Microdosimetric evaluation of the neutron field for BNCT at Kyoto University Reactor by using the PHITS code

Baba, Hiromi*; Onizuka, Yoshihiko*; Nakao, Minoru*; Fukahori, Mai*; Sato, Tatsuhiko; Sakurai, Yoshinori*; Tanaka, Hiroki*; Endo, Satoru*

Radiation Protection Dosimetry, 143(2-4), p.528 - 532, 2011/02

https://doi.org/10.1093/rpd/ncq511

The PHITS simulation were performed to reproduce the geometrical setup of an experiment that measured the microdosimetric energy distributions at the Kyoto University Reactor (KUR) where two types of tissue equivalent proportional counters (TEPC) were used, one with A-150 wall alone and another with a 50 ppm boron loaded A-150 wall. It was found that the PHITS code is a useful tool for the simulation of the energy deposited in tissue in BNCT based on the comparisons with experimental results.

Conceptual design of the SlimCS fusion DEMO reactor

Tobita, Kenji; Nishio, Satoshi*; Enoeda, Mikio; Nakamura, Hirofumi; Hayashi, Takumi; Asakura, Nobuyuki; Uto, Hiroyasu; Tanigawa, Hiroyasu; Nishitani, Takeo; Isono, Takaaki; et al.

JAEA-Research 2010-019, 194 Pages, 2010/08

JAEA-Research-2010-019-01.pdf:48.47MB
JAEA-Research-2010-019-02.pdf:19.4MB

This report describes the results of the conceptual design study of the SlimCS fusion DEMO reactor aiming at demonstrating fusion power production in a plant scale and allowing to assess the economic prospects of a fusion power plant. The design study has focused on a compact and low aspect ratio tokamak reactor concept with a reduced-sized central solenoid, which is novel compared with previous tokamak reactor concept such as SSTR (Steady State Tokamak Reactor). The reactor has the main parameters of a major radius of 5.5 m, aspect ratio of 2.6, elongation of 2.0, normalized beta of 4.3, fusion out put of 2.95 GW and average neutron wall load of 3 MW/m. This report covers various aspects of design study including systemic design, physics design, torus configuration, blanket, superconducting magnet, maintenance and building, which were carried out increase the engineering feasibility of the concept.

Hydrogenation and dehydrogenation of passivated aluminum under high pressure

Saito, Hiroyuki; Machida, Akihiko; Sakurai, Yoko; Katayama, Yoshinori; Aoki, Katsutoshi

Proceedings of 18th International Symposium on Processing and Fabrication of Advanced Materials (PFAM-18), p.75 - 80, 2009/12

SlimCS; Compact low aspect ratio DEMO reactor with reduced-size central solenoid

Tobita, Kenji; Nishio, Satoshi; Sato, Masayasu; Sakurai, Shinji; Hayashi, Takao; Shibama, Yusuke; Isono, Takaaki; Enoeda, Mikio; Nakamura, Hirofumi; Sato, Satoshi; et al.

Nuclear Fusion, 47(8), p.892 - 899, 2007/08

https://doi.org/10.1088/0029-5515/47/8/022

The concept for a compact DEMO reactor named "SlimCS" is presented. Distinctive features of the concept is low aspect ratio ( = 2.6) and use of a reduced-size center solenoid (CS) which has a function of plasma shaping rather than poloidal flux supply. The reduced-size CS enables us to introduce a thin toroidal field (TF) coil system which contributes to reducing the weight and construction cost of the reactor. SlimCS is as compact as advanced commercial reactor designs such as ARIES-RS and produces 1 GWe in spite of moderate requirements for plasma parameters. Merits of low-, i.e. vertical stability for high elongation and high beta limit are responsible for such reasonable physics requirements.

Concept of compact low aspect ratio Demo reactor, SlimCS

Tobita, Kenji; Nishio, Satoshi; Sato, Masayasu; Sakurai, Shinji; Hayashi, Takao; Shibama, Yusuke; Isono, Takaaki; Enoeda, Mikio; Nakamura, Hirofumi; Sato, Satoshi; et al.

