Ultrasonic analysis of columnar crystal propagation echo in acoustically anisotropic weld metals; Targeting intergranular cracking of stainless-steel piping in pressurized water reactor primary system "FY2024 Nuclear Regulation Research Technology Infrastructure Construction Project Subsidy 'The Grant to Establish Technology Bases for Enhancement of Nuclear Regulation Research'"

Matsui, Tetsuya; Shimodaira, Masaki; Yamaguchi, Yoshihito; Toyama, Takeshi; Katsuyama, Jinya

JAEA-Research 2025-017, 41 Pages, 2026/03

JAEA-Research-2025-017.pdf:4.52MB

The JAEA Safety Research Center has been conducting fundamental research on advanced inspection and structural integrity assessment technologies since FY2024, including the development of a machine-learning-based ultrasonic flaw detection method using an ultrasonic simulator. To assess the simulator's applicability, phased array ultrasonic testing (PAUT) results produced by the simulator were compared with actual measurement data. Due to limited publicly available datasets, an intergranular crack in the pressurizer spray line piping of Kansai Electric Power Co. Inc.'s Ohi Nuclear Power Station Unit 3 was selected as the reference case. PAUT linear scanning analysis at a 45 incident angle detected the crack's corner and edge echoes. Strong columnar-crystal propagation echoes were also observed within the weld metal, with their intensity showing dependence on the symmetric axis angle. Analysis at a 31 incident angle similarly identified strong columnar-crystal propagation echoes, which connected to the crack's corner echoes and propagated into the weld region. These results align with actual measurements, indicating that the observed weld-metal echoes are likely attributable to columnar-crystal propagation.

Development of a high-resolution imaging camera for alpha dust and high-dose rate monitor (Contract research); FY2023 Nuclear Energy Science & Technology and Human Resource Development Project

Collaborative Laboratories for Advanced Decommissioning Science; Tohoku University*

JAEA-Review 2025-048, 56 Pages, 2026/02

JAEA-Review-2025-048.pdf:2.89MB

The Collaborative Laboratories for Advanced Decommissioning Science (CLADS), Japan Atomic Energy Agency (JAEA), had been conducting the Nuclear Energy Science & Technology and Human Resource Development Project (hereafter referred to "the Project") in FY2023. The Project aims to contribute to solving problems in the nuclear energy field represented by the decommissioning of the Fukushima Daiichi Nuclear Power Station, Tokyo Electric Power Company Holdings, Inc. (TEPCO). For this purpose, intelligence was collected from all over the world, and basic research and human resource development were promoted by closely integrating/collaborating knowledge and experiences in various fields beyond the barrier of conventional organizations and research fields. The sponsor of the Project was moved from the Ministry of Education, Culture, Sports, Science and Technology to JAEA since the newly adopted proposals in FY2018. On this occasion, JAEA constructed a new research system where JAEA-academia collaboration is reinforced and medium-to-long term research/development and human resource development contributing to the decommissioning are stably and consecutively implemented. Among the adopted proposals in FY2022, this report summarizes the research results of the "Development of a high-resolution imaging camera for alpha dust and high-dose rate monitor" conducted in FY2023. The present study aims to develop a high-resolution imaging camera for alpha dust and a high-dose rate monitor. To realize the high-resolution imaging camera for alpha dust, we have developed novel scintillation materials with emission bands of 500-800 nm. Moreover, we have prepared several materials for the camera and software. We have also developed novel scintillation materials with emission bands of 650-1,000 nm, and simulation studies have been conducted for the high-dose-rate monitor system consisting of optical fiber. In addition, we demonstrated this monitoring system, and the dose-rate dynamic range was found to be 20 mSv/h to 1 kSv/h.

Feasibility study of machine learning-based discrimination of , and particles from grayscale radiation images

Laffolley, H.; Tsubota, Yoichi; Tsuji, Tomoya; Honda, Fumiya

Nuclear Instruments and Methods in Physics Research A, 1082(Part 2), p.171029_1 - 171029_11, 2026/02

https://doi.org/10.1016/j.nima.2025.171029

In the framework of the decommissioning of the Fukushima Daiichi Nuclear Power Station, the Japan Atomic Energy Agency analyses and classifies a variety of radioactive samples. The objective is to simplify the sample characterization process by developing multipurpose analysis tools that quickly produce results for different types of samples while reducing labor. The development of an analytical device has been started, based on the MiniPIX TPX standard detector, a hybrid semiconductor pixelated radiation detector. This detector creates grayscale images that show the interaction of ionizing particles, where brightness directly indicates energy. The final aim is to build a fast mapping device that generates 2D activity maps, distinguishing between , , and radiation, and includes simple local spectrometry for highly contaminated samples. The shape of the cluster created by the interaction between an incident particle and the semiconductor is typical of the said particle. Thus, eight supervised machine learning models have been trained on a dataset made of 9 features extracted from pure images of , and particles collected from Co, Sr, Cs and Am standard sources. The best models can distinguish the particles with nearly 80% accuracy, reaching 96% accuracy for low-energy rays exposition only, with a processing time of a few microseconds per frame. The identification of particles is 100% accurate.

