Structural investigation of borosilicate glasses by using XAFS measurement in soft X-ray region, 3 (Joint research)

Nagai, Takayuki; Okamoto, Yoshihiro; Yamagishi, Hirona*; Shibata, Daisuke*; Kojima, Kazuo*; Hasegawa, Takehiko*; Sato, Seiichi*; Fukaya, Akane*; Hatakeyama, Kiyoshi*

JAEA-Research 2023-004, 45 Pages, 2023/09

JAEA-Research-2023-004.pdf:6.07MB

The local structure of glass-forming elements and waste elements in borosilicate glasses varies with its chemical composition. In this study, simulated waste glass samples were prepared and the chemical state regarding boron (B), silicon (Si) and waste elements of iron (Fe), cesium (Cs) were estimated by using XAFS measurement in soft X-ray region. To understand the chemical stability of simulated waste glasses, XANES spectra of B K-edge, Fe L, L-edge, and Cs M, M-edge were measured on the glass surface exposed to the leachate. As a result, it was found that the glass surface exposed to the leachate was changed and it was difficult to obtain a clear XANES spectrum. From the B K-edge XANES spectra on glass surfaces exposed to the leachate, an increase in three-coordination of B-O (BO) and a decrease in four-coordination of B-O (BO) were observed compared to the glass surfaces before immersion. The XANES spectra of Fe L, L-edge, and Cs M, M-edge show that as the exposure time in the leachate increases, the Cs present on the glass surface dissolves into the leachate. The XANES spectra of Si K-edge were measured on simulated waste glass surfaces before immersion, and it was confirmed that the change in XANES spectra given by NaO concentration had a larger effect than the waste component concentration.

Structural investigation of borosilicate glasses by using XAFS measurement in soft X-ray region, 2 (Joint research)

Nagai, Takayuki; Okamoto, Yoshihiro; Yamagishi, Hirona*; Kojima, Kazuo*; Inose, Takehiko*; Sato, Seiichi*; Hatakeyama, Kiyoshi*

JAEA-Research 2022-008, 37 Pages, 2022/10

JAEA-Research-2022-008.pdf:5.27MB

The local structure of glass-forming elements and waste elements in borosilicate glasses varies with its chemical composition. In this study, borosilicate glass frit and simulated waste glass samples were prepared and the chemical state regarding boron (B), silicon (Si) and waste elements of iron (Fe), cesium (Cs) were estimated by using XAFS measurement in soft X-ray region. Following results were obtained by XAFS measurements of simulated waste glass surfaces after immersion test to investigate the long chemical stability. (1) As the leaching time of glass samples in immersion test passed, the Cs M, M-edge XANES spectra disappeared and the Fe L, L-edge spectra changed. (2) A new compound was formed on the sample surface after the immersion test, and these changes in the surface state were confirmed by Raman spectroscopy. However, it became difficult to obtain a clear B K-edge XANES spectrum by forming a compound on glass surfaces. The Si K-edge XANES spectra of borosilicate glass frits with different NaO content were measured, and following was confirmed. (1) As the NaO concentration increases in borosilicate glass frit, the K-edge peak of Si shifts to the low energy side. (2) The intensity of the Si K-edge peak is maximum when the NaO content in glass frits was about 7wt%.

PSTEP: Project for solar-terrestrial environment prediction

Kusano, Kanya*; Ichimoto, Kiyoshi*; Ishii, Mamoru*; Miyoshi, Yoshizumi*; Yoden, Shigeo*; Akiyoshi, Hideharu*; Asai, Ayumi*; Ebihara, Yusuke*; Fujiwara, Hitoshi*; Goto, Tadanori*; et al.

Earth, Planets and Space (Internet), 73(1), p.159_1 - 159_29, 2021/12

https://doi.org/10.1186/s40623-021-01486-1

The PSTEP is a nationwide research collaboration in Japan and was conducted from April 2015 to March 2020, supported by a Grant-in-Aid for Scientific Research on Innovative Areas from the Ministry of Education, Culture, Sports, Science and Technology of Japan. It has made a significant progress in space weather research and operational forecasts, publishing over 500 refereed journal papers and organizing four international symposiums, various workshops and seminars, and summer school for graduate students at Rikubetsu in 2017. This paper is a summary report of the PSTEP and describes the major research achievements it produced.