Proceedings of 21st IAEA Fusion Energy Conference (FEC 2006) (CD-ROM), 8 Pages, 2006/10

http://www-naweb.iaea.org/napc/physics/FEC/FEC2006/html/node305.htm#60147

no abstracts in English

Development of a wide-range paired scintillator with optical fiber neutron monitor for BNCT irradiation field study

Ishikawa, Masayori*; Kumada, Hiroaki; Yamamoto, Kazuyoshi; Kaneko, Junichi*; Bengua, G.*; Unesaki, Hironobu*; Sakurai, Yoshinori*; Tanaka, Kenichi*; Kosako, Toshiso*

Nuclear Instruments and Methods in Physics Research A, 551(2-3), p.448 - 457, 2005/10

https://doi.org/10.1016/j.nima.2005.06.044

A wide range thermal neutron detector was developed based on the Scintillator with Optical Fiber (SOF) detector which has been previously used for thermal neutron monitoring during boron neutron capture therapy irradiation. With this new detector system we intended to address the issues of real-time thermal neutron flux measurement and the simultaneous measurement of a wide range of thermal neutron flux in a BNCT irradiation field which were difficult to implement with the gold wire activation method. A good agreement between the thermal neutron flux measured by the gold wire activation method and the paired SOF detector system was observed. However, measurements which would normally take a few days to perform with the gold wire activation method were obtained in just about 15 min using the SOF detector system. We also confirmed the dynamic range of linearity for the SOF detector system to be in the order of magnitude of 1e-4.

Calibration of epithermal neutron beam intensity for dosimetry at JRR-4

Yamamoto, Kazuyoshi; Kumada, Hiroaki; Kishi, Toshiaki; Torii, Yoshiya; Sakurai, Yoshinori*; Kobayashi, Toru*

Proceedings of 11th World Congress on Neutron Capture Therapy (ISNCT-11) (CD-ROM), 15 Pages, 2004/10

To carry out the boron neutron capture therapy (BNCT) using the epithermal neutron, the epithermal neutron beam intensity was measured by using Au reaction rate activated on the resonance absorption peak (4.9eV). Two scaling factors, which are the reactor power calibration factor and the calculation/experiment (C/E) scaling factor, are necessary in order to correct with the simulation and actual irradiation experiment. First, an optimum detector position was investigated using MCNP code. The result of MCNP calculation showed that the influence of subject placed at the collimator was below 1% when the detector was placed in the distance of over 20cm from the collimator. Therefore we installed the monitor holders near the bismuth block in order to set three gold wire monitors. The factors were determined in the calibration experiments that measure the thermal neutron flux in the phantom and reaction rate of the gold wire monitors. The monitoring technique to measure epithermal neutron beam intensity was applied to clinical irradiation with the epithermal neutron beam.

Validation of minor actinide cross sections by studying samples irradiated for 492 days at the dounreay prototype fast reactor, 1; Radiochemical analysis

Shinohara, Nobuo; Kono, Nobuaki; Nakahara, Yoshinori; Tsujimoto, Kazufumi; Sakurai, Takeshi; Mukaiyama, Takehiko*; Raman, S.*

Nuclear Science and Engineering, 144(2), p.115 - 128, 2003/06

https://doi.org/10.13182/NSE03-A2347

no abstracts in English

Validation of minor actinide cross sections by studying samples irradiated for 492 days at the dounreay prototype fast reactor, 2; Burnup calculations

Tsujimoto, Kazufumi; Kono, Nobuaki; Shinohara, Nobuo; Sakurai, Takeshi; Nakahara, Yoshinori; Mukaiyama, Takehiko*; Raman, S.*

Nuclear Science and Engineering, 144(2), p.129 - 141, 2003/06

https://doi.org/10.13182/NSE03-A2348

no abstracts in English

Fusion plasma performance and confinement studies on JT-60 and JT-60U

Kamada, Yutaka; Fujita, Takaaki; Ishida, Shinichi; Kikuchi, Mitsuru; Ide, Shunsuke; Takizuka, Tomonori; Shirai, Hiroshi; Koide, Yoshihiko; Fukuda, Takeshi; Hosogane, Nobuyuki; et al.

Fusion Science and Technology (JT-60 Special Issue), 42(2-3), p.185 - 254, 2002/09

https://doi.org/10.13182/FST02-A227

With the main aim of providing physics basis for ITER and the steady-state tokamak reactors, JT-60/JT-60U has been developing and optimizing the operational concepts, and extending the discharge regimes toward sustainment of high integrated performance in the reactor relevant parameter regime. In addition to achievement of the equivalent break-even condition (QDTeq up to 1.25) and a high fusion triple product = 1.5E21 m-3skeV, JT-60U has demonstrated the integrated performance of high confinement, high beta-N, full non-inductive current drive with a large fraction of bootstrap current in the reversed magnetic shear and in the high-beta-p ELMy H mode plasmas characterized by both internal and edge transport barriers. The key factors in optimizing these plasmas are profile and shape controls. As represented by discovery of various Internal Transport Barriers, JT-60/JT-60U has been emphasizing freedom and restriction of profiles in various confinement modes. JT-60U has demonstrated applicability of these high confinement modes to ITER and also clarified remaining issues.