Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Oe, Toshiaki*; Wakasugi, Keiichiro
Genshiryoku Bakkuendo Kenkyu (CD-ROM), 24(1), p.27 - 32, 2017/06
The report estimates the life-time of the waste glass dissolution in the geologic disposal environment. The overall safety report on the geologic disposal in Japan showed very short life-time of approximately 70,000 years under pessimistic assumptions ignoring the temperature decrease due to radioactive decay and dissolution rate reduction due to surface shrinkage. These factors are physically established phenomena and may not be excluded. The dissolution models including these factors of temperature and surface area decreases are discussed and used for re-evaluation. Three fracture models are presented for evaluating the surface area decreases; a single plate, monotonic spheres, spheres having power-law distribution. All models have the same initial volume as the waste glass block for mass conservation and the total surface areas are 10 times higher than the initial pristine block because of the fracture development during production. The results indicate the retention time of 50% of initial mass exceed 100,000 years even by different fracture models and the dissolution life-times are expected for 260,000
700,000 years depending on models. These results imply more strong isolation capability of the waste glass than that estimated in the overall safety report.
Takahashi, Yuta*; Oe, Toshiaki*; Wakasugi, Keiichiro
Tokai Daigaku Kiyo Kogakubu, 56(2), p.21 - 26, 2016/00
Hirano, Fumio; Sato, Seichi*; Kozaki, Tamotsu*; Inagaki, Yaohiro*; Iwasaki, Tomohiko*; Oe, Toshiaki*; Kato, Kazuyuki*; Kitayama, Kazumi*; Nagasaki, Shinya*; Niibori, Yuichi*
Journal of Nuclear Science and Technology, 49(3), p.310 - 319, 2012/03
Times Cited Count：0 Percentile：0.01(Nuclear Science & Technology)The thermal impacts of hull and end piece wastes from the reprocessing of MOX spent fuels burned in LWRs on repository performance were investigated. The heat generation rates in MOX spent fuels and the resulting heat generation rates in hull and end piece wastes change depending on the fuel histories including the burn-up of UO
spent fuels, the cooling period before reprocessing, the storage period of fresh MOX fuels. The heat generation rates of hull and end piece wastes from the reprocessing of MOX spent fuels with any of those histories are significantly larger than those from UO spent fuels with burn-ups of 45 GWd/THM. If a temperature below 80
C is specified for cement-based materials used in waste packages after disposal, the allowable number of canisters containing compacted hull and end pieces in a package for 45 GWd-MOX needs to be limited to a value of 0.7 to 1.6, which is significantly lower than the value of 4.0 for 45 GWd-UO.
Nakayama, Shinichi; Nagasaki, Shinya*; Inagaki, Yaohiro*; Oe, Toshiaki*; Sasaki, Takayuki*; Sato, Seichi*; Sato, Tsutomu*; Tanaka, Satoru*; Tochiyama, Osamu*; Nagao, Seiya*; et al.
JAEA-Conf 2007-003, 120 Pages, 2007/03
JAEA-Conf-2007-003.pdf:53.18MB
The 1st information exchange meeting on Radioactive Waste Disposal Research Network was held in Nuclear Science Research Institute of Japan Atomic Energy Agency on August 4, 2006. Radioactive Waste Disposal Research Network was established by under Interorganization Atomic Energy Research Program of Japan Atomic Energy Agency, and the objective is to bring both research infrastructures and human expertise in Japan to an adequate performance level, thereby contributing to the development of the fundamental research area in the field of radioactive waste disposal. This lecture material is a collection of research presentations and discussions during the information exchange meeting.
Oe, Toshiaki*; Yamaguchi, Tetsuji
Nihon Genshiryoku Gakkai-Shi, 40(1), p.47 - 49, 1998/01
no abstracts in English
U, 
U, 
U, 
Np, 
Pu, 
Pu, 
Pu, 
Am and 
AmOtsuki, Tsutomu*; Nagame, Yuichiro; Tsukada, Kazuaki*; Shinohara, Nobuo; *; Hashimoto, Kazuyuki; *; Sueki, Keisuke*; ; ; et al.
Physical Review C, 44(4), p.1405 - 1423, 1991/10
Times Cited Count：35 Percentile：86.1(Physics, Nuclear)no abstracts in English
Cl + 
Zn and 
O + 
YNagame, Yuichiro; Ikezoe, Hiroshi; Otsuki, Tsutomu*; Yokoyama, Akihiko*; ; *; ; Sekine, Toshiaki; Ideno, K.
Physics Letters B, 249(1), p.13 - 17, 1990/10
Times Cited Count：3 Percentile：26.7(Astronomy & Astrophysics)no abstracts in English
Yoshiki, Nobuya*; Oe, Toshiaki*; Tsukamoto, Masaki*; Tanaka, Hiroshi*
JNC TJ1400 2005-003, 149 Pages, 1990/03
JNC-TJ1400-2005-003.pdf:4.97MB
None
Cl + ZnNagame, Yuichiro; Ikezoe, Hiroshi; *; ; Sekine, Toshiaki; ; *; Ideno, K.; Yokoyama, Akihiko*; ; et al.
