Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Tsubota, Yoichi; Porcheron, E.*; Journeau, C.*; Delacroix, J.*; Suteau, C.*; Lallot, Y.*; Bouland, A.*; Roulet, D.*; Mitsugi, Takeshi
Proceedings of International Conference on Environmental Remediation and Radioactive Waste Management (ICEM2023) (Internet), 6 Pages, 2023/10
In order to safely remove fuel debris from the Fukushima Daiichi Nuclear Power Station (1F), it is necessary to quantitatively evaluate radioactive airborne particulate generated by the cutting of nuclear fuel debris. We fabricated Uranium-bearing simulated fuel debris (SFD) with In/Ex-Vessel compositions and evaluated the physical and chemical properties of aerosols generated by heating the SFDs. Based on these results, we estimated the isotopic composition and radioactivity of aerosols produced when 1F-Unit2 fuel debris is laser cut, which is a typical example of a heating method. Plutonium, mainly 
Pu,
Am, and 
Cm were found to be the alpha nuclide, and Pu, 
Cs-Ba, and 
Sr-Y were found to be the beta nuclide of interest.
Porcheron, E.*; Journeau, C.*; Delacroix, J.*; Berlemont, R.*; Bouland, A.*; Lallot, Y.*; Tsubota, Yoichi; Ikeda, Atsushi; Mitsugi, Takeshi
Proceedings of International Conference on Environmental Remediation and Radioactive Waste Management (ICEM2023) (Internet), 5 Pages, 2023/10
Results of the URASOL project aimed at evaluating the generation and dispersion of radioactive aerosols during the cutting of fuel debris, a key issue in the decommissioning of the damaged reactors at the Fukushima Daiichi Nuclear Power Station (1F), are presented in this report. Characterization of aerosols generated during heating and mechanical cutting of simulated fuel debris in terms of mass concentration, real-time number density, mass-based particle size distribution, morphology, and chemical properties is reported. In the heating tests, an increase in particle size with increasing temperature was observed, and in terms of particle number density, the case using depleted uranium simulated fuel debris had a smaller number density than the test using Hf-containing simulated fuel debris. In mechanical cleavage, the aerodynamic median mass diameter of the aerosol was almost the same for the radioactive and non-radioactive samples (about 3.7
4.4 
m).
Journeau, C.*; Delacroix, J.*; Gu
var, C.*; Testud, V.*; Brackx, E.*; Porcheron, E.*; Bouland, A.*; Berlemont, R.*; Ikeda, Atsushi
Science Talks (Internet), 6, p.100215_1 - 100215_9, 2023/05
Sun, Haomin; Leblois, Y.*; Gelain, T.*; Porcheron, E.*
Journal of Nuclear Science and Technology, 59(11), p.1356 - 1369, 2022/11
Times Cited Count：0 Percentile：0.01(Nuclear Science & Technology)In severe accident scenarios of PWR, containment spray can be employed to washout the aerosol of radioactive materials, retaining them in the containment. Therefore, it is crucial to correctly predict the washout efficiency for safety assessment. For a PWR, a high spray coverage ratio (
84%-95%) is required. However, experimental studies on the washout with such a high coverage ratio in a large vessel are quite limited. To understand such a washout phenomenon for model development, aerosol washout experiments are performed in a large vessel with not only aerosol measurements but also spray droplet characterizations. The spray coverage ratios are experimentally confirmed to be compatible with a real PWR. The washout features are investigated in detail. The model in MELCOR is examined using the measured aerosol removal rate, showing the removal rate tendency against particle diameters being reproduced. Although a significant underestimation occurs for large particles, a satisfactory agreement is obtained for smaller ones (
0.52 m in diameter) corresponding to the minimum removal rate and around.
Porcheron, E.*; Leblois, Y.*; Journeau, C.*; Delacroix, J.*; Molina, D.*; Suteau, C.*; Berlemont, R.*; Bouland, A.*; Lallot, Y.*; Roulet, D.*; et al.
Proceedings of International Topical Workshop on Fukushima Decommissioning Research (FDR2022) (Internet), 5 Pages, 2022/10
One of the important challenges for the decommissioning of the damaged reactors of the Fukushima Daiichi Nuclear Power Station (1F) is the fuel debris retrieval. The URASOL project, which is undertaken by a French consortium consisting of ONET Technologies, CEA, and IRSN for JAEA/CLADS, is dedicated to acquiring basic scientific data on the generation and characteristics of radioactive aerosols from the thermal or mechanical processing of fuel debris simulant. Heating process undertaken in the VITAE facility simulates some representative conditions of thermal cutting by LASER. For mechanical cutting, the core boring technique is implemented in the FUJISAN facility. Fuel debris simulants have been developed for inactive and active trials. The aerosols are characterized in terms of mass concentration, real time number concentration, mass size distribution, morphology, and chemical properties. The chemical characterization aims at identifying potential radioactive particles released and the associated size distribution, both of which are important information for assessing possible safety and radioprotection measures during the fuel debris retrieval operations at 1F.
Sun, Haomin; Porcheron, E.*; Magne, S.*; Leroy, M.*; Dhote, J.*; Ruffien Ciszak, A.*; Bentaib, A.*
Proceedings of OECD/NEA Specialist Workshop on Advanced Measurement Method and Instrumentation for enhancing Severe Accident Management in an NPP addressing Emergency, Stabilization and Long-term Recovery Phases (SAMMI 2020) (Internet), 10 Pages, 2020/12
Bentaib, A.*; Janin, T.*; Porcheron, E.*; Magne, S.*; Leroy, M.*; Dhote, J.*; Ruffien Ciszak, A.*; Sun, Haomin
Proceedings of OECD/NEA Specialist Workshop on Advanced Measurement Method and Instrumentation for enhancing Severe Accident Management in an NPP addressing Emergency, Stabilization and Long-term Recovery Phases (SAMMI 2020) (Internet), 6 Pages, 2020/12
Sun, Haomin; Leblois, Y.*; Gelain, T.*; Porcheron, E.*
Proceedings of 2020 International Conference on Nuclear Engineering (ICONE 2020) (Internet), 11 Pages, 2020/08