Measurements of displacement cross section of tungsten under 389-MeV proton irradiation and thermal damage recovery

Iwamoto, Yosuke; Yoshida, Makoto*; Matsuda, Hiroki; Meigo, Shinichiro; Satoh, Daiki; Yashima, Hiroshi*; Yabuuchi, Atsushi*; Shima, Tatsushi*

Materials Science Forum, 1024, p.95 - 101, 2021/03

https://doi.org/10.4028/www.scientific.net/MSF.1024.95

To predict the lifetime of target materials in high-energy radiation environments at spallation neutron sources, radiation transport codes such as PHITS are used to calculate the displacements per atom (DPA) value. In this work, to validate calculated DPA values of tungsten, we implemented 0.25-mm-diameter wire sample of tungsten in a proton irradiation device with a Gifford-McMahon cryocooler and measured the defect-induced electrical resistivity changes related to the displacement cross section using 389-MeV protons at 10 K. As well as our previous results for aluminum and copper, calculated results with defect production efficiencies provided good agreements with experimental data. Based on measurements of recovery of the defects through annealing, about 85% of the damage remained at 60 K, and the same tendency is observed in other experimental result for reactor neutron irradiation.

High temperature gas-cooled reactors

Takeda, Tetsuaki*; Inagaki, Yoshiyuki; Aihara, Jun; Aoki, Takeshi; Fujiwara, Yusuke; Fukaya, Yuji; Goto, Minoru; Ho, H. Q.; Iigaki, Kazuhiko; Imai, Yoshiyuki; et al.

High Temperature Gas-Cooled Reactors; JSME Series in Thermal and Nuclear Power Generation, Vol.5, 464 Pages, 2021/02

https://doi.org/10.1016/C2018-0-05383-9

As a general overview of the research and development of a High Temperature Gas-cooled Reactor (HTGR) in JAEA, this book describes the achievements by the High Temperature Engineering Test Reactor (HTTR) on the designs, key component technologies such as fuel, reactor internals, high temperature components, etc., and operational experience such as rise-to-power tests, high temperature operation at 950C, safety demonstration tests, etc. In addition, based on the knowledge of the HTTR, the development of designs and component technologies such as high performance fuel, helium gas turbine and hydrogen production by IS process for commercial HTGRs are described. These results are very useful for the future development of HTGRs. This book is published as one of a series of technical books on fossil fuel and nuclear energy systems by the Power Energy Systems Division of the Japan Society of Mechanical Engineers.

Two-step-pressurization method in pulsed electric current sintering of MoO for production of Tc radioactive isotope

Suematsu, Hisayuki*; Sato, Soma*; Nakayama, Tadachika*; Suzuki, Tatsuya*; Niihara, Koichi*; Nanko, Makoto*; Tsuchiya, Kunihiko

Journal of Asian Ceramic Societies (Internet), 8(4), p.1154 - 1161, 2020/12

https://doi.org/10.1080/21870764.2020.1824326

Pulsed electric current sintering of molybdenum trioxide (MoO) was carried out by one- and two-step pressuring methods for fabrication of irradiation target using production of Mo and Tc nuclear medicine. At 550C by the two-step pressurizing method, a relative density of 93.1% was obtained while, by the one-step pressurization method, the relative density was 76.9%. Direct sample temperature measurements were conducted by inserting a thermocouple in a punch. By the two-step pressurizing method, the sample temperature was higher than that by the one-step pressurizing method even almost the same die temperature. From voltage and current waveforms, it was thought that the conductivity of the sample increased by the two-step pressurizing method to increase the sample temperature and the relative density. The two-step pressurization method enables us to prepare dense targets at a low temperature from recycled and coarse-grained Mo enriched MoO powder.

