Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Chiba, Satoshi*; Wakabayashi, Toshio*; Tachi, Yoshiaki; Takaki, Naoyuki*; Terashima, Atsunori*; Okumura, Shin*; Yoshida, Tadashi*
Scientific Reports (Internet), 7(1), p.13961_1 - 13961_10, 2017/10
Times Cited Count:34 Percentile:96.31(Multidisciplinary Sciences)Transmutation of long-lived fission products (LLFPs: Se, Zr, Tc, Pd, I, and Cs) into short-lived or non-radioactive nuclides by fast neutron spectrum reactors without isotope separation has been proposed as a solution to the problem of radioactive wastes disposal. Despite investigation of many methods, such transmutation remains technologically difficult. To establish an effective and efficient transmutation system, we propose a novel neutron moderator material, yttrium deuteride (YD), to soften the neutron spectrum leaking from the reactor core. Neutron energy spectra and effective half-lives of LLFPs, transmutation rates, and support ratios were evaluated with the continuous-energy Monte Carlo code MVP-II/MVP-BURN and the JENDL-4.0 cross section library. With the YD moderator in the radial blanket and shield regions, effective half-lives drastically decreased from 10 to 10 years and the support ratios reached 1.0 for all six LLFPs. This successful development and implementation of a transmutation system for LLFPs without isotope separation contribute to developing a self-consuming cycle of LLFPs using fast spectrum reactors to reduce radioactive waste.
Kudo, Junichi*; Sakaba, Nariaki; Takahashi, Makoto*; Wakabayashi, Toshio*
Nihon Genshiryoku Gakkai Wabun Rombunshi, 9(4), p.360 - 367, 2010/12
The HTTR-IS system is one of the plants producing hydrogen with nuclear power. Such a system has high safety requirements. One of the safety studies to be conducted is the probabilistic safety assessment (PSA) study for concerned hydrogen explosion, which was not studied previously. Therefore, this study is conducted for the preliminary PSA of flammable gas leakage in the HTTR-IS system. First, a master logic diagram (MLD) was developed to identify initiating events. After identifying initiating events, event tree analysis (ETA) and fault tree analysis (FTA) were performed to quantify the average frequency of an accident. The initial result of the PSA shows that the nominal frequency of explosion is 2.510 1/y. This frequency is higher than the criterion defined in this paper and unacceptable. Installments of additional components are investigated in order to reduce frequency. As a result, the average frequency of explosion is decreased to 7.910 1/y.
Tachi, Yoshiaki; Wakabayashi, Toshio*
Transactions of the American Nuclear Society, 103(1), p.268 - 269, 2010/11
It is very attractive technique to transmute long-lived fission products such as iodine-129 included in spent fuel by using Fast Reactors (FRs) to minimize environmental burden and toxic risk due to high level waste disposal. Iodine has low melting point (386K) and low boiling points (457K) compared with FR core temperature. Furthermore, it is corrosive against iron based materials. Then, it is the most important issue to search suitable chemical forms for FR core conditions, having high stability at elevated temperature and good compatibility with cladding material. From the viewpoint of melting point, nuclides generation by neutron irradiation, reactivity with stainless steel, easy fabrication method and recyclability, 5 kinds of iodides of CuI, MgI, YI, RbI and YI were selected as the candidate chemical form of iodine for transmutation in FR. In order to evaluate stability of the candidate iodides at elevated temperature, TG-DTA of CuI, RbI, BaI and YI were performed. According to TG-DTA results, no significant mass change showed in BaI beyond those temperatures. Mass of CuI, RbI and YI started to be lost severely at the lower temperature than their melting points. Compatibility test between iodides and cladding materials were conducted. Cladding materials in contact with iodides were heated in a capsule filled with pure Ar gas at 873K for 5000h maximum. Results of cross-section observation showed that MgI and YI made pit corrosion on SUS316 and ODS. It appeared that the upper part of the inner surface test capsules with RbI, YI were degraded severely. Based on the experimental results, the most applicable iodide for transmutation by FR is BaI from the viewpoints of stability at elevated temperature and compatibility with cladding material.
Oki, Shigeo; Takashima, Hideki; Wakabayashi, Toshio; Yamaguchi, Kenji*; Yamawaki, Michio*
JNC TY9400 2004-005, 36 Pages, 2004/05
In the framework of the study on transmutation of minor actinide (MA) nuclides with fast reactors, the fission cross section ratio of 237Np relative to 235U has been measured by using a back-to-back (BTB) fission chamber at YAYOI fast neutron source reactor. The compact BTB fission chamber was prepared for the measurements in the experimental holes called Glory hole and Grazing hole passing though the core center and the side blanket of YAYOI, respectively. Dependence of fission cross section ratios on neutron spectrum was investigated by changing the measurement position in these experimental holes.The measured values of fission cross section ratios were compared with those calculated with the following nuclear data libraries: JENDL-3.2, ENDF/B-VI, JEF-2.2, and JENDL-2. It was found that the calculated values in the center of the core systematically overestimated the measurements by about 30%. Dispersion of the calculated values among the nuclear data libraries was smaller than the above difference from the measured value. We also see the dependence of C/E value on the measurement position. It is hardly said that uncertainty of nuclear data brings about the above overestimation of 30%.The present result remained some issues in terms of the measurement accuracy. If we can get rid of those causes, for example, by means of the unfolding technique on pulse height distribution, the result could be utilized as expletive information in nuclear data validation not only for 237Np, but also for 235U and 238U which characterize the neutron spectrum.
