Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
孫 昊旻; 日引 俊*
International Journal of Heat and Mass Transfer, 237, p.126445_1 - 126445_14, 2025/02
被引用回数:2 パーセンタイル:36.85(Thermodynamics)Various bubbles exist in two-phase flows. A practical approach is classifying the bubbles into two groups based on their drag coefficients. Two-group two-fluid model can potentially provide the most accurate analysis of two-phase flows. Two-group drift-flux model should be established as a constitutive equation to simplify the two-group two-fluid model for its practical use. The drift-flux model for large square channels has seldom been investigated, even though such channels exist in various engineering systems. This study developed the two-group drift-flux model for large square channels based on experimental databases.
孫 昊旻; 功刀 資彰*; 横峯 健彦*; Shen, X.*; 日引 俊*
Experimental Thermal and Fluid Science, 154, p.111171_1 - 111171_24, 2024/05
被引用回数:3 パーセンタイル:64.78(Thermodynamics)Taking the importance of gas-liquid two-phase flows in large square channels for advanced nuclear reactors, such as ESBWR, we experimented with upward cap-bubbly flows in a large square channel. Local void fractions, axial gas velocities, and interfacial area concentrations for two bubble-size groups were measured at three axial locations. Based on the database, cap-bubbly flow characteristics in a large square channel were understood. The existing drift-flux and interfacial area concentration correlations were validated. The void fraction covariances were obtained and used to validate their existing correlations.
孫 昊旻; 功刀 資彰*; 横峯 健彦*; Shen, X.*; 日引 俊*
International Journal of Heat and Mass Transfer, 211, p.124214_1 - 124214_17, 2023/09
被引用回数:4 パーセンタイル:37.98(Thermodynamics)An experiment for upward bubbly flows was conducted in a large square channel. The local void fraction, axial gas velocity, axial liquid velocity, interfacial area concentration, and Sauter mean diameter were measured at three axial locations. Based on the measurement data, the flow characteristics through flow development were investigated. The drift-flux parameters were directly determined from the local measurement data through their definitions. It was found that the distribution parameters and the void fractions could be fairly reproduced by the existing correlations for large circular pipes. Furthermore, the interfacial area concentrations could be predicted by existing correlations with reasonable accuracy.
大貫 晃; 柴田 光彦; 玉井 秀定; 秋本 肇; 山内 豊明*; 溝上 伸也*
日本混相流学会年会講演会2003講演論文集, p.35 - 36, 2003/07
原研で開発を進めている低減速軽水炉の熱流動設計では、サブチャンネル解析コード等による解析的な評価を中核に据えている。そのため、ボイドドリフトモデルをはじめとする物理モデルの稠密格子体系への適用性を検証する必要がある。本研究では19本稠密格子ロッドバンドル体系での気液二相流流量配分実験を行い、サブチャンネル解析コードの適用性を評価/検証する。チャーン流条件で取得した液相及び気相の流量配分実験結果をサブチャンネル解析コードNASCAにより評価した結果、液相流量分布は妥当に予測したが気相流量分布は過小評価した。ボイドドリフトモデルの適用性をさらに検討する必要がある。
大貫 晃; 秋本 肇
Int. J. Multiph. Flow, 22(6), p.1143 - 1154, 1996/00
被引用回数:45 パーセンタイル:84.37(Mechanics)大口径垂直管(内径Dh:0.48m、流路長さLとDhの比:約4.2)内の未整定域を含む空気/水二相流の流れの構造を実験的に調べた。未整定域で極端に異なる流れの構造を実現するため2種類の空気注入方法(多孔焼結金属による注入及びノズル注入)を採った。小口径管(Dh≦約0.05m)でスラグ流の現れる条件であっても、空気注入方法によらず流路を占有するスラグ気泡は見られなかった。テスト部下半分での区間差圧分布及び相分布は空気注入方法に依存した特異な分布を示した。しかしながら、テスト部上半分では空気注入方法の効果は小さかった。テスト部上端での区間ボイド率をKataokaの式と比較したところ、ドリフトフラックスモデルの分布パラメータはDhの効果を含めてモデル化すべきこと、及び気泡径分布が空気注入方法に依存することがわかった。
日引 俊*; 三島 嘉一郎*; 米田 憲司*; 藤根 成勲*; 神田 啓治*; 西原 英晃*; 鶴野 晃; 松林 政仁
Journal of Nuclear Science and Technology, 30(6), p.516 - 523, 1993/06
中性子ラジオグラフィ(NRG)を用いて、小口径円管内空気-水二相流の可視化とボイド率計測を行った。中性子源にはJRR-3を用い、1.510
n/cm
・sの熱中性子束により二相流画像をビデオ撮影した。管内の気泡形状とその挙動は明瞭に観察できた。ボイド率計測に際しては、暗電流、シェーディング、線源強度揺らぎ、散乱中性子、電子機器のドリフトの影響を検討し、その補正を行った。散乱中性子については、水層厚さが薄いことから、その影響を無視することができた。これらの補正後の画像輝度と水層厚さには、直線関係が成立し、その校正曲線からボイド率を計算した。得られたボイド率は、ドリフトフラックスモデルにより良好に相関でき、小口径内管内空気-水二相流にも既存のドリフトフラックスモデルが適用可能であることがわかった。以上の結果、狭間隙流路内でのボイド率計測にNRG法が有効であることが示された。