Structural investigation of simulated waste glass samples by using XAFS measurement in soft X-ray region (Joint research)

Nagai, Takayuki; Okamoto, Yoshihiro; Yamagishi, Hirona*; Ota, Toshiaki*; Kojima, Kazuo*; Inose, Takehiko*; Sato, Seiichi*; Hatakeyama, Kiyoshi*

JAEA-Research 2020-009, 48 Pages, 2020/09

JAEA-Research-2020-009.pdf:4.53MB

The local structure of glass-forming elements and waste elements in waste glass varies with its chemical composition. In this study, borosilicate glass frit and simulated waste glass samples were prepared and the local structure and chemical state regarding boron (B), oxygen (O), and waste elements of cerium (Ce), cesium (Cs) were estimated by using XAFS measurement in soft X-ray region. Following results were obtained by XAFS measurements of prepared glass frit and simulated waste glass samples: (1) The existence ratio of four coordinate sp structure (BO) tends to increase with increasing NaO content in glass samples. (2) The height of a pre-edge which appears by K-edge XANES spectrum of O is so high that the Fe content in glass samples. Following results were obtained by XAFS measurements of simulated waste glass samples after immersion test to investigate long chemical stability. (1) The existence ratio of four coordinate sp structure (BO) increases by immersion test. (2) Ce which exists in the surface layer is oxidized by immersion test, and much of Cs in surface layer is lost after leach testing. Even if the glass frit form (fiber cartridge or beads) and manufacturing method were changed and a glass sample of the similar chemical composition was prepared, these observed Raman spectra of samples were different.

Measurement of defect-induced electrical resistivity change of tungsten wire at cryogenic temperature using high-energy proton irradiation

Iwamoto, Yosuke; Yoshida, Makoto*; Matsuda, Hiroki; Meigo, Shinichiro; Satoh, Daiki; Yashima, Hiroshi*; Yabuuchi, Atsushi*; Kinomura, Atsushi*; Shima, Tatsushi*

JPS Conference Proceedings (Internet), 28, p.061003_1 - 061003_5, 2020/02

https://doi.org/10.7566/JPSCP.28.061003

To predict the lifetime of target materials in high-energy radiation environments at spallation neutron sources, radiation transport codes such as PHITS are used to calculate the displacements per atom (DPA) value. In this work, to validate calculated DPA values of tungsten, we implemented 0.25-mm-diameter wire sample of tungsten in a proton irradiation device with a Gifford-McMahon cryocooler and measured the defect-induced electrical resistivity changes related to the displacement cross section using 389-MeV protons at 10 K. In comparison with experimental data under 1.1 and 1.9 GeV proton irradiation, we found that damage rate of tungsten increases with proton energy due to increase the number of secondary particle s produced by nuclear reactions.

Investigation of simulated waste glass samples prepared from borosilicate glass frit including vanadium

Nagai, Takayuki; Okamoto, Yoshihiro; Shiwaku, Hideaki; Inose, Takehiko*; Sato, Seiichi*; Hatakeyama, Kiyoshi*; Hirono, Kazuya*; Homma, Masanobu*; Kobayashi, Hiromi*; Takahashi, Tomoe*; et al.

JAEA-Research 2018-007, 87 Pages, 2018/11

JAEA-Research-2018-007.pdf:61.21MB

To select the chemical composition of a glass frit which can increase the waste content, the simulated waste glass samples prepared from a borosilicate glass frit including vanadium (V) were investigated by using Laser Ablation (LA) ICP-AES analysis, Raman spectrometry, and synchrotron XAFS measurement in this study on foundation business of the Agency for Natural Resources and Energy.

Radiocesium distribution in aggregate-size fractions of cropland and forest soils affected by the Fukushima nuclear accident

Koarashi, Jun; Nishimura, Shusaku; Atarashi-Andoh, Mariko; Matsunaga, Takeshi*; Sato, Tsutomu*; Nagao, Seiya*

Chemosphere, 205, p.147 - 155, 2018/08

https://doi.org/10.1016/j.chemosphere.2018.04.092

There is little understanding of how soil aggregation can affect the mobility and bioavailability of Cs in soils. To explore this, soil samples were collected at seven sites under different land-use conditions in Fukushima and were separated into four aggregate-size fractions. The fractions were then analyzed for Cs content and extractability and mineral composition. In forest soils, aggregate formation was significant, and Cs was largely associated with large-sized aggregates. In contrast, there was less aggregation in agricultural field soils, and most of Cs was in the clay- and silt-sized fractions. Across all sites, the Cs extractability was higher in the large-sized aggregate fractions than in the clay-sized fractions. The results demonstrate that large-sized aggregates are a significant reservoir of potentially mobile and bioavailable Cs in organic-rich (forest and orchard) soils.