Near term test plan using HTTR (High Temperature engineering Test Reactor)

Takada, Shoji; Iigaki, Kazuhiko; Shinohara, Masanori; Tochio, Daisuke; Shimazaki, Yosuke; Ono, Masato; Yanagi, Shunki; Nishihara, Tetsuo; Fukaya, Yuji; Goto, Minoru; et al.

Nuclear Engineering and Design, 271, p.472 - 478, 2014/05

https://doi.org/10.1016/j.nucengdes.2013.12.018

JAEA has carried out research and development to establish the technical basis of HTGRs using HTTR. To connect hydrogen production system to HTTR, it is necessary to ensure the reactor dynamics when thermal-load of the system is lost. Thermal-load fluctuation test is planned to demonstrate the reactor dynamics stability and to validate plant dynamics codes. It will be confirmed that the reactor become stable state during losing a part of removed heat at heat-sink. A temperature coefficient of reactivity is one of the important parameters for core dynamics calculations, and changes with burnup because of variance of fuel compositions. Measurement of temperature coefficient of reactivity has been conducted to confirm the validity of calculated temperature coefficient of reactivity. A LOFC test using HTTR has been carried out to verify the inherent safety under the condition of LOFC while the reactor shut-down system disabled.

Study of the applicability of CFD calculation for HTTR reactor

Tsuji, Nobumasa*; Nakano, Masaaki*; Takada, Eiji*; Tokuhara, Kazumi*; Ohashi, Kazutaka*; Okamoto, Futoshi*; Tazawa, Yujiro; Inaba, Yoshitomo; Tachibana, Yukio

Proceedings of 6th International Topical Meeting on High Temperature Reactor Technology (HTR 2012) (USB Flash Drive), 9 Pages, 2012/10

Passive heat removal performance of the reactor vessel cavity cooling system (RCCS) is of primary concern for enhanced inherent safety of HTGR. In a loss of forced cooling accident, decay heat must be removed by radiation and natural convection of RCCS. Thus thermal hydraulic analysis of reactor internals and RCCS is powerful means for evaluation of the heat removal performance of RCCS. The thermal hydraulic analyses using CFD computation tools are conducted for normal operation of the High Temperature Engineering Test Reactor (HTTR) and are compared to the temperature distribution of measured data. The calculated temperatures on outer faces of the permanent side reflector (PSR) blocks are in fair agreement with measured data. The transient analysis for decay heat removal mode in HTTR is also conducted.

Evaluation of dose rate reduction in a spacecraft compartment due to additional water shield

Sato, Tatsuhiko; Niita, Koji*; Shurshakov, V. A.*; Yarmanova, E. N.*; Nikolaev, I. V.*; Iwase, Hiroshi*; Sihver, L.*; Mancusi, D.*; Endo, Akira; Matsuda, Norihiro; et al.

Cosmic Research, 49(4), p.319 - 324, 2011/08

https://doi.org/10.1134/S0010952511040083

HZE particle transport codes are the indispensable tool in the shielding design of spacecrafts. We are therefore developing a general-purpose Monte Carlo code PHITS, which can deal with the transports of all kinds of hadrons and heavy ions with energies up to 200 GeV/n in 3-dimensional phase spaces. The applicability of PHITS to space researches has been well verified by comparing the neutron spectra in spacecrafts calculated by the code with the corresponding experimental data. Recently, PHITS was employed in the estimation of radiation fields in the Russian Service Module in ISS. The results of the estimation indicate that PHITS can reproduce experimental data of the dose reduction rates due to water shielding attached on the wall of the Russian crew cabin fairly well. The details of the calculation procedures will be given in the presentation, together with the results of other applications of PHITS to the space exploration.

Examination on small-sized cogeneration HTGR for developing countries

Sakaba, Nariaki; Tachibana, Yukio; Shimakawa, Satoshi; Ohashi, Hirofumi; Sato, Hiroyuki; Yan, X.; Murakami, Tomoyuki; Ohashi, Kazutaka; Nakagawa, Shigeaki; Goto, Minoru; et al.

JAEA-Technology 2008-019, 57 Pages, 2008/03

JAEA-Technology-2008-019.pdf:8.59MB

The small-sized and safe cogeneration High Temperature Gas-cooled Reactor (HTGR) that can be used not only for electric power generation but also for hydrogen production and district heating is considered one of the most promising nuclear reactors for developing countries where sufficient infrastructure such as power grids is not provided. Thus, the small-sized cogeneration HTGR, named High Temperature Reactor 50-Cogeneration (HTR50C), was studied assuming that it should be constructed in developing countries. Specification, equipment configuration, etc. of the HTR50C were determined, and economical evaluation was made. As a result, it was shown that the HTR50C is economically competitive with small-sized light water reactors.

Temperature dependence of magnetic moment orientation in CoZ-type hexaferrite estimated by high-temperature neutron diffraction

Takada, Yukio*; Nakagawa, Takashi*; Fukuta, Yasunari*; Tokunaga, Masatoshi*; Yamamoto, Takao*; Tachibana, Takeshi*; Kawano, Shinji*; Igawa, Naoki; Ishii, Yoshinobu

Japanese Journal of Applied Physics, 44(5A), p.3151 - 3156, 2005/05

https://doi.org/10.1143/JJAP.44.3151

We investigated the correlation between the thremomagnetic curve of CoZ-Type hexagonal barium ferrite, BaCoFeO and its magnetic moment direction. The thermomagnetic curve shows two significant magnetization slumps at 540K and 680K. High-temperature neutron diffraction experiment and Rietveld analyses indicate that temperature rise from 523 to 573K makes the magnetic moments turn to the c-axis from a direction parallel to the c-plane most significantly.The change in average orientation of the magnetic moments must be induced by the disappearence of the contribution of cobalt to magnetism in this temperature.

