMD code. The experimental results were compared with the calculation data of the TALYS code, and it turned out that the calculation data does not reproduce the experimental ones satisfactorily.

口頭

Cu, Tiに対する9MeV重陽子中性子収量測定

執行 信寛*; 日高 浩介*; 平林 慶一*; 中村 泰博*; 森口 大輔*; 平野 秀峻*; 平山 嵩祐*; 内藤 有紀*; 渡辺 幸信*; 相良 建至*; et al.

no journal, , 

9MeV重陽子を厚い銅とチタンに入射したときの中性子収量測定を行った。中性子検出器に直径5.08cm,厚さ5.08cmのNE213シンチレータを使用し、発光量をアンフォールディングすることにより中性子エネルギースペクトルを導出した。その結果、銅の場合、中性子エネルギーが9MeV以上の領域で15$$^{circ}$$方向の収量が0$$^{circ}$$方向の収量を上回ることがわかった。また、チタンの場合は中性子のエネルギーが8MeVから12MeVの範囲で同様の傾向が見られた。

5 件中 1件目~5件目を表示
  • 1