Structural changes of polystyrene particles in subcritical and supercritical water revealed by in situ small-angle neutron scattering

Shibata, Motoki*; Nakanishi, Yohei*; Abe, Jun*; Arima, Hiroshi*; Iwase, Hiroki*; Shibayama, Mitsuhiro*; Motokawa, Ryuhei; Kumada, Takayuki; Takata, Shinichi; Yamamoto, Katsuhiro*; et al.

Polymer Journal, 55(11), p.1165 - 1170, 2023/11

https://doi.org/10.1038/s41428-023-00817-1

Structural investigation of borosilicate glasses by using XAFS measurement in soft X-ray region, 3 (Joint research)

Nagai, Takayuki; Okamoto, Yoshihiro; Yamagishi, Hirona*; Shibata, Daisuke*; Kojima, Kazuo*; Hasegawa, Takehiko*; Sato, Seiichi*; Fukaya, Akane*; Hatakeyama, Kiyoshi*

JAEA-Research 2023-004, 45 Pages, 2023/09

JAEA-Research-2023-004.pdf:6.07MB

The local structure of glass-forming elements and waste elements in borosilicate glasses varies with its chemical composition. In this study, simulated waste glass samples were prepared and the chemical state regarding boron (B), silicon (Si) and waste elements of iron (Fe), cesium (Cs) were estimated by using XAFS measurement in soft X-ray region. To understand the chemical stability of simulated waste glasses, XANES spectra of B K-edge, Fe L, L-edge, and Cs M, M-edge were measured on the glass surface exposed to the leachate. As a result, it was found that the glass surface exposed to the leachate was changed and it was difficult to obtain a clear XANES spectrum. From the B K-edge XANES spectra on glass surfaces exposed to the leachate, an increase in three-coordination of B-O (BO) and a decrease in four-coordination of B-O (BO) were observed compared to the glass surfaces before immersion. The XANES spectra of Fe L, L-edge, and Cs M, M-edge show that as the exposure time in the leachate increases, the Cs present on the glass surface dissolves into the leachate. The XANES spectra of Si K-edge were measured on simulated waste glass surfaces before immersion, and it was confirmed that the change in XANES spectra given by NaO concentration had a larger effect than the waste component concentration.

Quasielastic neutron scattering probing H dynamics in the H conductors LaHO

Tamatsukuri, Hiromu; Fukui, Keiga*; Iimura, Soshi*; Honda, Takashi*; Tada, Tomofumi*; Murakami, Yoichi*; Yamaura, Junichi*; Kuramoto, Yoshio*; Sagayama, Hajime*; Yamada, Takeshi*; et al.

Physical Review B, 107(18), p.184114_1 - 184114_8, 2023/05

https://doi.org/10.1103/PhysRevB.107.184114

Case study activities for nuclear security culture development in JAEA

Amano, Tsukasa; Shibata, Ryodai; Sato, Yoshiharu; Yamazaki, Katsuyuki; Shiromo, Hideo; Nakamura, Hironobu

Proceedings of INMM & ESARDA Joint Annual Meeting 2023 (Internet), 6 Pages, 2023/05

In Japan, about 10 years have passed since the law obligated nuclear operators to develop and maintain a nuclear security culture. During this period, the global nuclear situation has changed significantly, and it is becoming important to maintain a stance that emphasizes compliance with regulations and nuclear security culture. In JAEA, the policy of legal compliance and developing nuclear security culture is determined by the president of JAEA. For legal compliance and developing nuclear security culture, many activities are carried out based on that policy. Finally, these activities are evaluated and improved it every year. Case study is the one of activities that can obtain skills for legal compliance and developing nuclear security culture, such as sensitivity of nuclear security risks, correct understanding of the laws. The procedure for the case study was created with reference to a method called KY-Training which is often applied to safety training program in Japan. KY-Training is a training that participants (groups) can reach the conclusion how to respond to cases through four questions. Firstly, participants are given illustrations and descriptions which has potential of nuclear security risks. Then, participants make discussion according to four questions. Consequently, participants can effectively become aware of nuclear security risks. In the 2022 case study, we prepared 23 cases so that they can select choose freely according to role of participants such as in charge of nuclear security, guards, general employees. Finally, participants are asked to fill a questionnaire to evaluate effectiveness of case study. The result of questionnaires indicated that the case study was able to lead to improvement sensitivity of nuclear security risks and correct understanding of the laws. Overall, case study results suggested that JAEA's efforts were implying sufficiently to develop and maintain a nuclear security culture.

Experimental investigation of spray cooling behavior in 44 simulated fuel bundle

Nagatake, Taku; Shibata, Mitsuhiko; Yoshida, Hiroyuki; Nemoto, Yoshiyuki; Kaji, Yoshiyuki

Journal of Nuclear Science and Technology, 60(3), p.320 - 333, 2023/03

https://doi.org/10.1080/00223131.2022.2096146

In Fukushima Daiichi Nuclear Power Plant accident, failure of cooling system for spent fuel pool occurred and there was a concern that the spent fuels were damaged. Then a safety measures for SFP cooling in severe accident condition is required. As a countermeasure for SFP severe accident, it is considered that a portable spray is used for SFP cooling in such condition. In this research project, the numerical simulation methods have been developed in order to evaluate the applicability of portable spray system for cooling SFPs. And experiments were also performed in order to get a knowledge of spray cooling phenomena and validation data for the numerical simulation methods. As one of the experiments, a cooling experiment by using 44 simulated fuel assembly were performed and temperature distribution during spray cooling process were measured. In this paper, the results of a cooling experiment are reported.

