Design and actual performance of J-PARC 3 GeV rapid cycling synchrotron for high-intensity operation

Yamamoto, Kazami; Kinsho, Michikazu; Hayashi, Naoki; Saha, P. K.; Tamura, Fumihiko; Yamamoto, Masanobu; Tani, Norio; Takayanagi, Tomohiro; Kamiya, Junichiro; Shobuda, Yoshihiro; et al.

Journal of Nuclear Science and Technology, 59(9), p.1174 - 1205, 2022/09

https://doi.org/10.1080/00223131.2022.2038301

In the Japan Proton Accelerator Research Complex, the purpose of the 3 GeV rapid cycling synchrotron (RCS) is to accelerate a 1 MW, high-intensity proton beam. To achieve beam operation at a repetition rate of 25 Hz at high intensities, the RCS was elaborately designed. After starting the RCS operation, we carefully verified the validity of its design and made certain improvements to establish a reliable operation at higher power as possible. Consequently, we demonstrated beam operation at a high power, namely, 1 MW. We then summarized the design, actual performance, and improvements of the RCS to achieve a 1 MW beam.

Spallation and fragmentation cross sections for 168 MeV/nucleon Xe ions on proton, deuteron, and carbon targets

Sun, X. H.*; Wang, H.*; Otsu, Hideaki*; Sakurai, Hiroyoshi*; Ahn, D. S.*; Aikawa, Masayuki*; Fukuda, Naoki*; Isobe, Tadaaki*; Kawakami, Shunsuke*; Koyama, Shumpei*; et al.

Physical Review C, 101(6), p.064623_1 - 064623_12, 2020/06

https://doi.org/10.1103/PhysRevC.101.064623

The spallation and fragmentation reactions of Xe induced by proton, deuteron and carbon at 168 MeV/nucleon were studied at RIKEN Radioactive Isotope Beam Factory via the inverse kinematics technique. The cross sections of the lighter products are larger in the carbon-induced reactions due to the higher total kinetic energy of carbon. The energy dependence was investigated by comparing the newly obtained data with previous results obtained at higher reaction energies. The experimental data were compared with the results of SPACS, EPAX, PHITS and DEURACS calculations. These data serve as benchmarks for the model calculations.

Synchrotron radiation-based techniques available at JAEA advanced characterization nanotechnology platform (Japan Atomic Energy Agency)

Yoneda, Yasuhiro; Yoshigoe, Akitaka; Takeda, Yukiharu; Shiwaku, Hideaki; Matsumura, Daiju; Shobu, Takahisa; Tamura, Kazuhisa

Materia, 58(12), p.763 - 769, 2019/12

https://doi.org/10.2320/materia.58.763

This is an introduction to the equipment provided for each implementation period belonging to the structure analysis platform in the nanotechnology platform.

Conceptual study on parasitic low-energy RI beam production with in-flight separator BigRIPS and the first stopping examination for high-energy RI beams in the parasitic gas cell

Sonoda, Tetsu*; Katayama, Ichiro*; Wada, Michiharu*; Iimura, Hideki; Sonnenschein, V.*; Iimura, Shun*; Takamine, Aiko*; Rosenbusch, M.*; Kojima, Takao*; Ahn, D. S.*; et al.

Progress of Theoretical and Experimental Physics (Internet), 2019(11), p.113D02_1 - 113D02_12, 2019/11

AA2019-0315.pdf:1.37MB

https://doi.org/10.1093/ptep/ptz120

An in-flight separator, BigRIPS, at RIBF in RIKEN provides each experiment with specific nuclides separated from many nuclides produced by projectile fragmentation or in-flight fission. In this process, nuclides other than separated ones are discarded on the slits in BigRIPS, although they include many nuclides interested from the view point of nuclear structure. In order to extract these nuclides for parasitic experiments, we are developing a method using laser ion-source (PALIS). A test experiment with Se beam from RIBF has been performed by using a gas cell set in BigRIPS. Unstable nuclides around Se were stopped in the gas cell in accordance with a calculation using LISE code. The stopping efficiency has been estimated to be about 30%. As a next step, we will establish the technique for extracting reaction products from the gas cell.

Local magnetic states of the weakly ferromagnetic iron-based superconductor SrVFeAsO studied by X-ray magnetic circular dichroism

Horio, Masafumi*; Takeda, Yukiharu; Namiki, Hiromasa*; Katagiri, Takao*; Wakabayashi, Yuki*; Sakamoto, Shoya*; Nonaka, Yosuke*; Shibata, Goro*; Ikeda, Keisuke*; Saito, Yuji; et al.

