Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Maekawa, Yasunari; Koshikawa, Hiroshi; Yoshida, Masaru
Polymer, 45(7), p.2291 - 2295, 2004/03
Times Cited Count：8 Percentile：27.78(Polymer Science)Ion track membranes of poly(ethylene terephthalate) (PET) are applied to the production of anisotropically conducting films possessing copper wires of less than sub-micron in diameter. The membranes possessing cylindrical pores of 1.9 
m and 200 nm in diameter were prepared by irradiation of 
Xe
ion beams followed by etching in an aqueous NaOH. Copper wires were deposited into the pores by electrochemical plating in aqueous copper sulfate solution to prepare the PET/Cu hybrid membranes. The copper wires with 1.9 m in diameter showed wavelike surface roughness, resulting from the roughness of the pore side wall, whereas the copper wires with 200 nm in diameter showed smooth surfaces. The resistances of the membranes measured by a four terminal resistance method are in good agreement with the calculated values, indicating that the hybrid membranes possess conductivity perpendicular to the membrane surfaces but not parallel to the surfaces.
Nemoto, Yoshiyuki; Miwa, Yukio; Kikuchi, Masahiko; Kaji, Yoshiyuki; Tsukada, Takashi; Tsuji, Hirokazu
Journal of Nuclear Science and Technology, 39(9), p.996 - 1001, 2002/09
Times Cited Count：6 Percentile：38.62(Nuclear Science & Technology)Surface morphology of oxidized stainless steel was evaluated using atomic force microscope (AFM) and scanning electron microscope (FE-SEM). Cross-sectional morphology of oxide layer on the specimens was evaluated using FE-SEM after fabrication. Focused ion beam (FIB) technique was applied to fabricate thin film samples of oxide films, which were used for microstructure observation by transmission electron microscope (FE-TEM), and microscopic chemical analysis by energy dispersed X-ray spectrometer (EDS). These preparations and observations were successful, and microstructure and chemical composition of oxide films were evaluated on nanometer scale. Effects of silicon (Si) doping and dissolved oxygen (DO) content in water for oxide layer formation are discussed.
Koshikawa, Hiroshi; Yamamoto, Shunya; Sugimoto, Masaki; Kitamura, Akane; Sawada, Shinichi; Yamaki, Tetsuya
no journal, ,
Chemical etching of polymer films irradiated with heavy ions leads to the formation of ion-track membranes with nanoscale pores in different shapes. Particularly, conically-shaped pores are expected to have a potential to create metallic nanoneedles by combination of vapor-deposition and electroplating methods. In this study, we prepared copper nanoneedles inside the conical pores of polyimide (PI)-based ion-track membranes and investigated their morphology. The PI films were irradiated with 
Ar ions. The irradiated films were etched in a sodium hypochlorite solution at 60
C for 0.5 h, leading to the formation of conical pores with a surface diameter of ca. 500 nm. A very thin Au layer was deposited on this pore side of the ion-track membranes; then, it was used as a cathode for electroplating copper into the pores. After dissolving the PI templates, we obtained the copper needles ca. 500 nm in base diameter and 1.2 m in height on copper plates.
