Design and actual performance of J-PARC 3 GeV rapid cycling synchrotron for high-intensity operation

Yamamoto, Kazami; Kinsho, Michikazu; Hayashi, Naoki; Saha, P. K.; Tamura, Fumihiko; Yamamoto, Masanobu; Tani, Norio; Takayanagi, Tomohiro; Kamiya, Junichiro; Shobuda, Yoshihiro; et al.

Journal of Nuclear Science and Technology, 59(9), p.1174 - 1205, 2022/09

https://doi.org/10.1080/00223131.2022.2038301

In the Japan Proton Accelerator Research Complex, the purpose of the 3 GeV rapid cycling synchrotron (RCS) is to accelerate a 1 MW, high-intensity proton beam. To achieve beam operation at a repetition rate of 25 Hz at high intensities, the RCS was elaborately designed. After starting the RCS operation, we carefully verified the validity of its design and made certain improvements to establish a reliable operation at higher power as possible. Consequently, we demonstrated beam operation at a high power, namely, 1 MW. We then summarized the design, actual performance, and improvements of the RCS to achieve a 1 MW beam.

Short-range magnetic interaction in a monolayer 1-VSe film revealed by element-specific X-ray magnetic circular dichroism

Sumida, Kazuki; Takeda, Yukiharu; Kusaka, Shotaro*; Kobayashi, Katsuyoshi*; Hirahara, Toru*

Physical Review Materials (Internet), 6(1), p.014006_1 - 014006_8, 2022/01

https://doi.org/10.1103/PhysRevMaterials.6.014006

We investigated the intrinsic magnetic properties of the two-dimensional ferromagnetic candidate monolayer 1-VSe films using X-ray magnetic circular dichroism (XMCD), an element-specific magnetic probe. By performing high-resolution measurements, we succeeded in detecting a clear XMCD signal from the atomically thin 1-VSe films under an external magnetic field. Through manipulation of the X-ray incidence angle, we were able to disentangle the in-plane and out-of-plane magnetic properties and found a strong magnetic anisotropy. Moreover, magnetic field- and temperature-dependent XMCD revealed that there is no long-range ferromagnetic ordering even at 6 K, but short-range ferromagnetic and antiferromagnetic interactions between neighboring vanadium ions exist. Such low-temperature magnetic behavior signifies that the monolayer 1-VSe is on the verge of ferromagnetism, and this fact accounts for the reported ferromagnetism in VSe-based heterostructures.

Radiation shielding installation for beam injection section of 3GeV synchrotron

Nakanoya, Takamitsu; Kamiya, Junichiro; Yoshimoto, Masahiro; Takayanagi, Tomohiro; Tani, Norio; Kotoku, Hirofumi*; Horino, Koki*; Yanagibashi, Toru*; Takeda, Osamu*; Yamamoto, Kazami

Proceedings of 18th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.238 - 242, 2021/10

Since a user operation startup, the 3GeV synchrotron accelerator (Rapid-Cycling Synchrotron: RCS) gradually reinforced the beam power. As a result, the surface dose rate of the apparatus located at the beam injection area of the RCS increases year by year. The beam injection area has many apparatuses which required manual maintenance, so reducing worker's dose is a serious issue. To solve this problem, we have decided to adopt removal shielding that could be installed quickly and easily when needed. We carried out shield installation work during the 2020 summer maintenance period. The installation work of the shield has been carried out in a under high-dose environment. For this reason, reducing the dose of workers was an important issue. So, we carefully prepared the work plan and work procedure in advance. During the work period, we implemented various dose reduction measures and managed individual dose carefully. As a result, the dose of all workers could be kept below the predetermined management value. We had installed removal shielding at the beam injection area in the 2020 summer maintenance period. We confirmed that this shield can contribute to the reduction of the dose during work near the beam injection area.

High temperature gas-cooled reactors

Takeda, Tetsuaki*; Inagaki, Yoshiyuki; Aihara, Jun; Aoki, Takeshi; Fujiwara, Yusuke; Fukaya, Yuji; Goto, Minoru; Ho, H. Q.; Iigaki, Kazuhiko; Imai, Yoshiyuki; et al.

High Temperature Gas-Cooled Reactors; JSME Series in Thermal and Nuclear Power Generation, Vol.5, 464 Pages, 2021/02

https://doi.org/10.1016/C2018-0-05383-9

As a general overview of the research and development of a High Temperature Gas-cooled Reactor (HTGR) in JAEA, this book describes the achievements by the High Temperature Engineering Test Reactor (HTTR) on the designs, key component technologies such as fuel, reactor internals, high temperature components, etc., and operational experience such as rise-to-power tests, high temperature operation at 950C, safety demonstration tests, etc. In addition, based on the knowledge of the HTTR, the development of designs and component technologies such as high performance fuel, helium gas turbine and hydrogen production by IS process for commercial HTGRs are described. These results are very useful for the future development of HTGRs. This book is published as one of a series of technical books on fossil fuel and nuclear energy systems by the Power Energy Systems Division of the Japan Society of Mechanical Engineers.

Spallation and fragmentation cross sections for 168 MeV/nucleon Xe ions on proton, deuteron, and carbon targets

Sun, X. H.*; Wang, H.*; Otsu, Hideaki*; Sakurai, Hiroyoshi*; Ahn, D. S.*; Aikawa, Masayuki*; Fukuda, Naoki*; Isobe, Tadaaki*; Kawakami, Shunsuke*; Koyama, Shumpei*; et al.