Development of elemental technologies of hand-foot-cloth monitors for -contamination visualization (Contract research); FY2023 Nuclear Energy Science & Technology and Human Resource Development Project

Collaborative Laboratories for Advanced Decommissioning Science; Hokkaido University*

JAEA-Review 2025-021, 63 Pages, 2025/10

JAEA-Review-2025-021.pdf:5.71MB

The Collaborative Laboratories for Advanced Decommissioning Science (CLADS), Japan Atomic Energy Agency (JAEA), had been conducting the Nuclear Energy Science & Technology and Human Resource Development Project (hereafter referred to "the Project") in FY2023. The Project aims to contribute to solving problems in the nuclear energy field represented by the decommissioning of the Fukushima Daiichi Nuclear Power Station, Tokyo Electric Power Company Holdings, Inc. (TEPCO). For this purpose, intelligence was collected from all over the world, and basic research and human resource development were promoted by closely integrating/collaborating knowledge and experiences in various fields beyond the barrier of conventional organizations and research fields. The sponsor of the Project was moved from the Ministry of Education, Culture, Sports, Science and Technology to JAEA since the newly adopted proposals in FY2018. On this occasion, JAEA constructed a new research system where JAEA-academia collaboration is reinforced and medium-to-long term research/development and human resource development contributing to the decommissioning are stably and consecutively implemented. Among the adopted proposals in FY2022, this report summarizes the research results of the "Development of elemental technologies of hand-foot-cloth monitors for -contamination visualization" conducted in FY2023. The present study aims to develop hand-foot-monitors for -contamination visualization and cloth monitors for /-contamination visualization consisting of a portable phoswich detector. ZnS(Ag) thick films by AD method and rare earth complexes have been studied for development of -ray scintillator materials. The scintillator properties of the newly prepared ZnS(Ag) thick films were improved from those prepared in 2022. A rare earth complex shows strong emission intensity under -ray irradiation, which was 12.5 times higher than that of a commercially available plastic scintillator (Saint-Gobain, BC400). By optimizing the manufacturing process conditions (molding die, sintering conditions, cutting process, annealing conditions, grinding/polishing processes) for La-GPS polycrystalline thin plates, the preparing process for 50 mm square La-GPS was established. The prepared La-GPS provided excellent performance for -ray scintillators. The cloth monitors for /-contamination visualization were also improved for the reflection of the actual situation. Furthermore, the basic performance of the prototype cloth monitors was evaluated, and alpha-ray energy and position distribution information were obtained. In an evaluation test of the phoswich detector, a precise discrimination between - and -rays was achieved.

Improvement of aerosol time-of-flight mass spectrometer for on-line measurement of tiny particles containing alpha emitters (Contract research); FY2023 Nuclear Energy Science & Technology and Human Resource Development Project

Collaborative Laboratories for Advanced Decommissioning Science; Osaka University*

JAEA-Review 2025-019, 95 Pages, 2025/09

JAEA-Review-2025-019.pdf:9.49MB

The Collaborative Laboratories for Advanced Decommissioning Science (CLADS), Japan Atomic Energy Agency (JAEA), had been conducting the Nuclear Energy Science & Technology and Human Resource Development Project (hereafter referred to "the Project") in FY2023. The Project aims to contribute to solving problems in the nuclear energy field represented by the decommissioning of the Fukushima Daiichi Nuclear Power Station (1F), Tokyo Electric Power Company Holdings, Inc. (TEPCO). For this purpose, intelligence was collected from all over the world, and basic research and human resource development were promoted by closely integrating/collaborating knowledge and experiences in various fields beyond the barrier of conventional organizations and research fields. The sponsor of the Project was moved from the Ministry of Education, Culture, Sports, Science and Technology to JAEA since the newly adopted proposals in FY2018. On this occasion, JAEA constructed a new research system where JAEA-academia collaboration is reinforced and medium-to-long term research/development and human resource development contributing to the decommissioning are stably and consecutively implemented. Among the adopted proposals in FY2021, this report summarizes the research results of the "Improvement of aerosol time-of-flight mass spectrometer for on-line measurement of tiny particles containing alpha emitters" conducted from FY2021 to FY2023. The present study aims to improve Aerosol Time-Of-Flight Mass Spectrometer (ATOFMS) in order to monitor tiny particles containing alpha emitters such as U and Pu which were generated in removing debris from the reactors of 1F. We newly fabricated the improved ATOFMS quipped with a reflectron and carried out measurements for modeled tiny particles containing U. In obtained TOF spectra, ion peaks were observed for Zr, U, and their oxides as well as Zr and U. Mass resolution of the ion peak of U+ was 1,700, which demonstrates that the improved ATOFMS has sufficient mass resolution to distinguish Pu from U. In the development of the apparatus for preparing enriched and enlarged particles, we fabricated the apparatus consisting of PILS, a volume reduction tube, a supersonic atomizer, and an online dryer, and optimized apparatus conditions. In the optimized conditions, enlarged particles with size between 0.4 m and 0.8 m which are detectable with ATOFMS were dominantly produced. By analyzing the enlarged particles, these were produced by taking component elements of the apparatuses used in the enlarged process. The efficiency was evaluated to be 4.5 times. From these developments, the detection concentration limits of the apparatus were evaluated to be 7.010, 4.210, and 1.310 Bq/cm for U, U, and Pu, respectively. These values are below the air concentration limit.