Safety demonstration test (SR-2/S2C-2/SF-1) plan using the HTTR (Contract research)

Sakaba, Nariaki; Nakagawa, Shigeaki; Takamatsu, Kuniyoshi; Takada, Eiji*; Saito, Kenji; Furusawa, Takayuki; Tochio, Daisuke; Tachibana, Yukio; Iyoku, Tatsuo

JAERI-Tech 2004-014, 24 Pages, 2004/02

JAERI-Tech-2004-014.pdf:1.06MB

Safety demonstration tests using the HTTR are in progress to verify the inherent safety features and to improve the safety design and evaluation technologies for HTGRs, as well as to contribute to not only the commercial HTGRs but also the research and development for the VHTR one of the Generation IV reactors. This paper describes the reactivity insertion test and coolant flow reduction test by trip of gas circulator and partial flow loss of coolant planned in 2004 with detailed test method, procedure and results of pre-test analysis. From the analytical results, it was found that the negative reactivity feedback effect of the core brings the reactor power safely to a stable level without a reactor scram.

Safety demonstration test (S1C-2/S2C-1) plan using the HTTR (Contract research)

Sakaba, Nariaki; Nakagawa, Shigeaki; Takada, Eiji*; Tachibana, Yukio; Saito, Kenji; Furusawa, Takayuki; Takamatsu, Kuniyoshi; Tochio, Daisuke; Iyoku, Tatsuo

JAERI-Tech 2003-074, 37 Pages, 2003/08

JAERI-Tech-2003-074.pdf:1.83MB

Safety demonstration tests using HTTR are now underway in order to verify the inherent safety features and to improve the safety design and evaluation technologies for HTGRs, as well as to contribute to research and development for the VHTR, which is one of the Generation IV reactors. The first phase of the safety demonstration tests includes reactivity insertion tests by means of control-rod withdrawal and coolant flow reduction tests by tripping the gas circulators. In the second phase, accident simulation tests will be conducted. This paper describes the plan of coolant flow reduction tests by tripping of gas circulators planned in August 2003 with detailed test method, procedure and results of pre-test analysis. The analysis results of the steady state and transient behaviours of the reactor and the plant of the HTTR show that in the case of a rapid decrease of the coolant flow rate, the negative reactivity feedback effect of the core brings the reactor power safely to certain stable level without a reactor scram, and that the temperature transient of the reactor core is slow.

Rise-to-power test in High Temperature Engineering Test Reactor; Test progress and summary of test results up to 30MW of reactor thermal power

Nakagawa, Shigeaki; Fujimoto, Nozomu; Shimakawa, Satoshi; Nojiri, Naoki; Takeda, Takeshi; Saikusa, Akio; Ueta, Shohei; Kojima, Takao; Takada, Eiji*; Saito, Kenji; et al.

JAERI-Tech 2002-069, 87 Pages, 2002/08

JAERI-Tech-2002-069.pdf:10.12MB

Rise-to-power test in the HTTR has been performed from April 23rd to June 6th in 2000 as phase 1 test up to 10MW, from January 29th to March 1st in 2001 as phase 2 test up to 20MW in the rated operation mode and from April 14th to June 8th in 2001 as phase 3 test up to 20MW in the high temperature test operation mode. Phase 4 test to achieve the thermal reactor power of 30MW started from October 23rd in 2001. On December 7th it was confirmed that the thermal reactor power reached to 30MW and the reactor outlet coolant temperature reached to 850C. JAERI obtained the certificate of pre-operation test from MEXT because all the pre-operation tests by MEXT were passed successfully. From the test results of rise-up-power test up to 30MW, the performance of reactor and cooling system were confirmed, and it was confirmed that an operation of reactor facility could be performed safely. Some problems to be solved were found through tests. By means of solving them, the reactor operation with the reactor outlet coolant temperature of 950C will be achievable.

Cause and countermeasure for heat up of HTTR core support plate at power rise tests

Fujimoto, Nozomu; Takada, Eiji*; Nakagawa, Shigeaki; Tachibana, Yukio; Kawasaki, Kozo; Saikusa, Akio; Kojima, Takao; Iyoku, Tatsuo

JAERI-Tech 2001-090, 69 Pages, 2002/01

JAERI-Tech-2001-090.pdf:7.88MB

HTTR has carried out many kinds of tests as power rise tests in which reactor power rises step by step after attained the first criticality. In the tests, temperature of a core support plate showed higher results than expected value at each power level, the temperature was expected to be higher than the maximum working temperature at 100% power level. Therefore, tests under the high temperature test operation mode, in which the core flow rate was different, were carried out to predict the temperature at 100% power precisely, and investigate the cause of the temperature rise. From the investigation, it was clear that the cause was gap flow in a core support structure. Furthermore, it was estimated that the temperature of the core support plate rose locally due to change in gap width between the core support plate and a seal plate due to change in core pressure drop. The maximum working temperature of the core support plate was revised. The integrity of core support plate under the revised maximum working temperature condition was confirmed by stress analyses.

Development of a remote-controlled fatigue test machine using a laser extensometer in Hot Laboratory for study of irradiation effect on fatigue properties

Ishii, Toshimitsu; Yonekawa, Minoru; Omi, Masao; Takada, Fumiki; Saito, Junichi; Ioka, Ikuo; Miwa, Yukio

KAERI/GP-192/2002, p.157 - 166, 2002/00

no abstracts in English