Nuclear Physics A, 510, p.518 - 532, 1990/00
Times Cited Count：10 Percentile：56.68(Physics, Nuclear)no abstracts in English
AgNagame, Yuichiro; Ikezoe, Hiroshi; ; ; Sekine, Toshiaki; ; Ideno, K.; Yokoyama, Akihiko*; *; Otsuki, Tsutomu*
Heavy-Ion Reaction Dynamics in Tandem Energy Region, p.265 - 274, 1988/00
no abstracts in English
Saegusa, Hiromitsu; Onoe, Hironori; Kinoshita, Hirohisa*; Sasao, Eiji; Kosaka, Hiroshi*; Tokusu, Mitsuhiro*; Yoden, Toshiaki*
no journal, ,
no abstracts in English
Sekioka, Yasushi; Takeda, Seiji; Kimura, Hideo; Yamaguchi, Tetsuji; Oe, Toshiaki*; Nagasaki, Shinya*; Sasaki, Takayuki*; Kozaki, Tamotsu*; Inagaki, Yaohiro*
no journal, ,
no abstracts in English
Oe, Toshiaki*; Nagasaki, Shinya*; Kimura, Hideo; Takeda, Seiji; Sekioka, Yasushi; Kato, Hiroyasu*; Akahori, Kuniaki*
no journal, ,
no abstracts in English
Uchida, Masahiro; Amano, Kenji; Hama, Katsuhiro; Takeuchi, Ryuji; Yoshida, Takuma*; Noshita, Kenji*; Futakuchi, Katsuhito*; Oe, Toshiaki*; Nagasaki, Shinya*
no journal, ,
no abstracts in English
Oe, Toshiaki*; Nagasaki, Shinya*; Kimura, Hideo; Takeda, Seiji; Sekioka, Yasushi; Kato, Hiroyasu*
no journal, ,
no abstracts in English
Hama, Katsuhiro; Uchida, Masahiro; Amano, Kenji; Takeuchi, Ryuji; Hagiwara, Hiroki; Yoshida, Takuma*; Noshita, Kenji*; Nagasaki, Shinya*; Oe, Toshiaki*; Futakuchi, Katsuhito*
no journal, ,
The micro-chemical probe for characterization of geological environment has been developed. The performance test shows that this equipment can be applicable for the in-situ experiment.
Oe, Toshiaki*; Suzuki, Masashi*; Tachi, Yukio; Kato, Hiroyasu*
no journal, ,
Physico-chemical properties of pore water in water saturated compacted bentonite was investigated by the osmotic pressure measurement. Osmotic pressure reached the peak value at dry density of 1.2 g/cm
, implying that physico-chemical properties change drastically at this desity.
Takayama, Reona*; Oe, Kazuhiro*; Komori, Yukiko*; Fujisawa, Hiroyuki*; Kuriyama, Ai*; Kikutani, Yuki*; Kikunaga, Hidetoshi*; Kasamatsu, Yoshitaka*; Yoshimura, Takashi*; Takahashi, Naruto*; et al.
no journal, ,
The extraction behavior of trivalent actinides (Am, Cm, Cf, Es, and Fm) into di(2-ethylhexyl)phosphoric acid, HDEHP, in benzene from HNO
was studied together with lanthanides. The extraction constants, 
values, of lanthanides, Am, Cm, Cf, and Es were determined by a batch method using stable lanthanide isotopes and radiotracers of Am, Cm, 
Cf, and 
Es, respectively, while that of Fm was measured with 
Fm which was produced in the 
U(O,4n) reaction and was on-line supplied by a gas-jet method at the AVF cyclotron of RCNP, Osaka University. The values were determined by the slope analysis for the variation of the distribution ratio as a function of the concentration of HDEHP. We found that the of Fm is smaller than that of Dy in spite of the similar ionic radii while those of other actinides are almost the same as those of each lanthanide with a similar ionic radius.
Mitsui, Seiichiro; Oe, Toshiaki*; Inagaki, Yaohiro*; Okubo, Takahiro*; Kurosawa, Susumu*; Goto, Takahiro*; Inagaki, Manabu*; Ishiguro, Katsuhiko*; Takase, Hiroyasu*; Takahashi, Hirokazu*
no journal, ,
In order to develop robust performance assessment models, we have been preparing an information basis regarding glass properties and glass dissolution/alteration processes under disposal conditions as a part of NUMO-JAEA joint project. Our iterative working process for the preparation of the information basis comprises five steps: (1) integration of current knowledge; (2) development of glass dissolution scenarios based on current knowledge; (3) development of conceptual model; (4) sensitivity analyses to evaluate relative importance of relevant processes and associated uncertainties; and (5) identification of future R&D issues towards further improvement of the information basis. The current status will be presented in this talk.
Qiao, Y.*; Arai, Taiki*; Suzuki, Toshiaki*; Yoshigoe, Akitaka; Niwa, Masaaki*; Motohashi, Mitsuya*
no journal, ,
Roll-like structures with a thickness of about 1 
m fabricated by anodization of the surface of single-crystalline Si wafers have the potential to be applied to a variety of devices. With the aim of controlling the thickness and length of the rolls, the influence of the surface condition of the Si substrate before anodization was investigated. It was found that Pt coating before anodization was effective in controlling the thickness of rolls. Furthermore, it was found that this result was not affected by the doping types.
