JOPSS - Search Results

Journal Articles

Proposal of laser-induced ultrasonic guided wave for corrosion detection of reinforced concrete structures in Fukushima Daiichi Nuclear Power Plant decommissioning site

Furusawa, Akinori; Takenaka, Yusuke; Nishimura, Akihiko

Applied Sciences (Internet), 9(17), p.3544_1 - 3544_12, 2019/09

Times Cited Count：7 Percentile：59.3(Chemistry, Multidisciplinary)

Remote-controlled, non-destructive testing is necessary to detect corrosion of the reinforced concrete structures at the Fukushima Daiichi Nuclear Power Plant (NPP) de-commissioning site. This work aims to demonstrate that laser-induced ultrasonic guided wave technology can be applied to achieve this task. Hence, accelerated electrolytic corrosion is performed on a reinforced concrete specimen fabricated by embedding a steel rod into mortar. Waveforms of the laser-induced ultrasonic guided wave on the rod are measured with a previously employed piezoelectric transducer (PZT) probe, for each fixed corrosion time. Based on the results of Fourier and wavelet transforms of the waveforms, issues concerning the detection and extent of rebar corrosion are discussed. It is exhibited that the changes in bonding strength due to corrosion are distinguishable in the frequency domain of the ultrasonic signal.

Journal Articles

Feasibility study of advanced measurement technology for solution monitoring at reprocessing plant; Dose rate measurement for the solution including Pu with FP

Matsuki, Takuya; Yamanaka, Atsushi; Sekine, Megumi; Suzuki, Satoshi*; Yasuda, Takeshi; Tsutagi, Koichi; Tomikawa, Hirofumi; Nakamura, Hironobu; LaFleur, A. M.*; Browne, M. C.*

Proceedings of INMM 58th Annual Meeting (Internet), 8 Pages, 2017/07

The Tokai Reprocessing Plant (TRP) has been developing a new detector from 2015 to 2017 for purpose to monitor Pu amount in High Active Liquid Waste (HALW) containing FP. It can make a contribution to an advanced approach to effectively and efficiently conduct safeguards for reprocessing facilities because it becomes available to monitor and verify nuclear material movement continuously by a new detector, which has proposed by IAEA. For the second step of this project, we conducted dose rate measurement on the guide rail installing in the cell storing the HALW tank and comparison between measured dose rate distribution and calculation result by MCNP simulation in order to investigate the dose rate distribution which is needed for shielding design of a new detector that is used for radiation (neutron/ spectrum) measurement in the cell and inquest on the monitoring position of the detector for Pu monitoring. In this paper, we report the result of the dose rate measurement in the cell, improvement of the simulation model which is cleared by comparison between measurement result and calculation result and our future plan.

Journal Articles

On-line subcriticality measurement using a pulsed spallation neutron source

Iwamoto, Hiroki; Nishihara, Kenji; Yagi, Takahiro*; Pyeon, C.-H.*

Journal of Nuclear Science and Technology, 54(4), p.432 - 443, 2017/04

https://doi.org/10.1080/00223131.2016.1274687

Times Cited Count：16 Percentile：87.52(Nuclear Science & Technology)

JAEA Reports

Radiation monitoring data of the HTTR rise-to-power test; Results up to 30MW operation on the high-temperature test operation mode

Ashikagaya, Yoshinobu; Kawasaki, Tomokatsu; Yoshino, Toshiaki; Ishida, Keiichi

JAERI-Tech 2005-010, 81 Pages, 2005/03

JAERI-Tech-2005-010.pdf:16.65MB

no abstracts in English

JAEA Reports

Standard of radiation monitor based on LAN and PLC technology for J-PARC

Miyamoto, Yukihiro; Sakamaki, Tsuyoshi*; Maekawa, Osamu*; Nakashima, Hiroshi

JAERI-Tech 2004-054, 72 Pages, 2004/08

JAERI-Tech-2004-054.pdf:7.3MB

A standard is provided for the radiation monitor based on LAN (Local Area Network) and PLC (Programmable Logic Controller) technology at the introduction to the Japan Proton Accelerator Research Complex (J-PARC). The monitor consists of radiation measurement equipments and the central monitoring panel. The formers are installed in the radiation field, and the latter is installed in the control room and composed of PLC, which are connected with LAN. Extension of the existing standard and the conformity to the international standard were thought as important in providing the standard. The standard is expected to improve the compatibility, maintenancability and productivity of the components.

Journal Articles

Radiation control system for J-PARC

Miyamoto, Yukihiro

Hokeikyo Nyusu, (32), p.2 - 3, 2003/10

http://www.irm.or.jp/news32.pdf

no abstracts in English

JAEA Reports

Radiation monitoring data of the HTTR rise-to-power test; Results up to 30 MW operation on the rated operation mode

Ashikagaya, Yoshinobu; Yoshino, Toshiaki; Yasu, Katsuji; Kurosawa, Yoshiaki; Sawa, Kazuhiro

JAERI-Tech 2002-094, 80 Pages, 2002/12

JAERI-Tech-2002-094.pdf:12.8MB

no abstracts in English

JAEA Reports

Design concept of radiation control system for the high intensity proton accelerator facility

Miyamoto, Yukihiro; Ikeno, Koichi; Akiyama, Shigenori*; Harada, Yasunori

JAERI-Tech 2002-086, 43 Pages, 2002/11

JAERI-Tech-2002-086.pdf:5.7MB

Description is given for the characteristic radiation environment for the High Intensity Proton Accelerator Facility and the design concept of the radiation control system of it. The facility is a large scale accelerator complex consisting of high energy proton accelerators carrying the highest beam intensity in the world and the related experimental facilities and therefore provides various issues relevant to the radiation environment. The present report describes the specifications for the radiation control system for the facility, determined in consideration of these characteristics.

Journal Articles