Sodium-cooled Fast Reactors

Ohshima, Hiroyuki; Morishita, Masaki*; Aizawa, Kosuke; Ando, Masanori; Ashida, Takashi; Chikazawa, Yoshitaka; Doda, Norihiro; Enuma, Yasuhiro; Ezure, Toshiki; Fukano, Yoshitaka; et al.

Sodium-cooled Fast Reactors; JSME Series in Thermal and Nuclear Power Generation, Vol.3, 631 Pages, 2022/07

https://shop.elsevier.com/books/sodium-cooled-fast-reactors/morishita/978-0-12-824076-2

This book is a collection of the past experience of design, construction, and operation of two reactors, the latest knowledge and technology for SFR designs, and the future prospects of SFR development in Japan. It is intended to provide the perspective and the relevant knowledge to enable readers to become more familiar with SFR technology.

Distinct variation of electronic states due to annealing in -type LaEuCuO and NdCuO

Asano, Shun*; Ishii, Kenji*; Matsumura, Daiju; Tsuji, Takuya; Kudo, Kota*; Taniguchi, Takanori*; Saito, Shin*; Sunohara, Toshiki*; Kawamata, Takayuki*; Koike, Yoji*; et al.

Physical Review B, 104(21), p.214504_1 - 214504_7, 2021/12

https://doi.org/10.1103/PhysRevB.104.214504

Poro-elastic parameter acquisition test using siliceous mudstone (Wakkanai formation)

Aoki, Tomoyuki*; Tani, Takuya*; Sakai, Kazuo*; Koga, Yoshihisa*; Aoyagi, Kazuhei; Ishii, Eiichi

JAEA-Research 2020-002, 83 Pages, 2020/06

JAEA-Research-2020-002.pdf:8.25MB
JAEA-Research-2020-002-appendix(CD-ROM).zip:6.63MB

The Japan Atomic Energy Agency (JAEA) has conducted with the Horonobe Underground Research Project in Horonobe, Teshio-gun, Hokkaido for the purpose of research and development related to geological disposal technology for high-level radioactive wastes in sedimentary soft rocks. The geology around the Horonobe Underground Research Laboratory (HURL) is composed of the Koetoi diatomaceous mudstone layer and the Wakkanai siliceous layer, both of which contain a large amount of diatom fossils. Since these rocks exhibit relatively high porosity but low permeability, it is important to investigate the poro-elastic characteristics of the rock mass. For this objective, it is necessary to measure parameters based on the poro-elastic theory. However, there are few measurement results of the poro-elastic parameters for the geology around HURL, and the characteristics such as dependence on confining pressure are not clearly understood. One of the reasons is that the rocks show low permeability and the pressure control during testing is difficult. Therefore, a poro-elastic parameter measurement test was conducted on the siliceous mudstone of the Wakkanai formation to accumulate measurement results on the poro-elastic parameters and to examine the dependence of the parameters on confining pressure. As a result, some dependency of the poro-elastic parameters on confining pressure was observed. Among the measured or calculated poro-elastic parameters, the drained bulk modulus increased, while the Skempton's pressure coefficient, and the Biot-Wills coefficient in the elastic region decreased with the increase in confining pressure. The measurement results also inferred that the foliation observed in the rock specimens might impact a degree of dependency of those parameters on confining pressure.

Neutronic design of basic cores of the new STACY

Izawa, Kazuhiko; Ishii, Junichi; Okubo, Takuya; Ogawa, Kazuhiko; Tonoike, Kotaro

Proceedings of 11th International Conference on Nuclear Criticality Safety (ICNC 2019) (Internet), 9 Pages, 2019/09

Japan Atomic Energy Agency, JAEA, is conducting the renewal program of the heterogeneous water moderated critical assembly STACY (Static Experiment Critical Facility) in order to verify the criticality calculation considering fuel debris which have been produced in the accident of Fukushima Daiichi Nuclear Power Station. The first criticality of the new STACY is scheduled at the beginning of 2021. After the first criticality, it is necessary to perform a series of critical experiments with a series of basic experimental core in order to gain a proficiency of operators and grasp the uncertainty that accompanies the result of critical experiments in STACY. Prior to the construction of the new STACY, a series of neutronic calculation was carried out for licensing and planning first series of critical experiment. In this paper, possible core configuration of the basic experimental core and their limitations are discussed and presented.