Physical Review C, 101(6), p.064623_1 - 064623_12, 2020/06

https://doi.org/10.1103/PhysRevC.101.064623

The spallation and fragmentation reactions of Xe induced by proton, deuteron and carbon at 168 MeV/nucleon were studied at RIKEN Radioactive Isotope Beam Factory via the inverse kinematics technique. The cross sections of the lighter products are larger in the carbon-induced reactions due to the higher total kinetic energy of carbon. The energy dependence was investigated by comparing the newly obtained data with previous results obtained at higher reaction energies. The experimental data were compared with the results of SPACS, EPAX, PHITS and DEURACS calculations. These data serve as benchmarks for the model calculations.

Electrical and crystallographic study of an electrothermodynamic cycle for a waste heat recovery

Kim, J.*; Yamanaka, Satoru*; Nakajima, Akira*; Kato, Takanori*; Kim, Y.*; Fukuda, Tatsuo; Yoshii, Kenji; Nishihata, Yasuo; Baba, Masaaki*; Takeda, Masatoshi*; et al.

Advanced Sustainable Systems (Internet), 2(11), p.1800067_1 - 1800067_8, 2018/11

https://doi.org/10.1002/adsu.201800067

Activation in injection area of J-PARC 3-GeV rapid cycling synchrotron and its countermeasures

Yamamoto, Kazami; Yamakawa, Emi*; Takayanagi, Tomohiro; Miki, Nobuharu*; Kamiya, Junichiro; Saha, P. K.; Yoshimoto, Masahiro; Yanagibashi, Toru*; Horino, Koki*; Nakanoya, Takamitsu; et al.

ANS RPSD 2018; 20th Topical Meeting of the Radiation Protection and Shielding Division of ANS (CD-ROM), 9 Pages, 2018/08

The existing beam power of the J-PARC Rapid Cycling Synchrotron is up to 500 kW, and higher radiation doses are concentrated in the injection area. These activations are caused by the interaction between the foil and the beam. To reduce dose exposure to workers near the injection point, we study a new design of the injection scheme. Experience has shown that eddy currents are generated in the metal flange near the magnet owing to the pulsed magnetic field, and the temperature exceeds 100 degrees C. The shield installed in the new injection system needs to have a layer structure, in which an insulator is inserted between iron shields to reduce the eddy current. From the results of the shielding calculation, even if 1 mm of polyethylene was inserted between two 9-mm-thick SUS 316 plates, which serve as shielding material, the shielding performance was reduced only about 5%, and we confirmed that it would function well.

Materials and Life Science Experimental Facility (MLF) at the Japan Proton Accelerator Research Complex, 2; Neutron scattering instruments

Nakajima, Kenji; Kawakita, Yukinobu; Ito, Shinichi*; Abe, Jun*; Aizawa, Kazuya; Aoki, Hiroyuki; Endo, Hitoshi*; Fujita, Masaki*; Funakoshi, Kenichi*; Gong, W.*; et al.

Quantum Beam Science (Internet), 1(3), p.9_1 - 9_59, 2017/12

https://doi.org/10.3390/qubs1030009

The neutron instruments suite, installed at the spallation neutron source of the Materials and Life Science Experimental Facility (MLF) at the Japan Proton Accelerator Research Complex (J-PARC), is reviewed. MLF has 23 neutron beam ports and 21 instruments are in operation for user programs or are under commissioning. A unique and challenging instrumental suite in MLF has been realized via combination of a high-performance neutron source, optimized for neutron scattering, and unique instruments using cutting-edge technologies. All instruments are/will serve in world-leading investigations in a broad range of fields, from fundamental physics to industrial applications. In this review, overviews, characteristic features, and typical applications of the individual instruments are mentioned.

Relationship between the material properties and pyroelectric-generating performance of PZTs

Yamanaka, Satoru*; Kim, J.*; Nakajima, Akira*; Kato, Takanori*; Kim, Y.*; Fukuda, Tatsuo; Yoshii, Kenji; Nishihata, Yasuo; Baba, Masaaki*; Yamada, Noboru*; et al.

Advanced Sustainable Systems (Internet), 1(3-4), p.1600020_1 - 1600020_6, 2017/04

http://doi.org/10.1002/adsu.201600020

no abstracts in English

Novel electrothermodynamic power generation

Kim, Y.*; Kim, J.*; Yamanaka, Satoru*; Nakajima, Akira*; Ogawa, Takashi*; Serizawa, Takeshi*; Tanaka, Hirohisa*; Baba, Masaaki*; Fukuda, Tatsuo; Yoshii, Kenji; et al.

Advanced Energy Materials, 5(13), p.1401942_1 - 1401942_6, 2015/07

https://doi.org/10.1002/aenm.201401942

An innovative electro-thermodynamic cycle based on temporal temperature variations using pyroelectric effect has been presented. Practical energy is successfully generated in both synchrotron X-ray diffraction measurements under controlled conditions and real engine dynamometer experiments. The main generating origin is revealed as a combination of a crystal structure change and dipole change phenomenon corresponds to the temperature variation. In particular, the electric field induced 180 domain switching extremely improves generating power, and the true energy breakeven with temperature variation is firstly achieved.