Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Nakashima, Yosuke*; Takeda, Hisahito*; Ichimura, Kazuya*; Hosoi, Katsuhiro*; Oki, Kensuke*; Sakamoto, Mizuki*; Hirata, Mafumi*; Ichimura, Makoto*; Ikezoe, Ryuya*; Imai, Tsuyoshi*; et al.
Journal of Nuclear Materials, 463, p.537 - 540, 2015/08
Times Cited Count:18 Percentile:82.74(Materials Science, Multidisciplinary)Nakashima, Yosuke*; Sakamoto, Mizuki*; Yoshikawa, Masayuki*; Oki, Kensuke*; Takeda, Hisahito*; Ichimura, Kazuya*; Hosoi, Katsuhiro*; Hirata, Mafumi*; Ichimura, Makoto*; Ikezoe, Ryuya*; et al.
Proceedings of 25th IAEA Fusion Energy Conference (FEC 2014) (CD-ROM), 8 Pages, 2014/10
Fukaya, Masaaki*; Noda, Masaru*; Hata, Koji*; Takeda, Yoshinori*; Akiyoshi, Kenji*; Ishizeki, Yoshikazu*; Kaneda, Tsutomu*; Sato, Shin*; Shibata, Chihoko*; Ueda, Tadashi*; et al.
JAEA-Technology 2014-019, 495 Pages, 2014/08
The researches on engineering technology in the Mizunami Underground Research Laboratory (MIU) plan consists of (1) research on engineering technology deep underground, and (2) research on engineering technology as a basis of geological disposal. The former research is mainly aimed in this study, which is categorized in (a) development of design and construction planning technologies, (b) development of construction technologies, (c) development of countermeasure technologies, and (d) development of technologies for security. In this study, the researches on engineering technology are being conducted in these four categories by using data measured during construction as a part of the second phase of the MIU plan.
Hasegawa, Makoto; Kondo, Hitoshi; Kamei, Gento; Hirano, Fumio; Mihara, Morihiro; Takahashi, Kuniaki; Funabashi, Hideyuki; Kawatsuma, Shinji; Ueda, Hiroyoshi*; Oi, Takao*; et al.
JAEA-Research 2011-003, 47 Pages, 2011/02
In 2009, NUMO and JAEA set up a technical commission to investigate the reasonable TRU waste disposal following a cooperation agreement between these two organizations. In this report, the calculation result of radionuclide transport for a TRU waste geological disposal system was described, by using the TIGER code and the GoldSim code at identical terms. Comparing the calculation result, a big difference was not seen. Therefore, the reliability of both codes was able to be confirmed. Moreover, the influence on the disposal site design (Disposal capacity: 19,000 m) was examined when 10% of the amount of TRU waste increased. As a result, it was confirmed that the influence of the site design was very little based on the concept of the Second Progress Report on Research and Development for TRU Waste Disposal in Japan.
Kawamura, Hideki*; Ando, Kenichi*; Noda, Masaru*; Tanaka, Tatsuya*; Matsuda, Takeshi*; Fujii, Haruhiko*; Hashimoto, Shuji*; Ueda, Tadashi*; Matsui, Hiroya; Takeuchi, Shinji; et al.
JAEA-Technology 2009-081, 182 Pages, 2010/03
Grouting has practical importance for the reduction of groundwater inflow into excavations during construction of underground facilities. Considering the performance assessment of a radioactive waste repository, the performance of the engineered barrier system could be adversely affected by a high pH plume generated from grout. Therefore, a quantitative estimation of the effectiveness of grouting and grout material is essential. This study has been performed in the Mizunami URL being excavated in crystalline rock as a part of the Project for Grouting Technology Development for the Radioactive Waste Repository funded by METI, Japan. The aims were to evaluate the applicability of existing grouting technology and to develop methodology to determine the distribution of grout and change in hydraulic properties of the grouted rock volume. The target rock is the volume of rock around a planned refuge niche where the pre-excavation grouting was performed at 200-m depth from ground surface. After excavation of the refuge niche, ten boreholes were drilled and different kinds of investigations were carried out during and after drilling. The results were integrated and groundwater flow analysis of pre and post excavation grouting conditions were carried out to estimate quantitatively the effect of pre-excavation grouting. The results suggest that current pre-excavation grouting technology is effective for reduction of groundwater inflow into excavations and that hydraulic conductivity of the surrounding rock can be reduced by more than one order of magnitude.
Amano, Hikaru; Yamamichi, Miwako*; Baba, Masami*; Momoshima, Noriyuki*; Sugihara, Shinji*; Ueda, Yusuke*; Nakamura, Yasuhiro*
JAEA-Conf 2008-003, p.84 - 87, 2008/04
no abstracts in English
Asakura, Nobuyuki; Kawashima, Hisato; Shimizu, Katsuhiro; Sakurai, Shinji; Fujita, Takaaki; Takenaga, Hidenobu; Nakano, Tomohide; Kubo, Hirotaka; Higashijima, Satoru; Hayashi, Takao; et al.