Fabrication of neutron optical devices using PBW technique

Sakai, Takuro; Iikura, Hiroshi; Yamada, Naoto*; Sato, Takahiro*; Ishii, Yasuyuki*; Uchida, Masaya*

QST-M-8; QST Takasaki Annual Report 2016, P. 140, 2018/03

https://repo.qst.go.jp/records/73811

Mechanical characteristics of rock segment for reducing amount of cement use and stability of drift tunnel

Tada, Hiroyuki*; Kumasaka, Hiroo*; Saito, Akira*; Nakaya, Atsushi*; Ishii, Takashi*; Fujita, Tomoo; Sugita, Yutaka; Nakama, Shigeo; Sanada, Masanori*

Doboku Gakkai Rombunshu, F2 (Chika Kukan Kenkyu) (Internet), 73(1), p.11 - 28, 2017/03

https://doi.org/10.2208/jscejusr.73.11

This study examined the mechanical characteristics of rock segments and backfill materials and analyzed the stability of the drift that is supported by the rock segments and gravel backfill. The results confirmed the technical aspects of the formation of the rock segments and the effectiveness of the planned efforts to further reduce the amount of cement used.

Fabrication of fine imaging devices using an external proton microbeam

Sakai, Takuro; Yasuda, Ryo; Iikura, Hiroshi; Nojima, Takehiro; Koka, Masashi; Sato, Takahiro; Ishii, Yasuyuki; Oshima, Akihiro*

Nuclear Instruments and Methods in Physics Research B, 332, p.238 - 241, 2014/08

https://doi.org/10.1016/j.nimb.2014.02.069

We have successfully fabricated novel microscopic imaging devices made from UV/EB curable resin using an external scanning proton microbeams. The devices are micro-structured fluorescent plates that consist of an array of micro-pillars that align periodically. The base material used in the pillars is UV/EB curable resin and each pillar contains phosphor grains. The pattern exposures were performed using a proton beam writing technique. The height of the pillars depends on the range of the proton beam. Optical microscopy and scanning electron microscopy have been used to characterize the samples. The results show that the fabricated fluorescent plates are expected to be high-spatial-resolution imaging devices.

Production of N-labeled nitrogen gas tracer for the imaging of nitrogen fixation in soybean nodules

Ishii, Satomi; Igura, Masato*; Yin, Y.-G.; Hung, N. V. P.*; Suzui, Nobuo; Kawachi, Naoki; Koyanagi, Atsushi*; Oyama, Takuji*; Fujimaki, Shu

JAEA-Review 2013-059, JAEA Takasaki Annual Report 2012, P. 98, 2014/03

https://jopss.jaea.go.jp/pdfdata/JAEA-Review-2013-059.pdf

Quantitative analysis of the initial transport of fixed nitrogen in nodulated soybean plants using N as a tracer

Hung, N. V. P.*; Watanabe, Shiori*; Ishikawa, Shinji*; Otake, Norikuni*; Sueyoshi, Kuni*; Sato, Takashi*; Ishii, Satomi; Fujimaki, Shu; Oyama, Takuji*

Soil Science and Plant Nutrition, 59(6), p.888 - 895, 2013/12

https://doi.org/10.1080/00380768.2013.838742

Development of rock segment for reduction of amount of cement use

Tada, Hiroyuki*; Kumasaka, Hiroo*; Saito, Akira*; Nakaya, Atsushi*; Ishii, Takashi*; Sanada, Masanori; Noguchi, Akira*; Kishi, Hirokazu*; Nakama, Shigeo; Fujita, Tomoo

Dai-13-Kai Iwa No Rikigaku Kokunai Shimpojiumu Koen Rombunshu (CD-ROM), p.133 - 138, 2013/01

The authors have been developing methods for constructing tunnels using the minimum quantities of cement-type support materials in high-level radioactive waste disposal facilities and advancing research and development about the technical formation of rock segment using low alkaline mortar. In this study, the mechanical characteristic values concerning the rock segment and backfill materials were examined. The stability analysis of tunnel supported by the rock segment and backfilling with gravel were performed. Technical formation and effectiveness of the alternative supports planned for further reduction in cement influence was confirmed from a study result above-mentioned.