Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Schroer, C.*; Voss, Z.*; Wedemeyer, O.*; Novotny, J.*; Konys, J.*; Heinzel, A.*; Weisenburger, A.*; Mller, G.*; Furukawa, Tomohiro; Aoto, Kazumi
JNC TY9400 2005-020, 45 Pages, 2005/08
This report summarises the results of exposure experiments on the behaviour of 12Cr-2W steel P122 and an 9Cr-2W ODS-steel in oxygen-containing flowing lead-bismuth eutectic (LBE) at 550C, which were performed in the CORRIDA loop at the Karlsruhe Lead Laboratory (KALLA) as part of the collaboration between the Japan Nuclear Cycle Development Institute and the Karlsruhe Research Centre. The duration of these experiments was nominally 800, 2000, 5000 and 10,000 h. Both steels were tested after surface-finishing by turning and after surface alloying with aluminium in the GESA-facility. Owing to initial problems with the enrichment of oxygen in the flowing LBE, the oxygen content considerably varied during most of these experiments, so that the influence of temporary changes in the oxygen content of the LBE could also be investigated. The behaviour of P122 and ODS at permanently high oxygen content was deduced from an experiment for 4990 h at 550C and (c 510 mass-% or a 10). The results are compared with the findings of exposures to stagnant LBE at 550C and c=10 mass-% (COSTA-experiments).
Schroer, C.*; Voss, Z.*; Wedemeyer, O.*; Novotny, J.*; Konys, J.*; Heinzel, A.*; Weisenburger, A.*; Mller, G.*; Furukawa, Tomohiro; Aoto, Kazumi
JNC TY9400 2005-019, 26 Pages, 2005/08
This report summarises the results of exposure experiments on the behaviour of 12Cr-2W steel P122 joined by multi-run TIG welding in oxygen-containing flowing lead-bismuth eutectic (LBE) at 550C for nominally 800, 2000 and 5000 h. The flow velocity of the LBE and the mean oxygen content were 2 m/s and 510-7 mass-% (aPbO = 10-3), respectively. The influence of surface-alloying with aluminium (GESA-treatment) was also investigated in an exposure experiment for nominally 5000 h. The behaviour of the welded joint is generally comparable to that of P122 (after the standard heat-treatment), both qualitatively and quantitatively. Only few exceptions were observed which probably result from local peculiarities of the specific sample material. After surface alloying with aluminium, no significant oxidation and no liquid metal corrosion occurred in the centre of the specimens (including the weld seam), where the desired high quality of the aluminised layer was achieved.