Europhysics Conference Abstracts (CD-ROM), 31F, 4 Pages, 2007/00
Divertor design for the JT-60 SA has been progressing in order to handle large heat flux during full pulse duration of 100 s. Divertor should be suitable for single null plasma experiments with the full power injection of 41 MW. The simulation results using 2D fluid (plasma) and Monte-Carlo (neutral) code are summarized. Lower single-null divertor is designed for ITER-like plasma configuration in order to study physics concept of the ITER divertor: control of the plasma detachment. Simulation results for various divertor geometries showed that the vertical target with V-shaped corner can produce plasma detachment near the outer strike-point for medium edge plasma density. It was also demonstrated that the divertor plasma became attached to move the outer strike point above the V-corner, suggesting that recover from sever detachment can be achieved by changing the plasma location. USN divertor will be designed for high- plasma experiments with the highest shaping plasma of S=6.
Sakaki, Hironao; Takahashi, Hiroki; Ishiyama, Tatsuya*; Kawase, Masato; Sako, Hiroyuki; Kato, Yuko; Ito, Yuichi; Yoshikawa, Hiroshi; Ueda, Shinji*; Suzuki, Takahiro*
Proceedings of 3rd Annual Meeting of Particle Accelerator Society of Japan and 31st Linear Accelerator Meeting in Japan (CD-ROM), p.367 - 369, 2006/00
This paper reports Personnel Interlock System, Machine Protection System, and other Interlock System in J-PARC LINAC. The noise measures is important in MPS, we describe the noise decreasing method. The number of accelerating particles in J-PARC LINAC that can be accelerated has been deciding by ministry's guideline. Therefore, it is necessary to do severe surveillance. Here we also explain this particle monitoring instrument.
Ishiyama, Tatsuya*; Yoshikawa, Hiroshi; Sakaki, Hironao; Sako, Hiroyuki; Takahashi, Hiroki; Ito, Yuichi; Kato, Yuko; Kawase, Masato; Ueda, Shinji*; Sugimoto, Makoto*; et al.
Proceedings of 3rd Annual Meeting of Particle Accelerator Society of Japan and 31st Linear Accelerator Meeting in Japan (CD-ROM), p.370 - 372, 2006/00
no abstracts in English
Mohr, P.*; Shizuma, Toshiyuki; Ueda, Hiroyasu*; Goko, Shinji*; Makinaga, Ayano*; Hara, Kaoru*; Hayakawa, Takehito; Lui, Y.-W.*; Ogaki, Hideaki*; Utsunomiya, Hiroaki*
Physical Review C, 69(3), p.032801_1 - 032801_4, 2004/03
Times Cited Count:33 Percentile:84.6(Physics, Nuclear)The neutron capture cross section of the unstable s-process branching nucleus W has been derived from experimental data of the inverse W(,n)W photodisintegration taken with monochromatic photon beams from laser Compton scattering. The result of mb at keV leads to a relatively high effective neutron density in the classical s process of . A realistic model for the s process in thermally pulsing AGB stars overestimates the abundance of Os significantly because of the relatively small neutron capture cross section of W.
Tamai, Hiroshi; Matsukawa, Makoto; Kurita, Genichi; Hayashi, Nobuhiko; Urata, Kazuhiro*; Miura, Yushi; Kizu, Kaname; Tsuchiya, Katsuhiko; Morioka, Atsuhiko; Kudo, Yusuke; et al.
Plasma Science and Technology, 6(1), p.2141 - 2150, 2004/02
Times Cited Count:2 Percentile:6.52(Physics, Fluids & Plasmas)The dominant issue for the the modification program of JT-60 (JT-60SC) is to demonstrate the steady state reactor relevant plasma operation. Physics design on plasma parameters, operation scenarios, and the plasma control method are investigated for the achievement of high-. Engineering design and the R&D on the superconducting magnet coils, radiation shield, and vacuum vessel are performed. Recent progress in such physics and technology developments is presented.
Sakaki, Hironao; Nakamura, Naoki*; Yoshikawa, Hiroshi; Ueda, Shinji*
Proceedings of 28th Linear Accelerator Meeting in Japan, p.467 - 469, 2003/08
no abstracts in English
Seki, Masahiro; ; Matsuda, Shinzaburo; *; *; *; Nishi, Masataka; *; Tokuda, Shinji; *; et al.
Denki Gakkai Gijutsu Hokoku, 0(613), 102 Pages, 1996/00
no abstracts in English
Sato, Junya; Suzuki, Shinji*; Kato, Jun; Sakakibara, Tetsuro; Nakazawa, Osamu; Meguro, Yoshihiro; Ueda, Hiroshi*; Kurosaki, Fumio*; Yoneyama, Takashi*; Matsukura, Minoru*; et al.
no journal, ,
no abstracts in English