Okawachi, Yasushi; Oki, Shigeo; Wakabayashi, Toshio; Yamaguchi, Kenji*; Yamawaki, Michio*
JNC TY9400 2004-004, 37 Pages, 2004/05
In the framework of the study on transmutation of minor actinide (MA) nuclides with fast reactors, the fission cross section ratios of MA (241Am, 243Am) relative to 235U have been measured by using a back-to-back (BTB) fission chamber at YAYOI fast neutron source reactor. The compact BTB fission chamber was prepared for the measurements in the main experimental hole (Glory hole) passing though the core of YAYOI. Dependence of fission cross section ratios on neutron spectrum was investigated by changing the measurement position in Glory hole from core center to depleted uranium blanket.The measured values of fission cross section ratios were compared with those calculated with the following nuclear data libraries: JENDL-3.2, ENDF/B-VI, and JEF-2.2. It was found that the calculated values for both 241Am and 243Am in the center of the core systematically underestimated the measurements by 10 to 20%. Dispersion of the calculated values among the nuclear data libraries was smaller than the above difference from the measured value. We also see the dependence of C/E value on the measurement position.The present result remained some issues in terms of the measurement accuracy. If we can get rid of those causes, for example, by means of the unfolding technique on pulse height distribution, the result could be utilized as expletive information in nuclear data validation not only for 241Am and 243Am but also for 235U and 238U which characterize the neutron spectrum.
Uto, Nariaki; Hayafune, Hiroki;
Progress in Nuclear Energy, 37(1-4), 283 Pages, 2002/00
Times Cited Count:2 Percentile:19.44(Nuclear Science & Technology)None
Kai, Tetsuya; Kobayashi, Katsuhei*; Yamamoto, Shuji*; Cho, H.*; Fujita, Yoshiaki*; Kimura, Itsuro*; Okawachi, Yasushi*; Wakabayashi, Toshio*
Annals of Nuclear Energy, 28(8), p.723 - 739, 2001/05
Times Cited Count:7 Percentile:48.68(Nuclear Science & Technology)no abstracts in English
Kiyanagi, Yoshiaki*; Kamiyama, Takashi*; Hiraga, Fujio*; ; Okawachi, Yasushi
JNC TY9400 2000-015, 238 Pages, 2000/05
no abstracts in English
Mukaiyama, Takehiko; Wakabayashi, Toshio*
Nihon Genshiryoku Gakkai-Shi, 41(6), p.713 - 714, 1999/06
no abstracts in English
Proceedings of International Conference on Future Nuclear Systems (GLOBAL'99), 0 Pages, 1999/00
None
; Takahashi, Katsuro; Yanagisawa, Tsutomu
Nuclear Technology, 118, p.14 - 25, 1998/00
Times Cited Count:21 Percentile:82.17(Nuclear Science & Technology)None
R.P.Rulko*; Takano, Hideki; C.Broeders*; Wakabayashi, Toshio*; Sasa, Toshinobu; *; D.Lutz*; Mukaiyama, Takehiko; C.Nordborg*
Proc. of Int. Conf. on the Phys. of Nucl. Sci. and Technol., 2, p.1462 - 1469, 1998/00
no abstracts in English
Higano, Naomi; Wakabayashi, Toshio
PNC TN9410 96-248, 69 Pages, 1996/11
In spent fuel there are many kinds of long-lived fission products. Tc and I are contained as fission products in HLW: they have comparatively long half lives and their toxicity remains for more than 1000 years, when the efficacy of the engineered barrier is uncertain. Fortunately, these two nuclides have large capture cross-sections in the thermal-resonance neutron energy region, so they have a good potential to be changed to stable nuclides in such a neutron flux. We tried to reduce the amount of these nuclides using a fast reactor. The neutron spectrum of a FR is too hard for effective transmutation of these nuclides, but the flux of a FR is much higher than in other commercial reactors, and the hard spectrum of a FR can be changed locally into a moderated spectrum by the addition of some moderator materials. We tried to make a good neutron flux for transmutation of these long lived fission products and to get high transmutation rates. In this survey, 60 moderated target subassemblies were modeled on the core periphery of a 600MWe fast reactor. Using a continuous energy Monte-Carlo code (MVP), some parametric surveys have been done, examining the effects on transmutation performances of : moderator fraction ; pin and subassembly arrangements ; moderating materials. The code system allowed us to investigate the effects of self-shielding. For Tc, the best transmutation rate is about 10%/y in the case of Duplex pin -the FP region is surrounded by moderator material-. With the best arrangement to maximize the amount transmuted, we can transmute 40kg Tc in a year. With the present case, the transmutation rate and transmuted amount of I are inferior to those of Tc. In the most effective case, the I transmutation rate is 5.2% and the transmuted amount is 18kg in a year. But the produced amount of I from a PWR is small - about 5kg from a 100MWe PWR in a year-, so the transmuted amount of I is ...
Hirano, Masashi; Wakabayashi, Toshio*; *
Genshiryoku Kogyo, 42(10), p.1 - 5, 1996/10
no abstracts in English
Mukaiyama, Takehiko; Kubota, Masumitsu; Ogawa, Toru; Fujine, Sachio; Wakabayashi, Toshio*; Ozawa, Masaki*; *
Nihon Genshiryoku Gakkai-Shi, 38(7), p.591 - 593, 1996/00
no abstracts in English
; Ikegami, Tetsuo
Proceedings of International Conference on the Physics of Reactors (PHYSOR '96), 0 Pages, 1996/00
None
Wakabayashi, Toshio; Yamaoka, Mitsuaki;
Nuclear Engineering and Design, 154(3), p.239 - 250, 1995/04
Times Cited Count:4 Percentile:43.23(Nuclear Science & Technology)None