Grain refinement of dual phase steel maximizes deformation ability of martensite, leading to simultaneous enhancement of strength and ductility

Park, M.-H.*; Shibata, Akinobu*; Harjo, S.; Tsuji, Nobuhiro*

Acta Materialia, 292, p.121061_1 - 121061_13, 2025/06

https://doi.org/10.1016/j.actamat.2025.121061

Experimental investigation of phase transformations in steel using X-ray and neutron diffraction

Tomota, Yo*; Harjo, S.; Xu, P. G.; Morooka, Satoshi; Gong, W.; Wang, Y.*

Metals, 15(6), p.610_1 - 610_19, 2025/05

https://doi.org/10.3390/met15060610

Reduction and phase transformation of Ce-doped zirconolites

Hayashizaki, Kohei; Hirooka, Shun; Yamada, Tadahisa*; Sunaoshi, Takeo*; Murakami, Tatsutoshi; Saito, Kosuke

Ceramics (Internet), 8(1), p.24_1 - 24_12, 2025/03

https://doi.org/10.3390/ceramics8010024

Stress and plastic strain partitioning behaviors and those contributions to martensitic transformation of retained austenite in medium manganese and transformation-induced plasticity-aided bainitic ferrite steels

Hojo, Tomohiko*; Koyama, Motomichi*; Kumai, Bakuya*; Zhou, Y.*; Shibayama, Yuki; Shiro, Ayumi*; Shobu, Takahisa; Saito, Hiroyuki*; Ajita, Saya*; Akiyama, Eiji*

ISIJ International, 65(2), p.284 - 296, 2025/02

https://doi.org/10.2355/isijinternational.ISIJINT-2024-268

Development of a high-resolution imaging camera for alpha dust and high-dose rate monitor (Contract research); FY2022 Nuclear Energy Science & Technology and Human Resource Development Project

Collaborative Laboratories for Advanced Decommissioning Science; Tohoku University*

JAEA-Review 2024-016, 61 Pages, 2024/12

JAEA-Review-2024-016.pdf:2.88MB

The Collaborative Laboratories for Advanced Decommissioning Science (CLADS), Japan Atomic Energy Agency (JAEA), had been conducting the Nuclear Energy Science & Technology and Human Resource Development Project (hereafter referred to "the Project") in FY2022. The Project aims to contribute to solving problems in the nuclear energy field represented by the decommissioning of the Fukushima Daiichi Nuclear Power Station, Tokyo Electric Power Company Holdings, Inc. (TEPCO). For this purpose, intelligence was collected from all over the world, and basic research and human resource development were promoted by closely integrating/collaborating knowledge and experiences in various fields beyond the barrier of conventional organizations and research fields. The sponsor of the Project was moved from the Ministry of Education, Culture, Sports, Science and Technology to JAEA since the newly adopted proposals in FY2018. On this occasion, JAEA constructed a new research system where JAEA-academia collaboration is reinforced and medium-to-long term research/development and human resource development contributing to the decommissioning are stably and consecutively implemented. Among the adopted proposals in FY2022, this report summarizes the research results of the "Development of a high-resolution imaging camera for alpha dust and high-dose rate monitor" conducted in FY2022. The present study aims to develop a high-resolution imaging camera for alpha dust and a high-dose rate monitor. To realize the high-resolution imaging camera for alpha dust, we have developed novel scintillation materials with emission bands of 500-800 nm. Moreover, we have prepared several materials for the camera and software. We have also developed novel scintillation materials with emission bands of 650-1,000 nm, and simulation studies have been conducted for the high-dose-rate monitor system consisting of optical fiber.