Journal of the Physical Society of Japan, 87(10), p.105001_1 - 105001_2, 2018/10

https://doi.org/10.7566/JPSJ.87.105001

Void reactivity evaluation by modified conversion ratio measurements in LWR critical experiments

Yoshioka, Kenichi*; Kikuchi, Tsukasa*; Gunji, Satoshi*; Kumanomido, Hironori*; Mitsuhashi, Ishi*; Umano, Takuya*; Yamaoka, Mitsuaki*; Okajima, Shigeaki; Fukushima, Masahiro; Nagaya, Yasunobu; et al.

Journal of Nuclear Science and Technology, 52(2), p.282 - 293, 2015/02

https://doi.org/10.1080/00223131.2014.937781

We have developed a void reactivity evaluation method by using modified conversion ratio measurements in a light water reactor (LWR) critical lattice. Assembly-wise void reactivity is evaluated from the "finite neutron multiplication factor", , deduced from the modified conversion ratio of each fuel rod. The distributions of modified conversion ratio and on a reduced-moderation LWR lattice, for which the improvement of negative void reactivity is a serious issue, were measured. Measured values were analyzed with a continuous-energy Monte Carlo method. The measurements and analyses agreed within the measurement uncertainty. The developed method is useful for validating the nuclear design methodology concerning void reactivity.

Deformation-driven -wave halos at the drip-line; Ne

Nakamura, Takashi*; Kobayashi, Nobuyuki*; Kondo, Yosuke*; Sato, Yoshiteru*; Tostevin, J. A.*; Utsuno, Yutaka; Aoi, Nori*; Baba, Hidetada*; Fukuda, Naoki*; Gibelin, J.*; et al.

Physical Review Letters, 112(14), p.142501_1 - 142501_5, 2014/04

https://doi.org/10.1103/PhysRevLett.112.142501

no abstracts in English

Intra-pellet neutron flux distribution measurements in LWR critical lattices

Yoshioka, Kenichi*; Kikuchi, Tsukasa*; Gunji, Satoshi*; Kumanomido, Hironori*; Mitsuhashi, Ishi*; Umano, Takuya*; Yamaoka, Mitsuaki*; Okajima, Shigeaki; Fukushima, Masahiro; Nagaya, Yasunobu; et al.

Journal of Nuclear Science and Technology, 50(6), p.606 - 614, 2013/06

https://doi.org/10.1080/00223131.2013.785270

We have developed an intra-pellet neutron flux and conversion ratio distribution measurement method. A foil activation method with special foils was used for the neutron flux distribution measurement. A -ray spectrum analysis method with special collimators was used for the conversion ratio distribution measurement. Using the developed methods, intra-pellet neutron flux distributions and conversion ratio distributions were measured in critical experiments on a reduced-moderation LWR. Measured values were analyzed with a deterministic method and a Monte Carlo method. The neutron flux distribution measurements and analyses agreed within the range of 1% to 2%. The conversion ratio distribution measurements and analyses were consistent with each other. We found that the measurement methods are useful for the validation of neutron behavior in a fuel pellet, which is known as micro reactor physics.

Halo structure of the island of inversion nucleus Ne

Nakamura, Takashi*; Kobayashi, Nobuyuki*; Kondo, Yosuke*; Sato, Yoshiteru*; Aoi, Nori*; Baba, Hidetada*; Deguchi, Shigeki*; Fukuda, Naoki*; Gibelin, J.*; Inabe, Naoto*; et al.

Physical Review Letters, 103(26), p.262501_1 - 262501_4, 2009/12

https://doi.org/10.1103/PhysRevLett.103.262501

no abstracts in English

Experiment and analysis for criticality in small fast reactor with reflector at FCA

Fukushima, Masahiro; Okajima, Shigeaki; Mori, Takamasa; Takeda, Toshikazu*; Kinoshita, Izumi*

Proceedings of International Conference on the Physics of Reactors, Nuclear Power; A Sustainable Resource (PHYSOR 2008) (CD-ROM), 7 Pages, 2008/09

The criticality was measured in a series of mock-up cores simulated small fast reactor with massive reflector at FCA facility of JAEA in order to evaluate the prediction accuracy of the current analysis code system. In the analyses, the effective cross sections were obtained by using an ultra-fine group cell calculation code. The JENDL-3.3 cross section library was used. The core calculations for the criticality were performed by using a three-dimensional S transport code. Conventional calculations with a standard 70 energy group structure and under the P transport approximation overestimated the experimental values up to 1.5%/. Furthermore, the calculation parameters were investigated concerning the fine energy group structure and the higher Legendre order of anisotropic scattering cross section. Consequently, the calculation accuracy for the criticality was improved by about 1%/ with a 140 energy group structure and under the P approximation.