Neutron reflectivity study on the nanostructure of PMMA chains near substrate interfaces based on contrast variation accompanied with small molecule sorption

Shimokita, Keisuke*; Yamamoto, Katsuhiro*; Miyata, Noboru*; Nakanishi, Yohei*; Shibata, Motoki*; Takenaka, Mikihito*; Yamada, Norifumi*; Seto, Hideki*; Aoki, Hiroyuki; Miyazaki, Tsukasa*

Soft Matter, 19(11), p.2082 - 2089, 2023/03

https://doi.org/10.1039/D2SM01482C

A Phoswich alpha/beta detector for monitoring in the site of Fukushima Daiichi Nuclear Power Station

Morishita, Yuki; Takasaki, Koji; Kitayama, Yoshiharu; Tagawa, Akihiro; Shibata, Takuya; Hoshi, Katsuya; Kaneko, Junichi*; Higuchi, Mikio*; Oura, Masatoshi*

Radiation Measurements, 160, p.106896_1 - 106896_10, 2023/01

https://doi.org/10.1016/j.radmeas.2022.106896

This study proposes a newly developed phoswich alpha/beta detector that can discriminate alpha and beta particles emitted from the alpha and beta contaminations in the FDNPS site. The phoswich alpha/beta detector is made up of two layers of scintillators that detect alpha and beta particles. The pulse shape discrimination (PSD) method was used to detect alpha particles in high beta particle and high gamma-ray (comparable to gamma-ray dose rate near the FDNPS reactor building) environments. Due to a 23.3% full width at half maximum (FWHM) energy resolution for alpha particles, the detector can be used to distinguish between nuclear fuel materials such as plutonium and its radon progeny (Po-214). Moreover, the detector could distinguish alpha particles from Cs gamma rays with a dose rate background up to 9.0 mSv/h. It is the first to demonstrate that the developed phoswich detector can be used to discriminate and measure alpha and beta particles of the actual contaminated FDNPS samples.

Present status of JAEA's R&D toward HTGR deployment

Shibata, Taiju; Nishihara, Tetsuo; Kubo, Shinji; Sato, Hiroyuki; Sakaba, Nariaki; Kunitomi, Kazuhiko

Nuclear Engineering and Design, 398, p.111964_1 - 111964_4, 2022/11

https://doi.org/10.1016/j.nucengdes.2022.111964

Japan Atomic Energy Agency (JAEA) has been promoting the research and development (R&D) of High Temperature Gas-cooled Reactor (HTGR). R&D on reactor technologies is carried out by using High Temperature engineering Test Reactor (HTTR). The HTTR was resumed without significant reinforcements in 2021. On January 2022, a safety demonstration test under the OECD/NEA LOFC project was carried out. JAEA is promoting R&D on a carbon-free hydrogen production by thermochemical water splitting Iodine-Sulfur process (IS process). JAEA conducts design study for various HTGR systems toward commercialization. A new test program about demonstration of hydrogen production by the HTTR was launched. Steam methane reforming hydrogen production system was selected for the first demonstration by 2030.

A Numerical simulation method to evaluate heat transfer of fuel debris in air cooling by JUPITER, 2; Validation of porous model for natural convective heat transfer

Uesawa, Shinichiro; Yamashita, Susumu; Shibata, Mitsuhiko; Yoshida, Hiroyuki

Proceedings of 12th Japan-Korea Symposium on Nuclear Thermal Hydraulics and Safety (NTHAS12) (Internet), 8 Pages, 2022/10

Stabilization treatment of nuclear fuel material contained with organic matter

Senzaki, Tatsuya; Arai, Yoichi; Yano, Kimihiko; Sato, Daisuke; Tada, Kohei; Ogi, Hiromichi*; Kawanobe, Takayuki*; Ono, Shimpei; Nakamura, Masahiro; Kitawaki, Shinichi; et al.

JAEA-Testing 2022-001, 28 Pages, 2022/05

JAEA-Testing-2022-001.pdf:2.33MB

In preparation for the decommissioning of Laboratory B of the Nuclear Fuel Cycle Engineering Laboratory, the nuclear fuel material that had been stored in the glove box for a long time was moved to the Chemical Processing Facility (CPF). This nuclear fuel material was stored with sealed by a polyvinyl chloride (PVC) bag in the storage. Since it was confirmed that the PVC bag swelled during storage, it seems that any gas was generated by radiolysis of the some components contained in the nuclear fuel material. In order to avoid breakage of the PVC bag and keep it safety for long time, we began the study on the stabilization treatment of the nuclear fuel material. First, in order to clarify the properties of nuclear fuel material, radioactivity analysis, component analysis, and thermal analysis were carried out. From the results of thermal analysis, the existence of organic matter was clarified. Then, ion exchange resin with similar thermal characteristics was selected and the thermal decomposition conditions were investigated. From the results of these analyzes and examinations, the conditions for thermal decomposition of the nuclear fuel material contained with organic matter was established. Performing a heat treatment of a small amount of nuclear fuel material in order to confirm the safety, after which the treatment amount was scaled up. It was confirmed by the weight change after the heat treatment that the nuclear fuel material contained with organic matter was completely decomposed.