Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Murakami, Haruyuki; Kizu, Kaname; Ichige, Toshikatsu; Kamiya, Koji; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Hamaguchi, Shinji*; Takahata, Kazuya*; Yanagi, Nagato*; et al.
Proceedings of 24th International Cryogenic Engineering Conference (ICEC 24) and International Cryogenic Materials Conference 2012 (ICMC 2012) (CD-ROM), p.575 - 578, 2012/05
The JT-60U magnet system will be upgraded to the superconducting coils (JT-60SA) in the Broader Approach (BA) project. The JT-60SA magnet system has 18 Toroidal Field (TF) coils, a Central Solenoid (CS) with 4 modules and 6 Equilibrium Field (EF) coils. The CS conductors are designed with Nb
Sn cable in conduit (CIC) conductor because the magnetic field of CS is up to 8.9 T. The short CS conductor was manufactured and processed into the performance verification test sample. The Tcs test results indicate that the initial Tcs of the CS conductor is about 2 K higher than the minimum requirement of the conductor design. In addition the Tcs after the repetition excitation is more important issues for the CS conductor because the CS conductor is made of NbSn strand. The Tcs changes with the repetition excitation and the influence of the warm up and cool down process on the Tcs were measured. The test results show that there is no degradation while the repetition excitation tests. The AC loss test of the CS conductor was also performed for precise estimation of the conductor heat loads. The Tcs margin analysis of the CS conductor was conducted based on the latest conductor heat loads. The analysis results show that the CS conductor has enough Tcs margin during the JT-60SA operation. These results show that the design and the manufacturing process of the CS conductor satisfy its requirements. Thus CS conductors for the CS1 module have been manufactured on the mass production process. In this paper, the Tcs test, the repetition excitation test, the AC loss test and the Tcs margin analysis of the CS conductor are described.
Kizu, Kaname; Kashiwa, Yoshitoshi; Murakami, Haruyuki; Obana, Tetsuhiro*; Takahata, Kazuya*; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Hamaguchi, Shinji*; Matsui, Kunihiro; Nakamura, Kazuya*; et al.
Fusion Engineering and Design, 86(6-8), p.1432 - 1435, 2011/10
Times Cited Count：8 Percentile：53.37(Nuclear Science & Technology)In JT-60SA, central solenoid (CS) and plasma equilibrium field (EF) coils are procured by Japan. EF coil conductors are NbTi cable-in-conduit (CIC) conductor. Delivered superconducting cables and jackets are fabricated into CIC conductors at the jacketing facility with the length of 680 m constructed in the Naka site of JAEA. The production of superconductors with 444 m in length for actual EF coils was started from March 2010. The measurements of superconducting performance like current sharing temperature (Tcs) were conducted prior to the mass production. The measured Tcs was agreed with the expectation values from strand values indicating that no degradation was happened by production process.
Murakami, Haruyuki; Ichige, Toshikatsu; Kizu, Kaname; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Hamaguchi, Shinji*; Takahata, Kazuya*; Yanagi, Nagato*; Mito, Toshiyuki*; et al.
IEEE Transactions on Applied Superconductivity, 21(3), p.1991 - 1994, 2011/06
Times Cited Count：2 Percentile：18.52(Engineering, Electrical & Electronic)no abstracts in English
Kizu, Kaname; Tsuchiya, Katsuhiko; Obana, Tetsuhiro*; Takahata, Kazuya*; Hoshi, Ryo; Hamaguchi, Shinji*; Nunoya, Yoshihiko; Yoshida, Kiyoshi; Matsukawa, Makoto; Yanagi, Nagato*; et al.
Fusion Engineering and Design, 84(2-6), p.1058 - 1062, 2009/06
Times Cited Count：12 Percentile：62.36(Nuclear Science & Technology)The maximum magnetic field and maximum current of EF coils for JT-60SA is 6.2T, 20 kA, respectively. The EF coil conductors are NbTi cable-in-conduit (CIC) conductor with SS316L conduit. In order to confirm the performance of current sharing temperature (
) tests under coil operational condition was performed. As a results, the degradation of was 0.01-0.08 K indicating that the conductor design and its fabrication method is appropriate. Experimental results were compared with the 
and by standard plasma operation scenario. It was confirmed that the conductor has margin of 
1K.
Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Mito, Toshiyuki*; Imagawa, Shinsaku*; Kizu, Kaname; Tsuchiya, Katsuhiko; Hoshi, Ryo; Yoshida, Kiyoshi
Fusion Engineering and Design, 84(7-11), p.1442 - 1445, 2009/06
Times Cited Count：18 Percentile：74.76(Nuclear Science & Technology)The superconductor test facility in National Institute for Fusion Science (NIFS) has been upgraded in order to test cable-in-conduit (CIC) conductors for the JT-60SA equilibrium field (EF) coil. In the test facility, supercritical helium (SHe) lines were newly assembled with transfer tubes and a heat exchanger. The CIC conductor was covered with a thermal insulation vessel filled with gas helium at atmospheric pressure. The temperature of the conductor was varied using a film heater attached to an inlet pipe. The Ic and Tcs measurements of the prototype CIC conductor have successfully been carried out with the upgraded test facility. In the measurements, the conductor temperature was precisely controlled.
Kizu, Kaname; Tsuchiya, Katsuhiko; Hoshi, Ryo; Yoshida, Kiyoshi; Matsukawa, Makoto; Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Imagawa, Shinsaku*; et al.
no journal, ,
The maximum magnetic field and maximum current of EF coils for JT-60SA is 6.2 T, 20 kA, respectively. The EF coil conductors are NbTi cable-in-conduit (CIC) conductor with SS316L conduit. In order to confirm the performance of current sharing temperature (Tcs) tests under coil operational condition was performed. As a results, the degradation of Tcs was 0.02-0.07 K indicating that the conductor design and its fabrication method is appropriate.
Kizu, Kaname; Kashiwa, Yoshitoshi; Murakami, Haruyuki; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Imagawa, Shinsaku*; et al.
no journal, ,
In JT-60SA, magnets system consists of 18 toroidal field (TF) coils, 4 stacks of central solenoid (CS) and 6 plasma equilibrium field (EF) coils. The CS and EF coils are procured by Japan. The maximum magnetic field and maximum current of EF coils is 6.2 T, 20 kA. EF coil conductors are NbTi cable-in-conduit (CIC) conductor. Delivered superconducting cables and jackets are fabricated into CIC conductors at the jacketing facility with the length of 680 m constructed in the Naka site of JAEA. The production of superconductors with 444 m in length for actual EF coils was started from March 2010. The measurements of superconducting performance like current sharing temperature were conducted prior to the mass production. The production and test results of EF conductors will be described.
Murakami, Haruyuki; Ichige, Toshikatsu; Kizu, Kaname; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Imagawa, Shinsaku*; et al.
no journal, ,
no abstracts in English
Murakami, Haruyuki; Kizu, Kaname; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Imagawa, Shinsaku*; Mito, Toshiyuki*; et al.
no journal, ,
no abstracts in English
Murakami, Haruyuki; Kizu, Kaname; Tsuchiya, Katsuhiko; Yoshida, Kiyoshi; Obana, Tetsuhiro*; Takahata, Kazuya*; Hamaguchi, Shinji*; Yanagi, Nagato*; Imagawa, Shinsaku*; Mito, Toshiyuki*
no journal, ,
no abstracts in English
