Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Al cable-in-conduit conductorKoizumi, Norikiyo; Matsui, Kunihiro; Kume, Etsuo; Okuno, Kiyoshi
IEEE Transactions on Applied Superconductivity, 15(2), p.1363 - 1366, 2005/06
Times Cited Count：0 Percentile：0(Engineering, Electrical & Electronic)The NbAl Insert was developed by JAERI aiming at the demonstration of a NbAl conductor to fusion reactor magnets. A quench test was performed on the NbAl Insert at 13 T with various temperature margins, which are defined as a difference between current sharing temperature and operating temperature. The initial normalcy was initiated by using an inductive heater and a coil current was kept for several seconds. The normal zone propagation velocity was accelerated after 3 s from the onset of heating in case that the temperature margin was set at 0.5 K. A simulation using one-dimensional stability and quench simulation code was performed. The calculation results indicate that such rapid propagation occurred due to a temperature rise beyond a current sharing temperature because of a large pressure increase even at the location where the normal front did not reach yet. This large pressure rise was caused since the coolant was contained in the closed circulation circuit of the cooling system, which is usually applied to a large magnet cooling system.
Takahashi, Yoshikazu; Yoshida, Kiyoshi; Mitchell, N.*
IEEE Transactions on Applied Superconductivity, 15(2), p.1395 - 1398, 2005/06
Times Cited Count：8 Percentile：43.62(Engineering, Electrical & Electronic)The quench detection is important and necessary for the coil protection. The voltage tape method and the flow meter method are both considered for the ITER Central Solenoid (CS). The voltage tap method is primary due to its quick response. The CS consists of six pancake wound modules, which are operated with individual operating current patterns in ac mode. The induced voltage in the windings must be compensated to detect the voltage due to any normal transition during pulse operation. We have investigated the optimum configuration for pick-up coils (PC) for compensation. The results of simulations show that the compensated voltages are very low (70 mV) compared with the inductive voltage and adequate normal voltage sensitivity is obtained. The hot spot temperature in the CS during the operation was estimated from the simulation and the experimental data of the CSMC quench. The hot spot temperature estimated is about 144 K, lower than the ITER design criterion (150 K). It is shown that the detection system using the PCs could be designed with a high enough detection sensitivity.
